昌吉州农田地膜污染现状及治理对策

通过对昌吉州农田地膜使用现状进行调查,阐述了地膜污染的危害,并提出了适期揭膜、残膜回收、推广新型生物膜等措施与防治对策。     

膜电解法在线再生酸性蚀刻液及回收铜新技术

采用极化曲线法研究了酸性蚀刻液阴、阳极电化学行为,并构建了离子膜电解反应体系,考察了在线再生酸性蚀刻液及回收铜的效果。结果表明,阳极氧化过程发生浓差极化,存在极限电流密度,Cu＋含量越高,极限电流密度越大;阴极还原分4步反应进行,存在极限电流密度;强化溶液传质可有效提高阴、阳极极限电流密度,有利于避免电解过程中析出氯气和氢气;在线实验表明,通过监控阳极液ORP,可避免析出氯气;分步降低电流电解有利于避免析出氢气,形成致密的金属铜块;在电流为9～24A范围内分4步电解23．5h可再生酸性蚀刻液23．5L,同时电沉积回收510g铜,纯度高达99．98％。阴极电流效率达到95．2％,吨铜电耗3251kWh。电解过程中无氯气和氢气析出,无废液排放,表明膜电解法在线再生酸性蚀刻液具有良好的应用前景。     

混凝剂品种对混凝-超滤联合工艺膜污染的影响

本实验以工业化学合成聚合硫酸铁混凝剂和自制生物聚合硫酸铁为例,考察了铁系混凝剂品种对地表水浊度、TOC和UV254的去除效果,混凝剂品种对混凝-超滤联合工艺处理地表水过程中超滤膜污染的影响。混凝实验结果表明,在10 mg/L(以Fe3+计)最佳投加量下,两类混凝剂对浊度、TOC和UV254的去除率基本相同。超滤膜污染实验结果表明,生物聚合铁预处理水样通量衰减速度略大于化学聚合铁预处理水样;膜污染阻力分析结果显示,随着循环次数的增加,工业化学合成聚合铁预处理水样造成的不可逆污染阻力逐渐增加,而生物聚合铁预处理水样造成的不可逆污染阻力却略有下降;膜污染机理分析表明,2组过滤过程的膜污染类型基本相似,由最初的膜孔堵塞过渡到最终的滤饼层污染。SEM分析表明,生物聚合铁预处理水样的膜污染较为严重。     

无机陶瓷膜处理油田采出水

针对陶瓷膜在油田采出水处理过程中操作参数的选择及污染机理进行了研究。通过现场实验,分析了不同的操作参数对膜通量的影响,陶瓷膜对含油量及悬浮物的去除效果,膜阻力组成及膜污染清洗方法。实验结果表明,在确定出水水质达到低渗透油田注水水质A1级标准条件下,陶瓷膜过滤最佳操作条件为:跨膜压差0.16 MPa、温度50℃、膜面流速5.0 m/s。同时发现,NaOH和HNO3联合清洗有助于恢复膜通量。     

Influence of Relative Humidity and Ozone on the Sampling of Volatile Organic Compounds on Carbotrap/Carbosieve Adsorbents

By using a dynamic dilution system, the atmospheric measurement of 11 selected toxics VOCs (ethylene, acetylene, propene, 1-butene, 1,3-butadiene, 1-pentene, 1-hexene, benzene, toluene, ethylbenzene, m+p-xylene) from the list WHO of 1996 and TO-14 method of US EPA by preconcentration by thermal desorption (TD), analysis by gas chromatography (GC), identification and quantification with a flame ionisation detector (FID) was developed and validated in term of metrology, especially the techniques of sampling of these VOCs with adsorbents cartridges "Air Toxics" when used with an "UMEG sampler" equipped in the inlet with a nafion membrane. In particular the influence of climatic conditions (temperature and relative humidity) and the influence of chemical factors like ozone, on the representativity of sampling were studied. Experiments made with various humidities showed that the addition of a nafion membrane in the inlet of the sampling system was required. Without this membrane, losses of compounds were observed for RH >50%. With this membrane, storage for 2 weeks in a refrigerator, as for canisters, did not induce a loss of compounds. No significative decrease of concentrations of the studied VOCs after 14 days storage, which are known to react with ozone, were observed with an ozone concentrations of 55 ppb. One explanation is that nafion membrane, placed in the inlet of the sampler, will neutralize ozone before entering the sampling tubes. This observation is in accordance with literature which states that the sampling of VOCs on Carbotrap cartridges without ozone scrubber induce a loss of compounds.     

不同操作条件对纳滤膜去除水中五价砷的研究

采用纳滤膜（NF90）过滤自配含砷水,研究在不同操作条件下纳滤膜对水中砷去除效果的影响。本实验探讨膜进水浓度、水的pH值、膜进水温度、操作压力、水中天然有机物浓度等对膜除砷效率的影响。结果表明：纳滤膜对水中五价砷（As（Ⅴ））的去除率很高,最高去除率能达到99%,在实验的前2.5个小时内,砷的去除率均在90%以上。但是,纳滤膜除砷效率随着时间变化,去除率会降低。不同的操作条件对纳滤膜除砷的影响很大,研究不同条件的影响对应用很有意义。     

滤筒法测定水中悬浮物的实践

采用重量法用滤筒替代滤膜进行测定水中悬浮物的比对实验,实验结果表明:滤筒测定水中悬浮物比滤膜测定水中悬浮物更具有易恒重、测定误差小、准确度高、快速、简便、成本低等优点,适合水质监测应用。     

Simulation studies of ammonia removal from water in a membrane contactor under liquid–liquid extraction mode

Simulation studies were carried out, in an unsteady state, for the removal of ammonia from water via a membrane contactor. The contactor had an aqueous solution of NH₃ in the lumen and sulphuric acid in the shell side. The model equations were developed considering radial and axial diffusion and convection in the lumen. The partial differential equations were converted by the finite difference technique into a series of stiff ordinary differential equations w.r.t. time and solved using MATLAB. Excellent agreement was observed between the simulation results and experimental data (from the literature) for a contactor of 75 fibres. Excellent agreement was also observed between the simulation results and laboratory-generated data from a contactor containing 10,200 fibres. Our model is more suitable than the plug-flow model for designing the operation of the membrane contactor. The plug-flow model over-predicts the fractional removal of ammonia and was observed to be limited when designing longer contactors.     

膜法处理低温低浊水技术综述

低温低浊水的处理是给水处理的一个难点.分析了常规混凝方法难处理低温低浊水的原因,介绍和比较了膜处理低温低浊水的4种方法.研究结果表明,膜法出水水质好、稳定,采用低压膜直接过滤降低能耗,节省药剂投加费用;混凝-超滤工艺中加入粉末活性炭后可增加溶解性有机物的去除,膜生物反应器能有效去除氨氮.膜法处理低温低浊水对浊度和有机物的去除明显好于传统工艺,能提供水质良好的饮用水,是低温低浊水处理的发展方向.