Analysis of uncertainty consideration in environmental assessment: an empirical study of Canadian EA practice

Identifying and communicating uncertainty is core to effective environmental assessment (EA). This study evaluates the extent to which uncertainties are considered and addressed in Canadian EA practice. We reviewed the environmental protection plans, follow-up programs, and panel reports (where applicable) of 12 EAs between 1995 and 2012. The types of uncertainties and levels of disclosure varied greatly. When uncertainties were acknowledged, practitioners adopted five different approaches to address them. However, uncertainties were never discussed or addressed in depth. We found a lack of suitable terminology and consistency in how uncertainties are disclosed, reflecting the need for explicit guidance, and we present recommendations for improvement. Canadian Environmental Impact Statements are not as transparent with respect to uncertainties as they should be, and uncertainties in EA need to be better considered and communicated.     

石化装置安全仪表系统KooN表决结构的误跳车率定量分析

为了更准确量化安全仪表系统的误跳车率,基于联锁回路SIF中传感器、逻辑解算器、执行机构引发误跳车的不同失效机理和模型,考虑共因失效对误跳车率的影响,提出1种更符合实际并适用于异型KooN结构的新子系统误跳车率计算模型（STR of Non-identical Redundant System,SNRS）。针对SIF回路的误跳车率计算,建立了1种分析安全联锁SIF回路误跳车率（Reliability based Spurious Trip,RST）的计算框架。研究结果表明:以某聚丙烯装置第三反应器保护系统为例,将SNRS和RST方法与目前主流的多种计算方法进行数值计算对比,验证了方法的有效性,能够有效进行定量分析。     

基于尾涡强度的无人机与民机纵向安全间隔评估研究

为了解决无人机频频入侵机场净空,与民航客机发生危险接近的问题,以碰撞风险为量化指标,对无人机与民机需要保持的纵向安全间隔进行评估研究。分析民机尾涡流场对无人机运行的影响,利用Crow近场涡强度消散理论,得到实际尾迹影响区改进Reich碰撞模板,据此建立CNS/GPS性能环境下的纵向间隔评估模型,通过Matlab进行间隔值求解。研究结果表明:模型可以较为准确地反映民机起飞初始爬升阶段无人机尾随运行时导航性能和尾涡迹对所需最小间隔值的影响,并得到给定安全目标水平的计算结果。     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3,并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD,SEM,FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构,其中,LaFe0.9Mn0.1O3的结构稳定,比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高,且稳定性好,连续使用5次后催化活性未见明显减弱;在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下,COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%,BOD5/COD由0.02提升至0.40,可生化性大幅提高。     

Supporting Diverse Data Providers in the Open Water Data Initiative: Communicating Water Data Quality and Fitness of Use

Shared, trusted, timely data are essential elements for the cooperation needed to optimize economic, ecologic, and public safety concerns related to water. The Open Water Data Initiative (OWDI) will provide a fully scalable platform that can support a wide variety of data from many diverse providers. Many of these will be larger, well‐established, and trusted agencies with a history of providing well‐documented, standardized, and archive‐ready products. However, some potential partners may be smaller, distributed, and relatively unknown or untested as data providers. The data these partners will provide are valuable and can be used to fill in many data gaps, but can also be variable in quality or supplied in nonstandardized formats. They may also reflect the smaller partners' variable budgets and missions, be intermittent, or of unknown provenance. A challenge for the OWDI will be to convey the quality and the contextual “fitness” of data from providers other than the most trusted brands. This article reviews past and current methods for documenting data quality. Three case studies are provided that describe processes and pathways for effective data‐sharing and publication initiatives. They also illustrate how partners may work together to find a metadata reporting threshold that encourages participation while maintaining high data integrity. And lastly, potential governance is proposed that may assist smaller partners with short‐ and long‐term participation in the OWDI.     

Recent Changes in Stream Flashiness and Flooding,and Effects of Flood Management in North Carolina and Virginia

The southeastern United States has undergone anthropogenic changes in landscape structure, with the potential to increase (e.g., urbanization) and decrease (e.g., reservoir construction) stream flashiness and flooding. Assessment of the outcome of such change can provide insight into the efficacy of current strategies and policies to manage water resources. We (1) examined trends in precipitation, floods, and stream flashiness and (2) assessed the relative influence of land cover and flow‐regulating features (e.g., best management practices and artificial water bodies) on stream flashiness from 1991 to 2013. We found mean annual precipitation decreased, which coincided with decreasing trends in floods. In contrast, stream flashiness, overall, showed an increasing trend during the period of study. However, upon closer examination, 20 watersheds showed stable stream flashiness, whereas 5 increased and 6 decreased in flashiness. Urban watersheds were among those that increased or decreased in flashiness. Watersheds that increased in stream flashiness gained more urban cover, lost more forested cover and had fewer best management practices installed than urban watersheds that decreased in stream flashiness. We found best management practices are more effective than artificial water bodies in regulating flashy floods. Flashiness index is a valuable and straightforward metric to characterize changes in streamflow and help to assess the efficacy of management interventions.     

