微氧环境下硝基苯废水的处理效果

采用微氧条件下的序批式活性污泥反应器(SBR)处理硝基苯废水。研究结果表明,在水力停留时间(HRT)为24h,曝气量为600mL/min的条件下,反应器对硝基苯的平均去除率为100.00%,对其共存污染物COD、氨氮也有较好的去除效果,平均去除率分别为97.78%和78.55%,对TN和TP的去除效果相对较差,其平均去除率仅为24.18%和19.09%。气相色谱/质谱(GC/MS)分析表明,硝基苯降解的主要中间产物为苯胺,说明反应器中硝基苯首先是通过还原途径降解为苯胺,苯胺再进一步被降解为CO2、H2O和NH3。考察了不同曝气量(200、400、600mL/min)条件对处理效果的影响,结果表明,曝气量的降低直接导致了反应器中DO浓度的降低,导致COD、苯胺的去除效果变差。曝气量由600 mL/min降低至200 mL/min,COD平均去除率由97.78%降低至82.09%,出水苯胺平均质量浓度由0mg/L升至15.04mg/L。     

Dechlorination of carbon tetrachloride by the catalyzed Fe-Cu process

The electrochemical reduction characteristics of carbon tetrachloride (CT) were investigated using cyclic voltammetry in this study. In addition, the difference in reduction mechanisms of CT between Master Builders' iron and the catalyzed Fe-Cu process was discussed. The results showed that CT was reduced directly on the surface of copper rather than by atomic hydrogen produced at the cathode in the catalyzed Fe-Cu process. The reduction was realized largely by atomic hydrogen in Master Builders' iron. The entire CT in 350 ml aqueous solution with 320 mgL was reduced to trichloromethane and dichloromethane in 2.25 h when 100 g of scrap iron with FeCu ratio of 10:1 (ww) were used. Moreover, the reduction rate slowed with time. CT could be reduced at acidic, neutral and alkaline pH from solution by Fe-Cu bimetallic media, but the mechanisms were di?erent. The degradation rate was not significantly in?uenced by pH in the catalyzed Fe-Cu process; in Master Builders' iron it clearly increased with decreasing pH. The kinetics of the reductions followed pseudo-first order in both cases. Furthermore, the reductions under acidic conditions proceeded faster than that under the neutral and alkaline conditions. The catalyzed Fe-Cu process was superior to Master Builders' iron in treating CT-containing water and this advantage was particularly noticeable under alkaline conditions. The reduction was investigated in the cathode (Cu) and anode (Fe) compartments respectively, the results showed that the direct reduction pathway played an important role in the reduction by the catalyzed Fe-Cu process. The catalyzed Fe-Cu process is of practical value.     

阳极初始电势对微生物燃料电池产电的影响

在微生物燃料电池中,阳极电势会对产电菌的富集和生长产生影响.为进一步明确阳极电势的作用,确定适合微生物生长的最佳阳极电势,在微生物燃料电池的阳极室中设置附加电路以改变阳极的初始电势,考察阳极初始电势对产电微生物的影响.将阳极初始电势设为350 mV时,产电微生物的生长明显变慢.而阳极初始电势为-200 mV和200 mV时,微生物的生长速度基本相同.稳定运行后,阳极初始电势分别为350、200和-200 mV的微生物燃料电池,阳极内阻分别为71、43和80 Ω.通过变性梯度凝胶电泳(DGGE)分析微生物燃料电池稳定产电前后阳极微生物群落结构,虽然3个微生物燃料电池的阳极初始电势不同,但稳定后微生物群落结构相似,Clostridium sticklandii、Pseudomonas mendocina、Paenibacillus taejonensis在阳极的富集量最多,MFC对这3种细菌的强化富集作用最明显.     

海洋环境Al-Zn-In-Mg-Ti牺牲阳极腐蚀防护研究

以Al-Zn-In-Mg-Ti牺牲阳极为研究对象,在海洋环境下做车辆的牺牲阳极腐蚀防护试验。采用电位自动记录仪采集浸入海水期间车体的动态电位,绘制时间-电位（t-E）曲线图,并分析数据;采用扫描电镜（SEM）和X射线衍射（XRD）等方法对牺牲阳极试样表面腐蚀形貌及成分进行了分析。结果发现,Al-Zn-In-Mg-Ti牺牲阳极增加了车体电位的稳定性,使车体电位部分极化到-800 mV;车体电位达到平衡的时间为7 min,加速了车体电位达到平衡的时间;Al-Zn-In-Mg-Ti牺牲阳极腐蚀产物在表面形成致密氧化层,并在干湿交替的作用下形成龟裂的裂纹,阻止了牺牲阳极的进一步反应。     

Electrochemical inactivation of cyanobacteria and microcystin degradation using a boron-doped diamond anode——A potential tool for cyanobacterial bloom control

