弹性滑移支座力学性能的试验研究

介绍了弹性滑移支座的原理、构造和特点;通过对其在不同工况下的性能试验,研究了竖向荷载、位移幅值以及加载频率对弹性滑移支座力学性能的影响,并给出了试验值与理论计算值之间的对比。研究结果表明:弹性滑移支座具有良好的工作性能,滞回曲线饱满,耗能能力强;竖向荷载和加载频率对弹性滑移支座的力学性能有一定的影响,而位移幅值对其影响较小;弹性滑移支座的恢复力模型,可以用考虑速度的指数摩擦力模型来描述,并且模拟得较为准确。     

采用接触面单元分析砼-岩系统的力学行为

考虑实际修建过程中塔基岩石开挖的施工特点和砼分期浇筑特点,通过建立三维实体模型,根据基于大变形理论的快速拉格朗日方法,运用考虑库仑屈服准则的塑性接触面单元计算了锦屏一级水电站泄洪洞进口塔基砼-岩接触系统的应力和变形,评价了塔基的稳定性,并与直接考虑材料为实体单元的计算结果进行了比较。工程算例数值计算结果表明,采用接触面单元来分析砼-岩系统的力学行为更合理、更实用。     

造纸中段废水与生活污水合并深度处理工艺

采用水解酸化 CAST 混凝 复合滤池与水解酸化 接触氧化 混凝 复合滤池2种组合工艺对造纸中段废水与生活污水进行合并处理对照试验.结果表明,两种工艺都是切实可行的,二级出水均可达到<污水综合排放标准>(GB8978-1996)二级标准,深度处理出水可达中水水质要求.其中以水解酸化 CAST 混凝 复合滤池组合工艺效果最好.     

Effect of sulfate on the methanogenic activity of a bacterial culture from a brewery wastewater during glucose degradation

The maximum specific methanogenic activity （SMA） of a sludge originating from a brewery wastewater treatment plant on the degradation of glucose was investigated at various levels of sulfate on a specific loading basis. Batch experiments were conducted in serum bottles at pH 7 and 35℃. A comparison of the values indicates that the SMA of this mixed culture was increased and reached its highest level of 0.128 g CH4 gas COD/（g VSS.d） when biomass was in contact with sulfate at a ratio of 1：0.114 by weight.     

Treated wastewater irrigation effect on soil, crop and environment： Wastewater recycling in the loess area of China

A study was carried out at the Loess Plateau in Dongzhi,China,to test the feasibility of using secondary treatment sewage effluent and to determine whether the water quality would then meet the recommended irrigation norm.Seven crops,including celery,wheat, maize,millet,apples,rapeseed and yellow beans,were tested in the study.Physical and chemical properties of the soil,crop yield and quality and leachate at different soil depths were measured.In most cases,the quality of the crops that made use of treated sewage was not distinctively different from those that did not use treated sewage.However,yields for the former were much higher than they were for the latter.Leachates at different soil depths were analyzed and the results did not show alarming levels of constituents.For a period of approximately 14 months,the treated sewage irrigation had no significant effect on the loess soil and no cases of illness resulting from contact with the treated sewage were reported.With treated sewage irrigation,a slight increase in the organic content of the soil was observed.     

Non-UV based germicidal activity of metal-doped TiO2 coating on solid surfaces

A stain-based screening method was developed to screen different catalyst coatings for their germicidal activity. A Baclight dead/live bacteria viability kit （invitrogen, molecular probes） was used for staining the cell. The screening was carried out following a standard procedure. This included loading cell suspension to solid surface and maintaining contact for 30 min, then staining with a mixture containing dyes. The stained cells were observed using an epifluorescent microscope and photographed with a CCD camera under UV. Metal-doped TiO2 coatings on AI plates were prepared and tested for non-UV germicidal activity without using UV. It was tested using model microorganisms such as Bakers Yeast （Saccharomyces cerevisiae）, Bacillus subtilis, Pseudomonas putida, and Escherichia coli. On the basis of the germicidal activity of catalyst and the degree of damage caused to the cells, the stained cells may appear green （viable）, green with red or yellow nuclei and yellow （compromised） or red （nonviable）. According to their stained color, cells were counted to calculate the percentage of dead, live, and compromised cells. Compromised cells are cells that grow very slowly after reculturing indicating a degree of reversible cell damage. Screening the germicidal activity using this staining method is accurate and efficient, and requires less time than the culture-based method. A modification to the procedure for measuring germicidal activity of rough surfaces or fibrous coatings was developed. Both TiO2 and metal-doped TiO2 （Ag, Pt, Au, Cu） possess non-UV based germicidal activity. The germicidal activity of TiO2 was found to be related with its wetting property and can be improved by UV irradiation before testing. It is not greatly affected by contact time, indicating a fast acting germicidal activity.     

