全文获取类型
收费全文 | 52篇 |
免费 | 1篇 |
国内免费 | 7篇 |
专业分类
废物处理 | 2篇 |
环保管理 | 14篇 |
综合类 | 27篇 |
基础理论 | 5篇 |
污染及防治 | 10篇 |
评价与监测 | 1篇 |
社会与环境 | 1篇 |
出版年
2021年 | 1篇 |
2020年 | 1篇 |
2019年 | 1篇 |
2017年 | 3篇 |
2016年 | 1篇 |
2014年 | 2篇 |
2013年 | 4篇 |
2012年 | 5篇 |
2011年 | 4篇 |
2010年 | 2篇 |
2009年 | 2篇 |
2008年 | 1篇 |
2007年 | 2篇 |
2006年 | 3篇 |
2004年 | 2篇 |
2003年 | 4篇 |
2002年 | 3篇 |
2001年 | 1篇 |
2000年 | 5篇 |
1999年 | 2篇 |
1998年 | 4篇 |
1997年 | 1篇 |
1996年 | 2篇 |
1995年 | 1篇 |
1994年 | 1篇 |
1993年 | 2篇 |
排序方式: 共有60条查询结果,搜索用时 31 毫秒
31.
32.
33.
34.
35.
构造环境对幔源岩中稀有气体同位素比值的制约 总被引:1,自引:0,他引:1
稀有气体是地球化学研究中有效的物源示踪剂。在广泛收集资料的基础上,通过对He、Ne、Ar同位素数据的统计分析,总结、对比了不同构造环境幔源物质中轻稀有气体同位素的组成特征。统计表明,大洋中脊玄武岩(MORB)中3He/4He=7 0~10 0Ra者约占统计样品的90%;洋岛幔源物质(OIB)的3He/4He值变化范围大,但>10 0Ra者占65%;消减带幔源岩的3He/4He值总体略低于MORB;大陆幔源岩的3He/4He值主要变化于6 0~10 0Ra间,但环太平洋大陆边缘低于MORB者普遍;大陆热点地幔流体具有类似OIB的3He/4He值分布特征。MORB与OIB的40Ar/36Ar值分布范围类似(主要范围为296~12000),但低于1000者在MORB中仅24 5%,而在OIB中约43 4%;板块俯冲区幔源岩的40Ar/36Ar值总体较低,<1000者约占67%;大陆各类地幔流体的40Ar/36Ar值普遍偏低,主要在4000以下。大陆、大洋幔源岩中20Ne/22Ne值主要介于9 8~12 5间,但<9 8者在各大陆地幔普遍存在。幔源物质的上述组成特征与大气、地壳等源区对其影响有关。我国东部幔源物质稀有气体同位素组成具有大气 地幔混合源区特征。 相似文献
36.
实验研究了虾夷扇贝不同组织(鳃,内脏,外套膜和贝柱)在受到重金属Cd2+污染后的蓄积和排放规律。结果表明:(1)在染毒实验期间,海水中Cd2+不断被虾夷扇贝累积,且其内脏团、外套膜、鳃、贝柱中Cd2+的蓄积量均随暴露时间增加而增大。到第14 d均达到平衡。达到平衡后Cd2+蓄积量(干重)和蓄积速率均为:内脏团>鳃>外套膜>贝柱。其数值分别为:562.93×10-6和40.21×10-6/d,354.27×10-6和25.31×10-6/d,125.36×10-6和8.95×10-6/d,34.49×10-6和2.46×10-6/d。(2)排放实验期间,各组织中Cd2+蓄积量随排放时间的增加而逐渐下降。至排放第10天各组织中的Cd2+排出率为:贝柱﹥鳃﹥外套膜﹥内脏,各组织中Cd2+含量明显降低。表明:经短时间镉污染的虾夷扇贝,转入清洁海水一段时间对其体内Cd2+的排出是很有效的。(3)不同浓度Cd2+对虾夷扇贝各组织的影响实验表明:当Cd2+浓度相同时,扇贝不同组织蓄积量和富集系数次序均为:内脏团>鳃>外套膜>贝柱。虾夷扇贝各组织Cd2+蓄积量均随着暴露水体中Cd2+含量的增加而增加,海水中Cd2+浓度不影响Cd2+在虾夷扇贝各组织内的分配次序。而同一组织对Cd2+的富集系数与其蓄积量不同,它随着金属浓度的升高而呈现下降的趋势,贝柱的富集系数始终处在最低值。 相似文献
37.
采用UV/Fenton法处理金属切削液废水,通过正交试验和单因素试验得到其最佳工作条件为pH=2.5、H2O2(浓度30%)投加量=127.5 mL/L、Fe2+投加量=24.8 mmoL/L、总反应时间=2 h、投加次数6次,此条件下金属切削液废水COD去除率可达到94.4%;并采用1stOpt软件对正交试验数据和单因素模型方程进行多元非线性拟合,建立了UV/Fenton法处理金属切削液废水COD降解率的数学模型方程,模型结论与正交试验结果一致,表明该模型可以正确地反映UV/Fenton法处理金属切削液废水的降解效果。 相似文献
38.
The Influence of mixed and pure working fluids on the performance of organic Rankine cycles (ORCs) is discussed. Specifically, the performance of mixed and pure working fluids is analyzed based on certain characteristics of low-temperature heat source and heat sink. A method of selecting binary zeotropic mixed working fluids that match with different heat sinks is introduced. Thermodynamic processes of ORCs for various heat sources are simulated in Matlab. The performance characteristics of pure and mixed working fluids are compared under different inlet temperatures and temperature gradients of sensible heat sources. The results demonstrate that when the initial temperature of a heat source is lower and its temperature gradient is higher, and the temperature gradient of the heat sink is higher, mixed working fluids have better performance than pure working fluids. However, for the opposite heat source and heat sink situations, pure working fluids perform better. Mixtures with low critical temperature components exhibit the best performance among all working fluids when the temperature gradient of the heat source is large. The analysis also shows that introduction of a recuperator may reduce the cycle efficiency when the heat source temperature is low and the temperature gradient of the heat source is large. 相似文献
39.
40.
针对气田压裂返排液回用配制压裂液的水质要求,研究了pH值、金属离子、细菌和泡沫对处理后液体配制压裂液的影响。结果表明,通过调节pH值、控制金属离子浓度、加入杀菌剂和消泡剂可以达到回用配制压裂液的要求。其中,pH值应控制在6.5左右;当Na2CO3和NaOH的复配比为800/600、NaOH投加量为300mg/L时,能有效去除Ca2+、Mg2+、Fe3+等离子的影响;杀菌剂采用气田压裂专用杀菌剂;消泡剂采用二甲基硅油。实验在气井井场采用撬装微涡流混凝装置处理气田压裂返排液,并对上清液回用配液,回用率达到98.4%。 相似文献