新型PEI/PAA复合正渗透膜的制备及性能表征

采用聚乙烯亚胺(PEI)和聚丙烯酸(PAA)分别作为聚阴阳电解质,间苯二胺(MPD)与均苯三甲酰氯(TMC)分别为水相和油相单体,依次采用层层自组装(LBL)和界面聚合的方法对聚丙烯腈(PAN)基膜进行改性,探究层层自组装和界面聚合条件对膜性能的影响,并制备新型复合正渗透膜.得出最佳制备条件为:PAA与PEI的沉积时间为10 min,浓度为1 g·L~(-1),pH分别为9和3,支撑盐浓度为1.5 mol·L~(-1),MPD浓度为20 g·L~(-1),水相沉积时间为2 min,TMC浓度为1 g·L~(-1),界面聚合反应时间为60 s,聚电解质层数为2层,在此条件下制得的复合正渗透膜性能优良.以去离子水作为原液,1 mol·L~(-1) NaCl作为汲取液,水通量最高可达26.12 L·m~(-2)·h~(-1),反向盐通量为13.08 g·m~(-2)·h~(-1),与基膜相比,复合膜的亲水性能明显提高,抗污染性能提高,为正渗透膜的制备提供了新的方法和思路.     

纳米Bi_2O_3-Ni_2O_3的制备及光催化性能研究

采用微乳法制备了镍、铋复合氧化物纳米粒子,以XRD、TG-DTA、XPS及紫外-可见光谱仪对合成材料进行了表征,并以甲苯为目标污染物对其气-固复相光催化性能进行了研究。结果表明:Ni和Bi都显+3价,XRD曲线上分别出现Ni2O3和Bi2O3的特征衍射峰,制备样品是Ni2O3与Bi2O3复合氧化物,对于单一Bi2O3,制备的复合氧化物由于Ni2O3具有较强的电子富集能力,能够快速地传递光照射产生的电子,导致光生电子与空穴分离效率大大提高,促进了氧化反应,显示出了较好的光催化活性。     

Products of laccase catalyzed reaction of 1-hydroxypyrene

The formation of residues in soils and sediments which are not readily extractable is an important fate for hydrophobic organic contaminants. Reaction of 1-hydroxypyrene, a known fungal and terrestrial invertebrate metabolite and photo-oxidation product of pyrene, with a commercially prepared laccase (an oxidoreductive enzyme) in solution provides a test system to study the fate of residues in nature. The reaction of dissolved 1-hydroxypyrene with laccase produced a distinct color change and caused a precipitate to form. At least six products were shown by HPLC analysis with photodiode array detection. The most prominent peak was composed of 1,6- and 1,8-pyrene-dione as confirmed by proton NMR analysis. LC/MS data on remaining peaks indicate that radical coupling produces acetonitrile soluble dimers and at least one trimer. Proposed structures consistent with MS and photodiode array data indicate that pyrene subunits are linked predominantly by ether bonds. Additional products, insoluble in acetonitrile, were also formed. The formation of complex products in vitro, indicates that the same mechanisms could produce bound residues in soil.     

Photodegradation of an azo dye by silver-doped nano-particulate titanium dioxide

The synthesis of silver doped nano-particulate titanium dioxide (Ag/TiO₂) using a microemulsion method and an investigation of its photocatalytic activity for the degradation of Acid Red 27 in distilled water under UV-irradiation is reported. The prepared Ag/TiO₂ is characterized using transmission electron microscopy, X-ray diffraction, and energy-dispersive X-ray spectroscopy. The size of the Ag nanoparticles is around 5–15?nm, with almost uniform distribution on the TiO₂ particles. The efficiency of the photocatalytic process is evaluated to establish the optimum conditions, found to be at 2?wt% of Ag loading on TiO₂, catalyst dosage of 400?mg?L^?1, and calcination temperature of 300°C. Complete decolorization of the dye solution on Ag/TiO₂ was observed in 20?min of UV irradiation in the optimum conditions.     