The determination and matching analysis of pinch point temperature difference in evaporator and condenser of organic rankine cycle for mixed working fluid

Exergo-economic analysis of the pinch point temperature difference (PPTD) in both evaporator and condenser of sub-critical organic Rankine cycle system (ORCs) are performed based on the first and second laws of thermodynamics. Taking mixture R13I1/R601a as a working fluid and the annual total cost per net output power Z as exergo-economic performance evaluation criterion, the effects of PPTD in evaporator ΔT_e, and the PPTD ratio of condenser to evaporator y, on the exergo-economic performance of ORCs are analyzed. Moreover, how some other parameters influence the optimal PPTD in evaporator ΔT_e,opt and the optimal PPTD ratio of condenser to evaporator y_opt are also discussed. It has been found that the exergo-economic performance of ORCs is remarkably influenced by ΔT_e and y, and there exists ΔT_e,opt and y_opt. In addition, ΔT_e,opt and y_opt are affected by heat transfer coefficient ratio of condenser to evaporator ß, the temperature of working fluid at dew point in condenser T_1a, and composition of R13I1/R601a: larger ß and T_1a lead to lower ΔT_e,opt and y_opt; by contraries, larger mass fraction of R13I1 makes ΔT_e,opt and y_opt increase, and y_opt increases linearly. The effects of the temperature of working fluid at bubble point in evaporator T_3a, mass flow rate of exhaust flue gas m_g, and inlet temperature of exhaust flue gas T_gi on ΔT_e,opt and y_opt are very slight. For comparison, three additional working fluids, namely R601a, R245fa, and 0.32R245fa/0.68R601a, are also taken into account.     

中国工业CO_2排放的行业间传导网络及协同减排

工业是碳排放的主要部门,科学识别工业CO_2排放的行业间传导并揭示其联动结构对于跨行业协同减排具有重要的理论和现实意义。本文基于1991-2012年中国工业36个两位数行业数据,在VAR模型框架下,利用Granger因果检验方法对CO_2排放的行业间传导关系进行了识别,并从关系视角出发,借助社会网络分析方法(SNA)揭示工业CO_2排放行业间传导的整体和个体网络结构特征,研究发现:工业CO_2排放的行业间传导呈网络结构形态,网络密度在1-6期的滞后阶数下呈先升高后下降的趋势,并且在滞后2期达到最高;燃气生产和供应业、电力热力生产和供应业、服装业、造纸及纸制品业、木材加工业具有较高的度数中心度、中介中心度、接近中心度,在网络中处于核心位置,并发挥中介和桥梁作用;在CO_2排放的行业传导网络中,煤炭采选业、黑色金属矿采选业、有色金属矿采选业等10个行业属于经纪人板块,医药制造业、饮料制造业、化学纤维制造业等9个行业属于净受益板块,金属制品业、塑料制品业、农副食品加工业等11个行业属于双向溢出板块,烟草加工业、石油加工及炼焦业、燃气生产和供应业等6个行业属于净溢出板块。基于上述结论,本文提出了工业CO_2排放的跨行业协同减排思路。     

基于LCA的废旧资源循环利用节能减排效果评估模式与方法研究——以吉林省某钢铁企业为例

促进废旧资源循环利用是加快推进我国生态文明建设,完成节能减排目标的必然选择。本文基于生命周期评价模式,从微观企业层面入手,构建产品全生命周期基准流程,引入能量输入与环境输出参数,建立废旧资源循环利用节能减排效果量化核算模型,评估再生产品的节能减排经济成效,并以吉林省某钢铁企业为例,评估"废钢-电炉"短流程和"铁矿石-高炉-转炉"长流程的能源、环境、成本差异,辨识影响废钢再循环节能减排效果的主要因素和重要环节。结果显示,再生钢铁全生命周期与原生钢铁全生命周期相比,节能588.48kgce/t,节能率为84%;主要污染物中SO2减排率最高,达92%;CO2总减排1 180.92 kg/t,减排率为67%;总成本却高出198元/t。其中,炼铁工序的节能量和减碳量最大,烧结工序SO2、NOx和烟(粉)尘减排量最大,焦化工序COD和氨氮减排量最大,回收、加工处理、炼钢环节节能量和减碳量以及SO2、NOx和烟(粉)尘减排量均为负。成本方面,再生钢铁生产成本高于原生钢铁308元/t,虽然再生钢铁由于污染减排可节省56元/t的排污费并获取54元/t的碳交易收益,但都不足以扭转电炉炼钢费用较高的现状。因此,国家应在电炉炼钢方面给予钢企及相关企业适当的财税扶持政策,在电价方面给予钢企一定的优惠或补贴,并完善废钢回收加工体系等,以促进废钢循环利用。基于LCA的废旧资源循环利用节能减排效果评估可以实现对产品生命周期全过程的资源、环境、成本的优化管理。