A Constant Erosion Rate Model for Fine Sediment in the York River,Virginia

Results of field experiments using the Virginia Institute of Marine Science' Sea Carousel and tripod system reveal a highly dynamic sediment activity at the Clay Bank site in the York River. At the water-sediment interface, the critical bed shear stress for sediment erosion varied between 0.026 Pa and 0.1 Pa. For the well consolidated sediment below the interface, the critical bed shear stress increased significantly, to more than 0.6 Pa. The seasonal variation of erosion rate for the surficial sediment is significant. For the well consolidated sediment below the surficial sediment, however, the seasonal variation diminished and erosion rate approached a constant. Experimental results from the Carousel deployments imply that the erosion process for quasi-steady tidal flows is always near equilibrium. For this reason, a constant rate erosion model is proposed for the time during tidal acceleration phases. For other times, the erosion rate would be zero. The measured suspended sediment concentration at 10 cm above bed from the VIMS tripod system also Supports this model.     

Indoor radon levels in Greek schools

Radon and gamma dose rate measurements were performed in 512 schools in 8 of the 13 regions of Greece. The distribution of radon concentration was well described by a lognormal distribution. Most (86%) of the radon concentrations were between 60 and 250 Bq m⁻³ with a most probable value of 135 Bq m⁻³. The arithmetic and geometric means of the radon concentration are 149 Bq m⁻³ and 126 Bq m⁻³ respectively. The maximum measured radon gas concentration was 958 Bq m⁻³. As expected, no correlation between radon gas concentration and indoor gamma dose rate was observed. However, if only mean values for each region are considered, a linear correlation between radon gas concentration and gamma dose rate is apparent. Despite the fact that the results of radon concentration in schools cannot be applied directly for the estimation of radon concentration in homes, the results of the present survey indicate that it is desirable to perform an extended survey of indoor radon in homes for at least one region in Northern Greece.     

Measurement techniques for organizational safety causal models: Characterization and suggestions for enhancements

Through a review of literature from diverse disciplines with actual and potential application to causal modeling of organizational safety risk, this paper explores issues regarding measurement techniques in a quantitative safety analysis context. The interdependencies of modeling perspectives, constructs, and measures are indentified, leading to (a) characterization and classification of measurement techniques, (b) suggestions on the selection of appropriate measurement methods for different types of model constructs including individual-level, global, configural, and shared, and (c) discussion of the modeling implications of interactions between measurement, constructs, and causal paths. A multi-dimensional perspective is offered through combinations of different “measurement methods” and “measurement bases”. A Bayesian approach is also proposed to operationalize the multi-dimensional measurements. Examples are provided to help explain the roles of these measurements in capturing the relation between organizational factors and safety performance. This paper is a product of research which has the primary purpose of extending Probabilistic Risk Assessment (PRA) modeling frameworks to include the effects of organizational factors as the fundamental causes of accidents and incidents.     

Long-term investigation of anthropogenic and naturally occurring radionuclides at reference sites in western Sweden

In case of an accidental release of radioactive substances into the environment, it is important to quickly and reliably estimate the radiation dose received by people in the affected area, and to determine the extent of the contamination. Measurements of the extent of the release and the subsequent contamination can be facilitated if there are predetermined reference sampling sites with known background radiation and inventory of radionuclides. Since 1996, 34 reference sites for soil sampling, field gamma, and intensimeter measurements have been established in western Sweden. Time series data for dose rates and radioisotope inventory have been collected at these sites, allowing for the investigation of changes in these parameters over time. The mass activity densities for the uranium and thorium series elements varied approximately between 10 and 50 Bq/kg and between 10 and 40 Bq/kg, respectively. The mass activity density of ⁴⁰K was approximately in the range 300–800 Bq/kg. The radiation exposure due to ¹³⁷Cs was rather small in this area. The dose rates calculated from in situ measurement data showed that the contribution to the total dose rate was almost entirely due to naturally occurring radionuclides. The measured dose rate was about twice as high as the calculated rate, even after subtracting the contribution from cosmic radiation. This may be explained by the fact that intensimeters generally are calibrated to measure the quantity ambient dose equivalent, which should not underestimate the effective dose.     

Application of in-situ measurement to determine Cs in the Swiss Alps

Establishment of ¹³⁷Cs inventories is often used to gain information on soil stability. The latter is crucial in mountain systems, where ecosystem stability is tightly connected to soil stability. In-situ measurements of ¹³⁷Cs in steep alpine environments are scarce. Most studies have been carried out in arable lands and with Germanium (Ge) detectors. Sodium Iodide (NaI) detector system is an inexpensive and easy to handle field instrument, but its validity on steep alpine environments has not been tested yet. In this study, a comparison of laboratory measurements with GeLi detector and in-situ measurements with NaI detector of ¹³⁷Cs gamma soil radiation has been done in an alpine catchment with high ¹³⁷Cs concentration (Urseren Valley, Switzerland). The aim of this study was to calibrate the in-situ NaI detector system for application on steep alpine slopes. Replicate samples from an altitudinal transect through the Urseren Valley, measured in the laboratory with a GeLi detector, showed a large variability in ¹³⁷Cs activities at a meter scale. This small-scale heterogeneity determined with the GeLi detector is smoothed out by uncollimated in-situ measurements with the NaI detector, which provides integrated estimates of ¹³⁷Cs within the field of view (3.1 m²) of each measurement. There was no dependency of ¹³⁷Cs on pH, clay content and carbon content, but a close relationship was determined between measured ¹³⁷Cs activities and soil moisture. Thus, in-situ data must be corrected for soil moisture. Close correlation (R² = 0.86, p < 0.0001) was found for ¹³⁷Cs activities (in Bq kg⁻¹) estimated with in-situ (NaI detector) and laboratory (GeLi detector) methods. We thus concluded that the NaI detector system is a suitable tool for in-situ measurements in alpine environments. This paper describes the calibration of the NaI detector system for field application under elevated ¹³⁷Cs activities originating from Chernobyl fallout.     

