The influence of radiopharmaceutical isotope production on the global radioxenon background

Radioxenon isotopes play a major role in confirming whether or not an underground explosion was nuclear in nature. It is then of key importance to understand the sources of environmental radioxenon to be able to distinguish them from those of a nuclear explosion.     

Influence of temporally variable groundwater flow conditions on point measurements and contaminant mass flux estimations

Monitoring of contaminant concentrations, e.g., for the estimation of mass discharge or contaminant degradation rates, often is based on point measurements at observation wells. In addition to the problem, that point measurements may not be spatially representative, a further complication may arise due to the temporal dynamics of groundwater flow, which may cause a concentration measurement to be not temporally representative. This paper presents results from a numerical modeling study focusing on temporal variations of the groundwater flow direction. “Measurements” are obtained from point information representing observation wells installed along control planes using different well frequencies and configurations. Results of the scenario simulations show that temporally variable flow conditions can lead to significant temporal fluctuations of the concentration and thus are a substantial source of uncertainty for point measurements. Temporal variation of point concentration measurements may be as high as the average concentration determined, especially near the plume fringe, even when assuming a homogeneous distribution of the hydraulic conductivity. If a heterogeneous hydraulic conductivity field is present, the concentration variability due to a fluctuating groundwater flow direction varies significantly within the control plane and between the different realizations. Determination of contaminant mass fluxes is also influenced by the temporal variability of the concentration measurement, especially for large spacings of the observation wells. Passive dosimeter sampling is found to be appropriate for evaluating the stationarity of contaminant plumes as well as for estimating average concentrations over time when the plume has fully developed. Representative sampling has to be performed over several periods of groundwater flow fluctuation. For the determination of mass fluxes at heterogeneous sites, however, local fluxes, which may vary considerably along a control plane, have to be accounted for. Here, dosimeter sampling in combination with time integrated local water flux measurements can improve mass flux estimates under dynamic flow conditions.     

XZKP型高效空塔喷淋烟气脱硫装置技术特点

介绍了XZKP型高效空塔喷淋烟气脱硫装置的技术原理、技术特点、中试及工业化试验的情况。该技术通过改进工艺和结构,在提高脱硫效率和脱硫剂循环利用率两项技术上成效显著,用户可在不增加装置投资的前提下,获得更高的效率和更低的运行成本。     

Evaluation of two models of a slipmeter

The aim of the study was to compare the performances of the Brungraber Mark II (BM II) and Mark III (BM III) slipmeters. Friction measurements with the two slipmeters were conducted in a laboratory using four footwear materials, four floor types, and three surface conditions. Both the coefficient of friction (COF) values obtained with the slipmeters and the force platform-based COF values were measured. The COF measured with the BM II was slightly higher than that measured with the BM III with a R² of 0.83. A comparison of the averaged normal force between the two slipmeters showed that the BM II generated a significantly higher normal force than the BM III at a low COF and the difference of the normal force between the two slipmeters decreased when the COF value was increased. The regression analysis results in this study showed that the force platform-based COF values were closer to the COF values obtained with the BM III than with the BM II. The R² values for the regression model between the COF values obtained from the slipmeter and the force platform were 0.90 and 0.79 for the BM II and BM III, respectively.     

热真空设备中与温度相关的试验技术探讨

以RZHM-1400-AB型热真空试验箱为实例,简述设备主要工作原理。强调其温度传递方式及航天产品在热真空试验中温度参数的重要性。以无数试验数据为依据,着重论证何种类型测温传感器与实际设备相匹配,同时论证选取何种外形的测温传感器为最佳温度测量工具。同时,进一步介绍几种在热真空试验中使用这些测温传感器的方法,以减少不必要的人为测量误差。     

锶盐废渣含硫状态分析及硫含量的测定

锶盐废渣中硫的状态及含量不同其作用大不相同,有的呈现活性导致膨胀破坏,而有的则表现为惰性,因此有必要了解硫的存在状态及含量。分析表明锶盐废渣中硫主要以硫酸盐硫(SO3)和硫化物硫(S2-)两种形式存在。选择硫酸钡重量法和碘量法进行化学测定,然后用X-射线能谱仪进行元素定性分析;并将化学分析和仪器测定两种方法进行对比。结果表明,X-射线能谱法可以快捷、方便地探测锶渣所含各种元素,但不能确定元素的价态;化学分析方法可得到相对准确的元素含量;用硫酸钡重量法和碘量法联合测定锶渣中的硫含量,与X-射线能谱法相比,偏差仅为0.37%。     

三维脚型测量技术及方法的研究

本文阐述了人体脚型的测量方法及特点,比较后得出人工测量与三维扫描测量技术之间的差别。以YETI三维脚型扫描仪为模型,详细分析了脚型扫描仪的结构原理,摸索并提出了简单实用的测量方法,讨论了YETI三维脚型扫描仪获得的原始数据、脚型横截面以及脚型投影图的特点。     

Use of Scale Invariance in Evaluating Judgement Indicators

Indicators are used to draw conclusions about ecological endpoints when these endpoints cannot be measured directly. In many cases, inferences about an endpoint are only possible because assumptions have been made about the relationship between indicator and endpoint; we refer to such indicators as judgement indicators. The validity of inferences made using a judgement indicator can be gauged by examining the known or assumed form of the general relationship between indicator and endpoint. The rules for this kind of inference are a consequence of scale invariance, which originates from measurement theory. For simple indicators comprised of a single indicator measurement, the inferences allowed – equivalence, rank, equality of intervals, and equality of ratios – depend on whether the data are nominal, ordinal, interval, or ratio scaled. For composite indicators containing two or more simple indicators, inferences are also affected by the mathematical form of combination; e.g., whether the terms are summed or multiplied. Standardizing simple or composite indicators can allow inferences about the relative importance of observations, based on the natural range of occurrence. Scale invariance is a particularly important consideration in landscape assessments, since these often make use of judgement indicators.     

接地保护与接零保护安全性比较

我国现存标准或规范仍在推荐使用接零保护(TN系统),这是一种人为增大故障电流、以过流保护装置(过流保护断路器或熔断器)对漏电进行防护的方法.在漏电保护器RCD广泛应用的今天,完成漏电防护的首要装置是RCD,而不再是过流保护装置.通过基于RCD的漏电防护水平评价和对本质安全性的综合比较, 得出的结论是接地保护(TT系统)比接零保护(TN系统)更安全.     

PREDICTING MEASUREMENT ERROR OF AREAL MEAN PRECIPITATION DURING EXTREME EVENTS1

ABSTRACT: The areal mean precipitation (AMP) over a catchment is normally calculated using point measurements at rainfall gages. Error in AMP estimates occurs when an insufficient number of gages are used to sample precipitation which is highly variable in space. AMP error is investigated using historic, severe rainfalls with a set of hypothetical catchments and raingage networks. The potential magnitude of error is estimated for typical gage network densities and arrangements. Possible sources of error are evaluated, and a method is proposed for predicting the magnitude of error using data that are commonly available for severe, historic rainfall.