Polarity effect of pulsed corona discharge for the oxidation of gaseous elemental mercury

The effect of polarity on the oxidation of Hg⁰ was examined in the presence of O₂ via a pulsed corona discharge (PCD). The experimental result showed no difference in the energy yield of Hg⁰ oxidation at both positive and negative PCDs (∼8 μg Hg W h⁻¹ at following conditions: total flow rate = 2 L min⁻¹ (Hg⁰ = 50 μg N m⁻³, O₂ = 10%, and N₂ balance), temperature = 150 °C, and specific energy density = 5-15 W h N m⁻³). This suggests that the positive PCD process used to control gaseous air pollutants may play an essential key role in Hg⁰ oxidation because it consumes enough energy (∼15 W h N m⁻³) but an electrical precipitator could not because it consumes less energy (∼0.3 W h N m⁻³) to oxidize Hg⁰.     

Contamination of nonylphenolic compounds in creek water, wastewater treatment plant effluents, and sediments from Lake Shihwa and vicinity, Korea: comparison with fecal pollution

Nonylphenolic compounds (NPs), coprostanol (COP), and cholestanol, major contaminants in industrial and domestic wastewaters, were analyzed in creek water, wastewater treatment plant (WWTP) effluent, and sediment samples from artificial Lake Shihwa and its vicinity, one of the most industrialized regions in Korea. We also determined mass discharge of NPs and COP, a fecal sterol, into the lake, to understand the linkage between discharge and sediment contamination. Total NP (the sum of nonylphenol, and nonylphenol mono- and di-ethoxylates) were 0.32-875 μg L⁻¹ in creeks, 0.61-87.0 μg L⁻¹ in WWTP effluents, and 29.3-230 μg g⁻¹ TOC in sediments. Concentrations of COP were 0.09-19.0 μg L⁻¹ in creeks, 0.11-44.0 μg L⁻¹ in WWTP effluents, and 2.51-438 μg g⁻¹ TOC in sediments. The spatial distributions of NPs in creeks and sediments from the inshore region were different from those of COP, suggesting that Lake Shihwa contamination patterns from industrial effluents differ from those from domestic effluents. The mass discharge from the combined outfall of the WWTPs, located in the offshore region, was 2.27 kg d⁻¹ for NPs and 1.00 kg d⁻¹ for COP, accounting for 91% and 95% of the total discharge into Lake Shihwa, respectively. The highest concentrations of NPs and COP in sediments were found in samples at sites near the submarine outfall of the WWTPs, indicating that the submarine outfall is an important point source of wastewater pollution in Lake Shihwa.     

低温等离子体氧化水中难降解有机物研究

实验将介质阻挡放电与电晕放电组合在同一个反应器内,实验废水为直接大红染料溶液,将高压电极上通人50 Hz交流高压电,介质阻挡放电系统的电极间距为30 mm、电晕放电系统电极间距为25 mm、电源电压20 kV,利用常压空气中形成的雾化水电极介质阻挡放电/电晕放电低温等离子体及其活性基团作用于难降解有机物分子.实验分析了...     

高压脉冲放电等离子体处理活性红X-3B染料废水

采用高压脉冲放电等离子体技术对活性红X-3B染料废水进行处理,考察了废水电导率、脉冲电压、脉冲频率、针板间距以及曝气量对处理效果的影响。实验结果表明,当废水电导率为200μS/cm、脉冲电压为34kV、脉冲频率为60Hz、针板间距为15mm、曝气量为12L/h、处理时间为60m in时,活性红X-3B染料废水脱色率能达到98.6%。     

静电激发型袋除尘器的机理及应用前景

静电激发型袋除尘器有别于常规的电袋结合除尘器,其是将电除尘器的预荷电原理作用于烟气后,利用袋除尘器的滤袋做收尘极板来收集粉尘。本文通过分析Max-9^TMESFF的结构介绍了其除尘机理,并分析了它的应用前景。     

Sensitivity and Uncertainty of Ground‐Water Discharge Estimates for Semiarid Shrublands1