伪装遮障材料耐老化性能与机理分析

目的 研究伪装遮障材料在实用期的老化机理,获悉伪装遮障材料失效的主要环境因素。方法 通过分析伪装遮障材料在自然环境和实验室单因素环境中的性能变化,得出影响伪装遮障材料老化失效的主要因素。采用扫描电子显微镜、红外光谱仪、X射线光电子能谱仪表征材料的微观形貌、化学结构和化学成分变化,解释伪装遮障材料的老化机理。结果 获得了在不同自然环境、实验室单因素环境下,伪装遮障材料颜色外观和力学性能的变化规律,得到了伪装遮障材料在老化过程中发生的微观形貌、化学结构和化学成分变化。结论 伪装遮障材料在西双版纳自然环境下的老化程度最大,在济南自然环境下的老化程度最小。光照是导致伪装遮障材料颜色外观及力学性能降低的主要因素。老化过程中,主要是材料表面的聚氨酯发生老化、脱落,导致材料的力学性能下降。伪装遮障材料破坏时,纤维有2种失效形式,一种是纤维脱黏、直接断裂;另一种是纤维脱黏,拔出,或者拔出过程中断裂。     

HAN基ECSP凝胶模型的构建与分子动力学模拟

目的 从微观分子的角度对硝酸羟胺(HAN)基电控固体推进剂(Electrically Controlled Solid Propellants,ECSP)的性能参数进行模拟与计算。方法 利用分子表面静电势(ESP)对HAN分子2种可能的构型进行优化和稳定性分析。通过真空非周期性分子动力学模拟得到聚乙烯醇(PVA)分子稳定构型,并以HAN基ECSP的主要成分按一定比例构建凝胶模型。基于RESP(Restrained Electrostatic Potential)电荷生成更准确的凝胶模型拓扑文件,并进行凝胶模型的分子动力学模拟、模型稳定分析以及模型参数计算。结果 凝胶模型总能量相对平均值的周期性波动不超过7%。由于三维PVA链的包裹,H2O分子的扩散系数被大幅削弱。氢键分析和径向分布函数表明氢键键长主要分布在0.282 6 nm附近,PVA与H2O间的氢键较少,H2O与HAN、H2O与H2O之间的氢键较多。模型密度为1.405 g/cm³,与实验值吻合度高。在283、293、303 K下,HAN基ECSP凝胶模型的拉伸模量依次降低,剪切模量先增后减。在15 K/600 ps冷却速率下,HAN基ECSP凝胶模型的拉伸模量和剪切模量均增大。结论 ECSP制备结束后,冷却过程中的环境温度不宜过高,否则容易造成ECSP力学性能的快速下降,快速冷却可以提高ECSP的力学性能。     

不同冲击速度下硬煤的力学特性试验研究

为了研究硬煤破坏过程中的动态力学特性，采用Φ50 mm变截面分离式霍普金森压杆（SHPB）试验系统，对45#钢制薄壁套筒施加环向约束的硬煤试件进行不同加载速率的冲击压缩试验，得到被动围压下轴向应力-应变曲线、径向应力-应变曲线及最大被动围压和冲击速度的关系。研究结果表明:峰值应力、峰值应变随着冲击速度的增大而增大，最大被动围压值与冲击速度呈幂次增长的关系；被动围压下的硬煤试件变形受到限制，试件延性、抗压能力显著提高；随着冲击速度的增大，薄壁套筒对试件的约束也逐渐增大，达到峰值后，冲击速度对被动围压的影响减小，筒壁厚度影响着被动围压效果。     

生物-物化工艺处理造纸工业废水实例分析

以任丘市星火集团公司造纸厂废水处理工程为例，介绍了采用生物处理、物化处理相结合的工艺处理造纸工业废水的工艺流程以及主要设计参数。该工艺运行稳定，处理效果好，ＣＯＤ的去除率达到８０％以上，处理后的废水水质达到了《造纸工业水污染物排放标准》（ＧＢ３５４４－９２）中的二级标准。