道化学火灾、爆炸危险指数法在1,3丁二烯聚合安全性评价中的应用

道化学火灾、爆炸危险指数法是在化工领域中广泛应用的一种评价方法,根据该法制定的指数选取规则,可对工艺单元火灾爆炸危险性进行量化和分级.以某化工厂3000t/a三聚体生产项目为背景,从工艺过程、危险物质、安全设施设计等方面,对1,3丁二烯聚合过程火灾、爆炸危险性进行分析;定量评价工艺装置及所含物料潜在危险性,得出主装置区、储罐区固有危险等级,分析不同状态下安全补偿系数对降低危险等级的影响,提出相应安全对策措施.     

阳离子型聚丙烯酰胺絮凝剂的开发与煤气化黑水处理

煤气化过程产生的黑水通常采用絮凝处理去除悬浮物及部分有机物后循环使用。以丙烯酰氧乙基三甲基氯化铵为阳离子单体,以氧化还原类和偶氮类引发剂为复合引发剂,采用水溶液自由基共聚法制备了一种适用于黑水絮凝处理的阳离子型聚丙烯酰胺。实验结果表明：引发温度为15~20 ℃时,聚合反应较为平稳,1 h后聚合反应结束,于60~80 ℃干燥,得到产品相对分子质量较高,达（734~1 086）×10⁴;采用该絮凝剂絮凝处理黑水时,絮体大、沉降速率快,絮凝沉降效果佳;在煤气化装置黑水工况温度下,絮凝剂投加量为3 mg/L时,黑水中悬浮物质量浓度可从114 mg/L降至30 mg/L以下,满足现场使用要求。     

聚丙烯工业废水排放的治理措施

在利用间歇式液相本体法工艺生产聚丙烯时,易产生大量废水,包括闪蒸水环真空泵排放水、聚合釜轴封冷却水排放水、聚合升温用热水罐溢流水等。应最大限度地减少废水的排放量。已经采取的废水减排措施包括:对于真空泵逐渐调小供水量(即减少了排放量);将轴封冷却水收回重复利用;维持热水罐的水位稳定,避免产生溢流。采取上述措施在满足生产要求的同时,最大限度地减少了废水排放量。     

Biosynthesis of poly-(R)-3-hydroxyalkanoate: An emulsion polymerization

Poly-(R)-3-hydroxyalkanoates (PHAs) are bacterial storage polyesters, which are accumulated by a wide variety of microorganisms as a reserve of carbon and energy. Currently, these biopolymers are receiving much attention because of their potential application as biodegradable and biocompatible plastics. The polymer appears as submicron intracellular granules. The biosynthesis of these granules has been studied extensively but many observations remain inexplicable. This paper draws an analogy between the process of emulsion polymerization and that of granule formation. This analogy may explain many of the unknown features of granule formation and may also lead to useful applications of granules as latex products.     

白腐菌漆酶催化聚合造纸废水中木素的研究

为了证实漆酶对从造纸厂二沉池出水提取出的木素的催化聚合作用,研究了白腐菌采绒革盖菌Coriolus versicolor漆酶对木素聚合的影响。在有氧条件下,通过添加漆酶和少量ABTS介体到水样中,用紫外分光光度计测定了其中木素浓度变化,利用凝胶色谱法分析了酶催化聚合木素前后的分子量的变化。结果表明:酶处理6h以后,废水中木素浓度从93.1mg/L下降到17.2mg/L。酶处理2h以后,从造纸厂污水分离的木素的分子量从31251上升到58610。造纸废水中木素及其衍生物被聚合后通过絮凝沉淀除去,从而实现废水色度与COD降低,进而为造纸废水回用提供可能。     

一种船舶自修复防腐涂料的制备与表征

以脲醛树脂为囊壁、复合环氧树脂为囊芯,采用原位聚合法成功合成了脲醛树脂包覆环氧树脂体系微胶囊。采用扫描电子显微镜观察微胶囊的表面形貌,测量微胶囊的壁厚;利用红外光谱分析判定微胶囊壁材是否形成,芯材是否被完整包覆。结果表明,应用一步原位聚合法可以制备包覆完整、均匀分散、含有特殊芯材的微胶囊。合成的微胶囊形状基本呈球形,粒径分布均匀,平均粒径约为100μm;胶囊表面粗糙致密,粗糙表面主要是由纳米微胶囊沉积而成。微胶囊表面粗糙度的增加有利于增加微胶囊与基体的接触面积,改善微胶囊与基体的界面粘结力,从而提高自修复材料的修复效率。