氟虫双酰胺在水稻和稻田中的残留动态研究

采用超高效液相色谱法(UPLC)测定了氟虫双酰胺19.8%悬浮剂(SC)在水稻及稻田环境中的残留动态.结果表明,当氟虫双酰胺及其代谢产物NNI-des-iodo的添加量为0.05～1.0 mg·kg-1时,其在水稻田土壤、田水、稻秆、稻米和稻壳中的平均回收率为78.2%～104.8%,变异系数为1.1%～4.4%.氟虫双酰胺在2011年三地(福建福州、天津、江苏南京)的稻田水中的降解半衰期为9.8～17.3 d,土壤中10.8～22.4 d,植株中7.6～17.3 d,其在稻田水样品中检出了代谢产物NNI-des-iodo,而在土壤和植株样品中未检出.在推荐使用剂量下,于末次施药10 d后,氟虫双酰胺在水稻稻米中的残留量均低于美国规定的在稻谷上的最大残留允许量(0.5 mg·kg-1).     

Pollutant emission characteristics of rice husk combustion in a vortexing fluidized bed incinerator

Rice husk with high volatile content was burned in a pilot scale vortexing fluidized bed incinerator. The fluidized bed incinerator was constructed of 6 mm stainless steel with 0.45 m in diameter and 5 m in height. The emission characteristics of CO, NO, and SO2 were studied. The effects of operating parameters, such as primary air flow rate, secondary air flow rate, and excess air ratio on the pollutant emissions were also investigated. The results show that a large proportion of combustion occurs at the bed surface and the freeboard zone. The SO2 concentration in the flue gas decreases with increasing excess air ratio, while the NOx concentration shows reverse trend. The flow rate of secondary air has a significant impact on the CO emission. For a fixed primary air flowrate, CO emission decreases with the secondary air flowrate. For a fixed excess air ratio, CO emission decreases with the ratio of secondary to primary air flow. The minimum CO emission of 72 ppm is attained at the operating condition of 40% excess air ratio and 0.6 partition air ratio. The NOx and SO2 concentrations in the flue gas at this condition are 159 and 36 ppm, which conform to the EPA regulation of Taiwan.     

A pilot-scale study of cryolite precipitation from high fluoride-containing wastewater in a reaction-separation integrated reactor

Fluoride removal by traditional precipitation generates huge amounts of a water-rich sludge with low quality, which has no commercial or industrial value. The present study evaluated the feasibility of recovering fluoride as low water content cryolite from industrial fluoride-containing wastewater. A novel pilot-scale reaction-separation integrated reactor was designed. The results showed that the seed retention time in the reactor was prolonged to strengthen the induced crystallization process. The particle size of cryolite increased with increasing seed retention time, which decreased the water content. The recovery rate of cryolite was above 75% under an influent fluoride concentration of 3500 mg/L, a reaction temperature of 50℃, and an influent flow of 40 L/hr. The cryolite products that precipitated from the reactor were small in volume, large in particle size, low in water content, high in crystal purity, and recyclable.     

三槽氧化沟内底推位置与积泥厚度的分析研究

氧化沟工艺由于进水中含有大量的无机颗粒,无机颗粒的沉淀导致沟内积泥较厚。为了不影响正常生产,依据经验数据,依次对1号、2号氧化沟安装底推。对沟内积泥情况及影响因素进行分析比较,得出氧化沟的积泥主要由进水中密度较大的无机颗粒造成,且积泥规律与底推安装位置和运行情况相关。     

日本交通部门碳排放与低碳交通相关因素研究

本文就日本向低碳社会体系转型的过程中,交通部门碳排放现状、都市交通体系构成、实施对策等方面进行了分析,探讨其交通运输领域低碳交通的相关因素及发展模式,为中国低碳交通体系的构建提供参考。     

GJB150A在某通信装备低温试验中的应用研究

由于是剪裁标准,GJB 150A发布以来的很长一段时间内,许多使用人员还无法适应,对试验工作造成诸多困扰。为了指导研究人员摆脱菜单式标准的束缚,以GJB 150A为参考标准,根据某通信装备的寿命期剖面和寿命期环境剖面,论述了该装备低温试验的实施要点,对试验程序、试验顺序和试验条件的选择依据及结果给出了详细分析,提出了试验实施的设备与试件要求。     

军用物资集装箱内部低温环境条件研究

以天津和齐齐哈尔两个低温地区军用物资集装箱运输为背景,分别对两个地区的集装箱内部温度变化及大气温度等数据进行测试并对比分析。对齐齐哈尔地区的数据进行回归分析,建立了集装箱内部温度模型,预测出集装箱内部最恶劣的低温极值范围,为危险军用物资集装箱安全储运提供理论依据,并提出了相应的对策及建议。     

全新世哈尼泥炭地碳积累速率及影响因素

本工作研究了全新世中国东北地区哈尼泥炭地的碳积累速率与气候变化的响应机制。综合多指标腐殖化度、有机碳含量、干容重和纤维素碳氧同位素重建了哈尼地区全新世气候变化历史,并且基于定年、有机碳含量和干容重得到碳积累速率数据。哈尼泥炭时间加权平均碳积累速率28.3gC/(m2·a)。B/A暖期后期温暖湿润气候有利于碳积累,出现碳积累高峰。相对寒冷的新仙女木期碳积累速率有所降低。温暖湿润早中全新世虽有高泥炭分解,但高初级生产力还是占据主导作用,出现高碳积累速率。期间有两次火山碎屑层扰动了泥炭发育,导致碳积累速率下降。高碳积累速率一直持续到4ka BP左右大暖期结束。4.0~1.6ka BP太平洋季风减弱,泥炭表面偏干,加之降温导致低初级生产力,最终导致此阶段碳积累速率显著降低。之后季风不断增强,碳积累速率也随之增加。八次IRD降温,小冰期和新仙女木降温在哈尼都是冷湿气候组合。冷湿气候虽使有机物分解降低,但更大程度的抑制了初级生产力发展,导致低碳积累速率。     

浙中某县Cd元素地球化学特征及生态效应

本文基于对浙中某县土壤-作物系统的调查研究,系统总结了Cd元素地球化学特征。研究发现,土壤中Cd含量呈现表层富集趋势;土壤Cd元素的赋存形态以离子交换态为主,占各形态总量比例高达39.68%,显示出该地区土壤中Cd的活性相对较强;Cd污染区在南部山区沿水系分布,在研究区北部零星分布。研究同时发现,污染主要是由于矿山开采、工业废物排放以及污水灌溉等人类活动引起,并且污染区已出现稻米样品Cd超标,应引起有关部门足够重视。     

低C/N条件下MUCT工艺数学模型的参数校正与验证

基于ASM2d模型建立了稳定运行的MUCT工艺营养物质去除过程的动力学反应模型,比较各种COD、TN、NH 4＋-N、TP的实测值和模拟值,以确定系统在低C/N条件下运行时的动力学和化学计量学参数.模拟结果表明,稳态模型中的动力学参数qPHA、KA、KPP、YPO3-4、μAUT和ηNO-3分别取值2.90 g.（g.d）-1、3.85 g.m-3、1.35 g.（g.d）-1、0.35、1.6和0.8.其他的动力学和化学计量学参数可采用IWA给出的默认值.