Cyanobacterial blooms are global phenomena that can occur in calm and nutrient-rich(eutrophic) fresh and marine waters. Human exposure to cyanobacteria and their biologically active products is possible during water sports and various water activities, or by ingestion of contaminated water. Although the vast majority of harmful cyanobacterial products are confined to the interior of the cells, these are eventually released into the surrounding water following natural or artificially induced cell death. Electrochemical oxidation has been used here to damage cyanobacteria to halt their proliferation, and for microcystin degradation under in-vitro conditions. Partially spent Jaworski growth medium with no addition of supporting electrolytes was used. Electrochemical treatment resulted in the cyanobacterial loss of cell-buoyancy regulation, cell proliferation arrest, and eventual cell death. Microcystin degradation was studied separately in two basic modes of treatment: batch-wise flow, and constant flow, for electrolytic-cell exposure. Batch-wise exposure simulates treatment under environmental conditions, while constant flow is more appropriate for the study of boron-doped diamond electrode efficacy under laboratory conditions. The effectiveness of microcystin degradation was established using high-performance liquid chromatography–photodiode array detector analysis, while the biological activities of the products were estimated using a colorimetric protein phosphatase-1 inhibition assay. The results indicate potential for the application of electro-oxidation methods for the control of bloom events by taking advantage of specific intrinsic ecological characteristics of bloom-forming cyanobacteria. The applicability of the use of boron-doped diamond electrodes in remediation of water exposed to cyanobacteria bloom events is discussed.     

活性碳纤维修饰PbO2电极的制备及其对阿莫西林的降解解毒研究

采用电沉积法将活性碳纤维（ACF）修饰于PbO₂阳极表面，通过扫描电镜（SEM）、X射线衍射仪（XRD）、电化学工作站等对其进行表征分析与优选.并以优选电极对典型抗生素阿莫西林（AMX）进行电催化降解，同时探究AMX在电催化过程中的降解效果与毒性演变规律.结果表明，ACF以"镶嵌"的方式被修饰于电极表层，且修饰后的电极析氧过电位、电荷传输速率、产·OH速率、稳定性等均有所提高.电催化降解结果显示，经120 min电催化处理，AMX去除率和矿化率分别达到70.69%、58.61%.基因毒理学测试结果表明，AMX毒性水平随电催化降解时间延长呈逐渐下降趋势，转录效应指数TELI_total数值由最初的1.96降至1.72.同时AMX经电催化处理后氧化应激、膜应激与一般应激表达均由强烈转为温和.     

Degradation of 2,4-dichlorophenol with a novel TiO2/Ti-Fe-graphite felt photoelectrocatalytic oxidation process

Degradation of 2,4-dichlorophenol(2,4-DCP)was studied in a novel three-electrode photoelectrocatalytic(PEC)integrative oxidation process,and the factors influencing the degradation rate,such as applied current,flow speed of O_2,pH,adscititious voltage and initial 2,4-DCP concentration were investigated and optimized.H_2O_2 was produced nearby cathode and Fe~(2 )continuously generated from Fe anode in solution when current and O_2 were applied,so,main reactions,H_2O_2-assisted TiO_2 PEC oxidation and E-Fenton reaction,occurred during degradation of 2,4-DCP in this integrative system.The degradation ratio of 2,4-DCP was 93% in this integrative oxidation process,while it was only 31% in E-Fenton process and 46% in H_2O_2-assisted TiO_2 PEC process.So,it revealed that the degradation of 2,4-DCP was improved greatly by photoelectrical cooperation effect.By the investigation of pH,it showed that this integrative process could work well in a wide pH range from pH 3 to pH 9.     

石墨极板电氧化法处理靛蓝染料废水初步研究

采用惰性材料石墨为阳极的电氧化法处理靛蓝染料废水。研究了进水浓度、不同电解质的作用对处理效果的影响，获得了COD去除率大于90％、色度去除率大于95％的处理效果。     

铝合金牺牲阳极材料的研究进展

论述了铝合金牺牲阳极材料的发展历程,阐述了适用于不用环境的铝合金牺牲阳极研发情况,综述了铝合金牺牲阳极的几种活化溶解理论,对影响阳极电化学性能的因素进行了探讨,分析了铝合金牺牲阳极材料技术目前存在的问题,并展望了铝合金牺牲阳极未来的发展方向。常规海水环境的牺牲阳极材料已发展得较为成熟,特殊工况环境的牺牲阳极尚有待进一步开发和完善。     

外加电流阴极保护中深井阳极的布置

针对某输油管道工程,为保障阴极保护效果的同时,减少阴极保护对周边金属构筑物产生直流杂散电流的干扰。结合现有相关标准规范以及阴极保护干扰的产生机理,对深井阳极的布置位置和阴极保护方案进行对比分析。由于该工程输油管道将分输库整体包围,如库外长输管道全部采取外加电流的阴极保护形式,无论阳极井如何布置,阴极保护电流均有可能对分输库内储罐等金属构筑物产生杂散电流干扰,此时阳极井的位置需从施工、维护、保护电流的发散以及投资等方面比选确定。为了实现外输管道得到有效保护,且最大程度减小阴极保护电流对分输库内储罐等金属构筑物的干扰,可采取对由分支点进出库区的成品油管道与干线绝缘,并对该部分管道施加牺牲阳极保护的形式。