Abstract: We proposed a step‐by‐step approach to quantify the sensitivity of ground‐water discharge by evapotranspiration (ET) to three categories of independent input variables. To illustrate the approach, we adopt a basic ground‐water discharge estimation model, in which the volume of ground water lost to ET was computed as the product of the ground‐water discharge rate and the associated area. The ground‐water discharge rate was assumed to equal the ET rate minus local precipitation. The objective of this study is to outline a step‐by‐step procedure to quantify the contributions from individual independent variable uncertainties to the uncertainty of total ground‐water discharge estimates; the independent variables include ET rates of individual ET units, areas associated with the ET units, and precipitation in each subbasin. The specific goal is to guide future characterization efforts by better targeting data collection for those variables most responsible for uncertainty in ground‐water discharge estimates. The influential independent variables to be included in the sensitivity analysis are first selected based on the physical characteristics and model structure. Both regression coefficients and standardized regression coefficients for the selected independent variables are calculated using the results from sampling‐based Monte Carlo simulations. Results illustrate that, while as many as 630 independent variables potentially contribute to the calculation of the total annual ground‐water discharge for the case study area, a selection of seven independent variables could be used to develop an accurate regression model, accounting for more than 96% of the total variance in ground‐water discharge. Results indicate that the variability of ET rate for moderately dense desert shrubland contributes to about 75% of the variance in the total ground‐water discharge estimates. These results point to a need to better quantify ET rates for moderately dense shrubland to reduce overall uncertainty in estimates of ground‐water discharge. While the approach proposed here uses a basic ground‐water discharge model taken from an earlier study, the procedure of quantifying uncertainty and sensitivity can be generalized to handle other types of environmental models involving large numbers of independent variables.     

Modeling Postfire Response and Recovery using the Hydrologic Engineering Center Hydrologic Modeling System (HEC‐HMS)1

Abstract: This paper investigates application of the Army Corps of Engineers’ Hydrologic Engineering Center Hydrologic Modeling System (HEC‐HMS) to a burned watershed in San Bernardino County, California. We evaluate the HEC‐HMS’ ability to simulate discharge in prefire and postfire conditions in a semi arid watershed and the necessary parameterizations for modeling hydrologic response during the immediate, and subsequent recovery, period after a wildfire. The model is applied to City Creek watershed, which was 90% burned during the Old Fire of October 2003. An optimal spatial resolution for the HEC‐HMS model was chosen based on an initial sensitivity analysis of subbasin configurations and related model performance. Five prefire storms were calibrated for the selected model resolution, defining a set of parameters that reasonably simulate prefire conditions. Six postfire storms, two from each of the following rainy (winter) seasons were then selected to simulate postfire response and evaluate relative changes in parameter values and model behavior. There were clear trends in the postfire parameters [initial abstractions (I_a), curve number (CN), and lag time] that reveal significant (and expected) changes in watershed behavior. CN returns to prefire (baseline) values by the end of Year 2, while I_a approaches baseline by the end of the third rainy season. However, lag time remains significantly lower than prefire values throughout the three‐year study period. Our results indicate that recovery of soil conditions and related runoff response is not entirely evidenced by the end of the study period (three rainy seasons postfire). Understanding the evolution of the land surface and related hydrologic properties during the highly dynamic postfire period, and accounting for these changes in model parameterizations, will allow for more accurate and reliable discharge simulations in both the immediate, and subsequent, rainy seasons following fire.     

微波辅助光催化降解高浓度活性黑

利用改装的家用微波炉、微波无极灯和TiO2催化剂研究了水中高浓度活性黑的光催化降解.系统考察了TiO2投加量、pH、微波无极灯数量对微波辅助光催化处理效果的影响,得出微波辅助光催化的最佳操作条件,并在最佳条件下对活性黑的脱色及矿化效果进行研究.结果表明,TiO2投加量存在最佳值2 g/L,降低pH和增加微波无极灯数量均可提高活性黑的降解率.在TiO2的投加量为2 g/L,pH =3,微波无极灯数量为3的最佳光催化条件下,400 mg/L的活性黑溶液反应180 min时可实现完全脱色,反应300 min时,TOC去除率高达89.1％.     

新疆油田抽汲排液污染控制研究

抽汲排液存在抽汲设备和工具密封性差,对井场环境污染比较严重的问题,为解决抽汲排液对井场造成的污染,分别对抽汲钢丝绳的选择、试油井口防喷盒的密封以及试油抽汲作业规程及其它方面作了研究和应用,使抽汲排液对井场造成的污染得到了较好控制,符合新疆油田创建"绿色油气田"的要求。     

稠油污水回用锅炉处理工艺的应用

新疆油田公司稠油污水处理普遍采用成熟的离子调整旋流反应水处理技术,污水处理后达到回用锅炉水质标准SY/T 0097-2000《稠油油田采出水用于蒸汽发生器给水处理设计规范》,供给油田专用高压注汽锅炉用水。采用相同技术建成的采油一厂稠油处理站污水回用锅炉处理工艺投用后,处理后污水回用锅炉,减少了含油污水的外排,充分利用了稠油污水的热能,取得了良好的经济和社会效益。