Assessment of Chlorophyll-a Concentration and Trophic State for Lake Chagan Using Landsat TM and Field Spectral Data

In this study, we present the digital evaluation of Landsat TM data and field spectral measurements for retrieving chlorophyll-a (chl-a) concentration and trophic state index in Lake Chagan of Northeast China. Chl-a concentration of the lake can be estimated from the band ratio (TM4/TM3) and the field spectral data at 670 nm (absorption peak) and at 700 nm (reflectance peak). The results show that the best determination coefficient (R ²) is 0.67 from the TM data, by which chl-a distribution can be mapped. Based on chl-a determination from laboratory analysis, field spectral and TM data, the modified trophic state index (TSI_M) was applied to assess the lake’s trophic state. With the available data in Lake Chagan, each algorithm demonstrates the similar result for assessing the lake’s chl-a and trophic state. Our results indicate that Landsat TM and field spectral data could be used effectively to determine chl-a concentration and evaluate the trophic state of Lake Chagan in the study.     

Hydrogen explosion incident mitigation in steam reforming units through enhanced inspection and forecasting corrosion tools implementation

Hydrogen (H₂) explosion effects recently examined, are confirming the devastating loss scenarios to humans, environment, assets, and associated business interruption. H₂ production is a core process in refineries used in further process steps. Steam reforming of natural gas or a mix with naphtha or LPG is a common hydrogen production technique, where the latest technologies have adopted enhanced metallurgies to minimize explosion risk and the associated maintenance cost following plant degradation owing to corrosion effects. However, corrosion rates are still high in specific areas of piping and process equipment. The aim of this paper is to present a methodology based on semi-quantitative RBI modeling according to regulations by API and recent EN standards, adopting a family of linear regression forecasting models that depict the yearly corrosion rate (per corrosion loop) of a hydrogen production steam reforming unit; this is done under different operating conditions (e.g., temperature, pressure, and fluid speed), metallurgy and other related physicochemical variables. The model is based on the examination of both ultrasonic wall thinning measurements and the examination of quantitative crosslinking total corrosion effects along with the physicochemical properties prevailing in different plant corrosion loops. The outcome of the regression analysis is an expansive family of multivariable equations describing, with a defined accuracy, the yearly corrosion rate and associated lifespan forecast per corrosion loop, and per examined part. These equations were further utilized in a custom-made database that can be used as an additional loss prevention tool by the hydrogen production unit management team. Evaluation results regarding the tool efficiency are presented in the following of this paper.     

Dispersion in Urban Environments; Comparison of Field Measurements with Wind Tunnel Results

A wind tunnel study was performed to determine the dispersion characteristics of vehicle exhaust gases within the urban canopy layer. The results were compared with those from a field monitoring station located in a street canyon with heavy traffic load. The agreement found was fair. In the second part of the paper it is shown how wind tunnel data can be utilized to supplement and thereby enhance the value of field data for model validation purposes. Uncertainty ranges were quantified which are inherent to mean concentration values measured in urban streets.     

Comparison of Numerical Street Dispersion Models with Results from Wind Tunnel and Field Measurements

Numerical dispersion models developed and validated in different European countries were applied to data sets from wind tunnel and field measurements. The comparison includes the Danish Operational Street Pollution Model (OSPM) and the microscale flow and dispersion model MISKAM. The latter is recommended for application in built-up areas in the draft of the new German guideline VDI 3782/8. In a first step the models were applied to simplified street configurations. Different parameters as length and height of adjacent buildings and the angle of the incoming flow were varied. The results were compared to recent wind tunnel measurements. In a second step the models were applied to two extensively investigated field data sets from Jagtvej, Copenhagen and G ttinger Straße, Hannover. Intensified and more transparent and accessible validation procedures would be helpful for the thorough user.     

The development of loads of cations, anions, Cd and Pb in precipitation and of atmospheric concentrations of N-components, in Switzerland from 1988 to 2003

This study presents the results of the analyses of Cd, Pb, cations and anions present in precipitation and dust at a pre-alpine and a suburban site in Switzerland in the period from 1988 to 2003. The aim of these measurements was to monitor the success of measures taken to diminish pollutant emissions. No change was found for Ca²⁺, K⁺, Na⁺ and Mg²⁺ loads – in line with expectations, as no reducing measures had been taken. Statistically significant and largely decreasing values (50–90%) were found for Cl⁻ and Cd (linked to the fitting of filters in incineration plants), Pb (unleaded petrol), (diminishing the use of mineral oil with high S content), and the proton (lower HCl and SO₂ emissions). A smaller decrease (up to 30%) or none was registered for oxidised nitrogen components (fitting cars with catalytic converters, but an increase in numbers of cars and trucks). No significant change was found for NH₃ as farming techniques had undergone no major changes. The long-term measurements show that the measures taken to reduce emissions were successful. A shorter monitoring period would have been misleading owing to data variability and temporary incidents e.g. amount of precipitation.