强磁场影响下菌株B1对染料的脱色作用

从校园土壤中筛选出一株对人工合成染料酸性红B有一定脱色能力的菌株B1(芽孢杆菌属),经过6.0、8.0、8.0T的强磁场分别作用30、15、30 min后进行了脱色试验;根据实验数据,得到染料脱色模型.结果表明,强磁场对B1具有诱变作用,能使其脱色能力得到强化.     

生物表面活性剂产生菌犁头霉菌(Absidia orchidis)的筛选及发酵条件优化

采用植物油为唯一碳源,设计选择培养基,从饭店下水道污泥中筛选出生物表面活性剂产生菌.结果分离到12株菌,其中一株能使发酵液的表面张力值从68 mN·m-1降低到34.5 mN·m-1,具有开发潜力,被选出作进一步的研究.该菌株经鉴定为犁头霉菌(Absidia orchidis).通过正交试验对犁头霉菌的培养条件进行优化,其优化培养条件为:植物油3.6 g·L-1,KH2PO412.1 g·L-1,Na2HPO45 g·L-1,(NH4)2SO4 1 g·L-1,NaNO32 g·L-1,酵母浸膏0.1 g·L-1,MgSO4·7H2O 0.15 g·L-1,NaCl 5 g·L-1,CaCl2 0.1 g·L-1,EDTA 1 g·L-1,KI 0.83μg·L-1,H3PO4 0.01μg·L-1,CoCl2·6H2O 0.048μg·L-1,MnSO4·H2O 0.312μg·L-1,Na2 MoO4·2H2O 0.048μg·L-1,ZnCl2 0.287μg·L-1,CuSO4·5H2O 0.125μg·L-1,初始pH值8,接种量6%.发酵70h时可获得生物表面活性剂的最大收获量,此时发酵液中生物表面活性剂的相对浓度达402倍.     

Process of rice straw degradation and dynamic trend of pH by the microbial community MC1

The process of the rice straw degradation in the fermentor with aeration at 290 ml/h was studied. The results of dissolved oxygen （DO） indicated that the optimum DO during cellulose degradation by microbial community MC1 ranged from 0.01 to 0.12 mg/L. The change model ofpH values was as follows： irrespective of the initial pH of the medium, pH values decreased rapidly to approximate 6.0 after being inoculated within 48 h when cellulose was strongly degraded, and then increased slowly to 8.0--9.0 until cellulose was degraded completely. During the degradation process, 15 kinds of organic compounds were checked out by GC-MS. Most of them were organic acids. Quantity analysis was carried out, and the maximum content compound was ethyl acetate which reached 13.56 g/L on the day 4. The cellulose degradation quantity and ratio analyses showed that less quantity （under batch fermentation conditions） and longer interval （under semi-fermentation conditions） of rice straw added to fermentation system were contributed to matching the change model of pH, and increasing the quantity and ratio of rice straw degradation during cellulose degrading process. The highest degradation ratio was observed under the condition office straw added one time every five days （under semi-fermentation conditions）.     

我国近岸海域微生物源示踪监测技术的研发

通过对我国近岸海域陆源性非点源污染污染贡献率及其危害性剧增现状的分析,强调了在我国开展污染源示踪检测技术研发的必要性。在总结了国外治理非点源污染的经验———微生物源示踪技术研究和应用现状的基础上,介绍了我国近岸海域微生物源示踪检测技术研发的设计思想。从而阐明,传统的环境监测指标和方法已不能满足发展的需要,集监测、溯源和示踪为一体,适应于我国国情的近岸海域非点源污染源监测技术的研发势在必行。     

Monitoring of a Coastal Mediterranean Area: Culturable Bacteria, Phytoplankton, Environmental Factors and their Relationships in the Southern Adriatic Sea

Culturable heterotrophic bacterial and phytoplanktonic densities were investigated at four sites in the Southern Adriatic Sea (Brindisi, S. Cataldo, Otranto and S. M. di Leuca) over an annual cycle. The main phytoplankton groups, the bacterial biodiversity, as well as the faecal contamination indicators were determined. Culturable bacterial numbers averaged 4.8 ± 0.2 log CFU ml⁻¹ whereas phytoplankton numbers averaged 2.1 ± 0.4 log cells ml⁻¹. Relationships between culturable bacteria, phytoplankton and the environmental factors were established. Bacterial and phytoplankton densities usually depended significantly on temperature, dissolved oxygen, phosphate and nitrite only in the S. Cataldo transect. In all the examined transects phytoplankton showed a bloom during the January–February period followed by a bacterial peak during the February–March period. Thus we can suppose that the phytoplankton winter bloom is responsible for the availabily of organic matter for bacterial populations in the following months in this oligotrophic ecosystem.     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

莱特生物强化技术处理高浓度有机废水的中试

采用莱特生物强化技术(LTBR—Littoral BioReactor),对兰州石化公司化工园区高浓度有机废水进行了中试试验,进行了正常运行的常规标定、水量冲击标定、浓度冲击标定。结果表明:采用LTBR生物处理工艺,使用特效微生物和营养基质,可以在高COD、高含盐等不利条件下正常进行有机物降解,达到了必须将废水中的COD降至2000mg/L以下的试验要求,为处理高浓度有机化工废水的工程应用开辟了新思路。     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

抗铬菌株的筛选鉴定及其生物学特性和吸附特性

利用微生物分离纯化技术,在培养基中加入不同浓度的Cr3+、Cr6+,经过长时间驯化,从污染土壤中筛选出2株对Cr具有较高抗性的菌株(A和B),对其进行了形态、生理生化特性及分子生物学鉴定,并研究了其最佳生长条件及对Cr3+的生物吸附规律。结果表明,菌株A和B分别为蜡状芽孢杆菌(Bacillus cereus)和米根霉菌(Rhizopus oryzae)。菌株A和B的最适生长pH值均为7,最适生长温度均为30℃,最佳装液量为80~100 mL(250 mL摇瓶)。在培养时间一定时,随着Cr3+浓度的增加,菌株对Cr3+的吸附率减少,而生物吸附量则逐渐增大;在Cr3+浓度一定时,随着培养时间的延长,菌体对Cr3+的吸附率呈现出先增加后减少的趋势,这与生物吸附量的变化趋势基本一致。在Cr3+浓度为100 mg/L时,菌株A和B对Cr3+的吸附率达到最大,分别为51.47%和46.36%。     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。