超高盐高磷废水磷酸盐还原系统构建过程中磷系统转化分析研究

针对现有除磷技术存在的问题,以高盐高磷榨菜腌制废水为研究对象,探讨了磷酸盐生物还原系统构建过程中磷形态的转化.结果表明,以3%的盐度(以NaCl计,下同)废水启动反应器,通过两阶段盐度逐步提升法,在进水有机负荷(COD)0.45kg.(m3.d)-1,磷负荷(PO43--P)5.0 g.(m3.d)-1,DO 6 mg.L-1,水温30℃,且未排泥的条件下,成功构建了超高盐(7%盐度)条件下的磷酸盐还原系统.通过该磷酸盐还原系统运行26个周期中,对磷平衡及污泥中磷形态转化进行研究.结果表明,系统中平均每日有41.8 mg.L-1的外源磷损失,而污泥中共有155 mg的内源磷通过磷形态转化以及磷酸盐还原途径损失,占外源磷损失量的14.2%,占系统磷损失总量的12.5%.系统构建过程中污泥的磷形态主要以Org-P→NaOH85-P→HCl-P→NaOH-P→BD-P→H2O-P途径进行转化.     

新时期医疗废物处置技术体系的变革及发展

近20年来,我国在推进医疗废物无害化管理和处理处置方面开展了大量的工作,成绩举世瞩目。但处于新的历史时期,如何更好地基于可行技术,探索与其相匹配的管理模式,解决医疗废物处理处置短板已成为迫在眉睫的工作。我国目前存在针对医疗废物处理处置技术适用性考虑不足、农村及偏远地区医疗废物处置能力缺乏、医疗废物应急处置能力存在短板以及医疗废物领域科技创新能力有待提升等问题。因此,结合各种医疗处置技术特点及适用性,提出基于技术的适用性推进医疗废物处理处置技术布局优化、通过管理和技术进步解决农村和边远地区医疗废物处置难题、合理配置疫情期间应急处置能力以及推进科技创新等建议,为打造新时期医疗废物处理处置技术体系提供参考。     

热水洗辅助微生物修复高含油落地油泥

为解决油田落地油泥含油率高但不能直接进行生物无害化处置的问题,探索一种热水洗辅助微生物修复工艺。利用热水洗实验考察了清洗配方和水温对降低含油率的影响;从落地油泥中分离出石油烃降解菌,以用于含油残砂的微生物降解过程,同时探究填料和烃降解微生物对残砂中石油烃降解效果的影响。结果表明,鼠李糖脂清洗剂在总用量为0.5%、水洗时间30 min和50 ℃条件下,可将油泥含油率由107.1 mg·g⁻¹降至为39.3 mg·g⁻¹;水洗后残砂中的土著菌群数量出现了明显下降。分离获得了2株烃降解菌,并优选出具有增加油泥溶氧和保水的沼渣。将烃降解微生物和优选沼渣加入残砂后,石油烃生物降解效率得到显著提升,200 d后含油率降为4.62 mg·g⁻¹。在此过程中,微生物优先降解分子量小的饱和烃和芳香烃组分,对胶质和沥青质等组分降解程度偏低。该研究结果可为油田高含油落地油泥的环保处置提供参考。     

基于Bishop条分法的多点多向地震动作用下边坡稳定性分析

以人工合成的多点、多向地震加速度时程作为地震动输入,基于Bishop条分法推导了地震边坡稳定安全系数的表达公式。在此基础上,针对某一具体算例,分析了不同地震峰值加速度下的不同坡高边坡稳定安全系数的变化规律,并与单点、单向地震动输入的结果进行了对比。结果表明,对于本文给出的算例,在坡高与地震峰值加速度都相同的条件下,多点、多向地震作用下的边坡安全系数要大于单点、单向作用下的安全系数;当坡高小于30 m、地震峰值加速度小于0.1 g时,多点、多向地震动作用下的边坡安全系数与单点、单向相差不大;当坡高大于30 m、地震峰值加速度大于0.1 g时,多点、多向地震动作用下的边坡安全系数相对单点、单向要小36%以上,此时边坡稳定性评价必须考虑地震动的多点、多向特性。     

Isometric Pull and Push Strengths of Paraplegics in the Workspace: 2. Statistical Analysis of Spatial Factors

