Competitive sorption between 17α-ethinyl estradiol and bisphenol A/4-n-nonylphenol by soils

The sorption of 17α-ethinyl estradiol(EE2),bisphenol A(BPA),and 4-n-nonylphenol(NP) in single systems and the sorption of EE2 with different initial aqueous concentrations of BPA or NP were examined using three soils.Results showed that all sorption isotherms were nonlinear and fit the Freundlich model.The degree of nonlinearity was in the order BPA(0.537-0.686) > EE2(0.705-0.858) > NP(0.875-0.0.951) in single systems.The isotherm linearity index of EE2 sorption calculated by the Freundlich model for Loam,Silt Loam and Silt increased from 0.758,0.705 and 0.858,to 0.889,0.910 and 0.969,respectively,when BPA concentration increased from 0 to 1000 μg/L,but the effect of NP was comparably minimal.Additionally,EE2 significantly suppressed the sorption of BPA,but insignificantly suppressed that of NP.These findings can be attributed to the difference of sorption affinity of EE2,NP and BPA on the hard carbon(e.g.,black carbon) of soil organic matter that dominated the sorption in the low equilibrium aqueous concentration range of endocrine-disrupting chemicals(EDCs).Competitive sorption among EDCs presents new challenges for predicting the transport and fate of EDCs under the influence of co-solutes.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.     

日本交通部门碳排放与低碳交通相关因素研究

本文就日本向低碳社会体系转型的过程中,交通部门碳排放现状、都市交通体系构成、实施对策等方面进行了分析,探讨其交通运输领域低碳交通的相关因素及发展模式,为中国低碳交通体系的构建提供参考。     

活化温度对SCAC制备过程中副产物生成规律的影响

文章研究了污泥-玉米芯活性炭(SCAC)制备过程中,活化温度对副产物(热解气和热解油)生成规律的影响。热解气和热解油分别采用气相色谱仪和气质联用仪进行分析检测。试验结果表明,随着活化温度的升高,SCAC的产量逐渐降低,热解气与热解油的产量则随之增多。不同温度条件下,热解气的主要成分均为H2和CO2,热解气中H2所占的体积百分数随着活化温度的升高而增加,而CO2则相应降低。此外,热解气中CH4的含量也会随着活化温度的上升而略有提高,说明较高的活化温度更有利于热解气的资源利用。热解油组分较为复杂,每个温度条件下的液态产物都包括上百种化合物,可分为烷烃,烯烃,苯类,酚类,腈类,杂环化合物,多环芳烃,有机酸,酰胺,酯类,甾体,醇,酮以及其他类共14大类型,其中以有机酸、腈类和甾体类有机物含量居多。随着活化温度的升高,有机酸和多环芳烃的含量有所增加,而酚类化合物的含量则有所降低;当活化温度升高至650℃以上时,甾体类有机物含量明显降低。     

我国水泥工业碳排放特征及动态变化分析

水泥工业是温室气体二氧化碳(CO2)的主要排放源,利用碳排放数学模型计算2001-2010年我国水泥工业碳的排放量,分析碳排放量的变化特点和发展趋势。结果表明:水泥工业碳排放总量逐年增长,与水泥产量和排放强度呈线性关系。"十一五"期间单位产品碳排放强度由0.69 t/t下降到0.65 t/t。万元GDP碳排放量2008年达到最低值为0.295 1 t,平均每年万元GDP碳排放量下降2.85%。水泥工业十年间实施节能降耗、资源循环利用、提高经济效益等措施,对于减少碳排放具有明显效果。     

呼和浩特地区污水厂能耗评价与碳排放分析

污水处理过程的能耗和温室气体排放方面的研究对于应对能源危机和气候危机具有重要作用。文章利用层次分析法,建立了具有4层15项指标的能耗评价体系。结合城镇污水处理系统的绿色指标体系,选取呼和浩特地区具有代表性、处理规模相近的2座中小型污水厂进行能耗评价。结果表明:处理能力利用率、处理工艺系统稳定性和污水厂高程布置所对应的3项评价指标在所选择的能耗影响因素中所占权重较大,分别为:0.143 0,0.302 4和0.145 6。进一步运用IPCC计算方法对污水处理厂进行碳排放概算,得出A、B污水处理厂的碳排放量分别为:19.401 t CO2/104t、18.378 t CO2/104t。A、B污水处理厂的实际比能耗分别为0.293 kW.h/m3、0.195 kW.h/m3。将碳排放数据与实际能耗情况对比得出:污水处理厂的能耗水平越高,单位碳排放量也越大。     

2,2′-二硝基联苄生产废水的处理研究

对十六烷基三甲基溴化铵改性凹凸棒土、凹凸棒土负载TiO2采用XRD、FTIR以及TG等手段进行了分析和表征,对比了改性凹凸棒土、活性炭、大孔树脂等不同吸附剂和凹凸棒土负载TiO2对二硝基联苄生产废水的处理效果。结果表明:十六烷基三甲基溴化铵改性凹凸棒土的废水中污染物的去除率比凹凸棒土提高了2.5倍;凹凸棒土负载TiO2在波长λ=254 nm下光照0.5 h,对废水中污染物的去除率是凹凸棒土的2.0倍;投加量为3%活性炭在pH为2.0⁵.0时,对该类废水中污染物的去除率可达80%以上。     

钢渣湿法捕获CO_2反应机制研究

以炼钢过程中排放的固体废弃物钢渣为碳捕获剂,进行了钢渣湿法捕获烟气CO2工艺的实验研究。通过分析钢渣的组成成份及反应机理,研究液固比、反应温度、反应时间、pH值及反应产物等主要参数对钢渣湿法碳捕获状况的影响。实验证明,通过合理的设计和适当的操作,可使钢渣湿法碳捕获效率达60%以上,具有一定的应用价值。     

Application of CGP-cross route process for microstructure refinement and mechanical properties improvement in steel sheets

A modified method of severe plastic deformation (SPD) entitled constrained groove pressing-cross route (CGP-CR) was introduced for imposing a high magnitude of equivalent strain of about 2.32 per pass on the sheet form samples. The major benefit of this improved route compared to previous common route was the more homogeneity of strain in the rolling (RD) and transverse (TD) directions of sheets. In this study, low carbon steel samples were used for examination of evolutions in microstructure and mechanical properties during SPD via CGP-CR process. Mechanical properties improvement were measured by tensile and macro hardness tests. The results indicate that CGP-CR process can effectively improve tensile strength; and also, yield stress and hardness of as-received low carbon steel samples were improved up to about 100% after two deformation passes. Also, high magnitude of inhomogeneity can be observed in hardness distribution through first pass of the process which diminishes in the subsequent passes. Microstructural evolutions during process were monitored by optical microscopy observations and X-ray diffraction analysis. The results demonstrate that initial ferritic microstructure with grain size of about 30 μm was refined to a 225 nm cell structure after two passes of CGP-CR process.     

GJB150A在某通信装备低温试验中的应用研究

由于是剪裁标准,GJB 150A发布以来的很长一段时间内,许多使用人员还无法适应,对试验工作造成诸多困扰。为了指导研究人员摆脱菜单式标准的束缚,以GJB 150A为参考标准,根据某通信装备的寿命期剖面和寿命期环境剖面,论述了该装备低温试验的实施要点,对试验程序、试验顺序和试验条件的选择依据及结果给出了详细分析,提出了试验实施的设备与试件要求。