纵向风对隧道火灾拱顶最高温度及其位置的影响

研究了燃烧风洞内不同纵向风速、不同火源功率条件下,隧道近火源区顶部温度沿纵向分布情况。结果表明,纵向风对不同尺寸火源条件下的顶部温度的影响呈不同特征。对较小尺寸火源,隧道顶部温升随风速增加而减小至稳定值;而对较大尺寸火源,顶部温升随风速增加先增加后减小。对于矩形火源,当纵向风较小(0.5~1.5m/s)时,长边平行于纵向风时顶部最高温升大于长边垂直于纵向风的情况;而当纵向风较大(≥2 m/s)时,两种油盘放置方式的顶部最高温升一致。纵向风作用下,顶部最高温升位置向下游呈现"两次移动"特征,即随着纵向风速增加该位置先向下游移动,当风速达到某一值时,隧道拱顶的加热机制由对流和辐射共同主控转变为辐射单独主控,最高温升位置突变回到上游后再次逐渐向下游移动。     

瞬态径向热流法测定松散煤体变导热系数

松散煤体的导热系数是指在单位梯度作用下,松散煤体单位时间内通过单位面积的热量,表征了松散煤体导热性能的强弱,是研究煤自燃的重要参数。目前,使用最广泛的热线法,测试结果易受电阻升温变化影响。针对当前测试方法的不足,本文在二维径向导热模型的基础上,设计了瞬态径向热流法测定松散煤体变导热系数测试装置,并建立了相应的导热系数解算模型。通过测定不同煤样随温度变化的变导热系数。结果表明,随着温度的升高,松散煤体的导热系数不断上升,两者之间基本成线性关系,测试结果符合松散煤体的导热特性。     

火灾环境中油罐罐壁冷却优化部署研究

对油罐火灾中着火罐罐壁和邻近罐罐壁的温度分布进行了科学分析,并进行了罐壁冷却实验研究,研究不同油罐罐壁材质对冷却效果的的影响,以及有热源作用和无热源作用罐壁在不同流量冷却水作用下的温度变化规律。结果表明,不同罐壁材质对冷却效果的影响不大,在实际火灾中可忽略罐壁材质的影响;流量越大,冷却速度越快,但达到火灾冷却要求时,不同大小流量冷却水的冷却效果差异并是很大,合适的供水强度是油罐高效冷却的前提。对油罐火灾冷却力量的部署提出了优化原则,为防灭火工作提供了一定的科学依据。     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

Alternative method to prevent thermal runaway in case of error on operating conditions continuous reactor

Thermal runaway was studied in a continuous tubular pilot reactor under steady-state regime. Different accident scenarii were conducted by making some errors on reactant concentrations and/or temperature feed. To prevent thermal runaway, control by direct contact by solvent injection was used at different reactor locations. This injection allowed controlling the maximum reaction temperature. A simplified analytical method to estimate the maximum reaction temperature along the reactor was used.Benefit of this control method was the diminution of computational time. Furthermore, by injecting solvent to control maximum reaction temperature, there is no need to shut down the unit. The control method was validated experimentally.     

Sources of underground CO: Crushing and ambient temperature oxidation of coal

As a harmful gas in underground coal mine, CO seriously threatened the safety of miners. Currently, the spontaneous combustion of residual coal in goaf is generally considered as the main source of underground CO. CO gas is also widely used as an indicator gas in fire prediction in mines. However, high concentrations of CO are also detected in some mines without spontaneous combustion of coal. Therefore, in the paper, with four ranks of coal, we studied other two potential CO sources: crushing and oxidation at ambient temperature. The more completely crushed coal produces more CO. The concentration of generated CO is inversely proportional to moisture content in coal. Therefore, the addition of water can inhibit the generation process of CO during the crushing process of coal. Lignite with low metamorphic grade can be oxidized to produce CO at ambient temperature (25 °C), and anthracite with high coal rank can be only oxidized to produce CO at 60 °C. Infrared spectra indicated that the coal with rich aliphatic hydrocarbons and oxygen-containing functional groups are more susceptible to oxidation at room temperature. Moreover, the smaller particle size of coal is more beneficial to the oxidation at ambient temperature to generate CO. CO generation during coal oxidation is also closely related to the ventilation rate.     