The effect of reach levels, horizontal angles, and vertical angles on isometric pull and push strengths of male and female was determined. Highly significant increases in men’s push strength were found between extreme to maximum reaches, and from extreme to normal reaches. However, for women’s push strength, a significant increase was found only between extreme to maximum reach. Significant or highly significant increases were found in men’s and women’s pull strength between the horizontal angle (θ) sagittal through the active shoulder (90°) and other angles (0, 45, and 135°). However, for men’s push strength, highly significant increases were found between the horizontal angle 45° from the frontal plane, and other angles. For women’s push strength, significant or highly significant increases were found between the horizontal angles 0° and angles of 90 and 135°. For men’s and women’s pull strength, significant or highly significant increases were found between the vertical angle (?), 90°, and other angles (–20, 0, and 45°). Similar increases were found for women’s push strength between the 45° angle and other angles. In the design of a workstation for paraplegics that requires pull and push forces, consideration must be given to the spatial factors.     

Occupational Accidents of Finnish-and Swedish-Speaking Workers in Finland: A Mental Model View

This article is based on 2 studies. The aim of the first study was to examine the differences in occupational accident frequency between the 2 main language groups in Finland. Based on 3 independent statistical data sets, it was shown that Swedish-speaking workers had about 40% fewer occupational accidents than Finnish-speaking workers. The aim of the second study was to confirm the difference at company level. A field study in the province of Vaasa with 14 small and medium-sized manufacturing companies revealed that the accident frequency of Swedish-speaking workers was 21% lower than that of Finnish-speaking workers.     

Validation of Methods for Determination of Metabolic Rate in the Edholm Scale and ISO 8996

The aim of this study was to validate the Edholm scale (Edholm, 1966) and the ISO 8996 standard (International Organization for Standardization [ISO], 1990) by comparing the metabolic rates estimated for both methods with the actual measured metabolic rate (M_Meas) in 6 manual material handling tasks simulated under laboratory conditions. The metabolic rate was calculated from oxygen consumption VO₂ (19 participants) according to Standard No. ISO 8996 (ISO, 1990). Additionally, the participants estimated perceived exertion using the Borg scale. The metabolic rates derived from the Edholm scale (M_Edh) overestimated 5 of 6 activities by 34-50% (α = .05). The metabolic rates derived from ISO 8996 (M_ISO) overestimated all activities by 7-38% (α =.05).     

Ergonomic Program Effectiveness: Ergonomic and Medical Intervention

The implementation of a successful ergonomic and medical intervention program designed to reduce the number and severity of injuries and illnesses and the associated levels of discomfort in the workplace is presented. Because of the recent activity concerning the on-again-off-again Occupational Safety and Health Administration (OSHA) Ergonomic Program Standard questions have been raised as to the value and effectiveness of an organization’s ergonomics program. In light of these concerns, the immense cost associated with work-related injury and illness, and the related pain and suffering associated with such injuries and illnesses, it is important to present a workable and effective ergonomic and medical intervention program. The results of this applied study demonstrate that through the application of an ergonomic and medical intervention program, workplace-related injuries and illnesses can be reduced or eliminated.     

Handheld-Assisted Field Data Collection for Occupational Risk Assessment

A computerized handheld procedure is presented in this paper. It is intended as a database complementary tool, to enhance prospective risk analysis in the field of occupational health. The Pendragon forms software (version 3.2) has been used to implement acquisition procedures on Personal Digital Assistants (PDAs) and to transfer data to a computer in an MS-Access format. The data acquisition strategy proposed relies on the risk assessment method practiced at the Institute of Occupational Health Sciences (IST). It involves the use of a systematic hazard list and semi-quantitative risk assessment scales. A set of 7 modular forms has been developed to cover the basic need of field audits. Despite the minor drawbacks observed, the results obtained so far show that handhelds are adequate to support field risk assessment and follow-up activities. Further improvements must still be made in order to increase the tool effectiveness and field adequacy.     

Safety Climate in Finnish- and Swedish-Speaking Companies

The aim of this study was to compare assessments made by Finnish- and Swedish-speaking workers in Finland about the safety climate in their companies, because an earlier study showed that the accident frequency of Swedish-speaking workers was one third lower than that of Finnish-speaking workers. 148 Finnish-speaking and 138 Swedish-speaking workers from 14 small and medium-sized companies participated in this study. They filled out a Finnish safety climate questionnaire, the reliability of which was above the acceptable level. There were no differences between the language groups in the total variables of safety climate and safety action. Based on the differences in single items, we interpreted that Swedish-speaking workers stressed collective safety more, whereas Finnish-speaking workers put more emphasis on their personal responsibility for safety.