考虑爆裂影响的钢筋混凝土梁火灾温度场数值分析

为了描述混凝土高温爆裂对构件热传导过程的影响,结合钢筋混凝土梁火灾试验,考虑爆裂时间和区域的不确定性,建立了火灾下钢筋混凝土梁数值分析模型,分析爆裂深度、爆裂面积比、爆裂位置等爆裂参数对梁跨中截面温度场的影响规律。研究结果表明:当钢筋混凝土梁发生受火爆裂,梁截面的温度显著升高,并随爆裂深度的增大而进一步增强;爆裂面积比对截面温度场影响不显著,当爆裂深度、爆裂位置一定,爆裂面积比增加达到13%左右时,截面温度场基本上不再变化;爆裂深度、爆裂面积比一定,梁跨中爆裂对截面温度场影响最大,但是底部纵筋处温度较顶部纵筋处温度升高较快。     

基于热湿交换理论的巷道风流温、湿度影响因素研究

为了研究巷道风流参数的影响因素、预测风流温湿度的变化规律,结合热湿交换理论,建立了风流与围岩壁面之间热湿交换的数学模型,以及贴体坐标系下围岩内部温度场的导热微分方程;利用数值方法,将围岩内部的导热问题与影响风流参数变化的热湿交换问题耦合起来,并以大柳塔煤矿52505综采工作面为例进行计算,得到了与实测参数较为一致的模拟结果,验证了该数值方法的有效性。研究结果表明:风流温度受原始岩温、入风流温度、局部热源强度等因素的影响,风流相对湿度与入风流温、湿度以及井下湿源的数量和强度有关;巷道壁温作为将围岩温度场与风流参数之间关联起来的主要因素,对模拟结果影响较大,其数值取决于壁面与风流之间热湿交换以及围岩原始岩温。     

配置SCR的柴油货车道路运行NOx排放分析

为了研究重型柴油货车在不同道路运行工况下的NO_x排放特性,以一辆配置选择催化还原(Selective CatalyticReduction,SCR)净化系统的国V排放标准的重型柴油货车为研究对象,开展实际道路运行车载排放测试,通过车载排放测试系统实时采集车辆行驶速度、NO_x排放体积分数与排气温度等数据,分析车速、排气温度、路况等对NO_x排放的影响。结果表明,车速低于40 km/h,NO_x排放随车速增大稍有增加; 40～70 km/h,随车速增大NO_x排放降低;高于70 km/h,随车速增大NO_x排放显著降低。车速与排气温度呈线性正相关,排气温度高于150℃,SCR才能显示出对NO_x的净化效果。市区工况车速低,排温低于150℃,SCR不能有效工作;市郊、高速工况下排温高于150℃,SCR催化效率提高,车速增大,排温升高,NO_x排放降低,因此NO_x排放市郊工况低于市区工况,高速工况低于市郊工况。配置SCR的重型柴油货车NO_x高排放区主要集中在中低车速、加速区间内。     

驾驶机舱LED灯光色温与人员警觉度关系仿真实验研究

为了探讨驾驶机舱内LED灯光色温与人员警觉度的联系,在A320模拟驾驶舱内设置2 500～2 700 K,3 000～3 200 K,6 000～6 500 K 3种不同色温的LED灯光环境,采用卡斯罗林嗜睡量表（KSS）、闪光融合临界频率仪（CFF）、视觉舒适度评分量表（VCS）,对5名被试人员在不同灯光环境的疲劳程度和视觉舒适度进行实时测量。针对测量结果,采用方差分析及描述性统计的数据分析方法,评价被试人员于不同灯光环境下的疲劳程度、视觉舒适度的差异性及变化情况。研究结果表明:高色温LED灯光环境下,人员的主观嗜睡感受及客观疲劳感受较低,且有着较低的疲劳感受增长率;高色温LED光源下人员的视觉舒适度也较高;增高LED灯光色温可一定程度上提升人员的警觉性。