Performance of photocatalytic lamps on reduction of culturable airborne microorganism concentration

Reduction of viable airborne Staphylococcus epidermidis and Aspergillus niger spore concentrations using two types of photocatalytic fluorescent lamps under controlled environmental conditions (25 vs. 35 °C and 55 vs. 75% relative humidity) were investigated. Visible white-light and UVA black light were in-house spray-coated with TiO₂ and then compared with a commercially coated visible white-light for microbial concentration reduction. The white-light photocatalytic lamps reduced the concentration of culturable S. epidermidis up to 92% independent of temperature or humidity change, while the black light photocatalytic lamps completely inactivated the culturable bacteria at 25 °C, 55% relative humidity. Humidity seemed to alleviate UVA damage since better bacteria survival was found. For A. niger spores, rising humidity or temperature could lower their concentration or drop their culturabilities so that a difference between the natural decay and photocatalytic disinfection could not be distinguished. Reductions of total bacteria and total fungi concentrations using these lamps were also examined under uncontrolled environmental conditions in an office and a waste-storage room. It was found that photocatalytic lamps could reduce total culturable bacteria concentration from 9 to 97% and total culturable fungi concentration from 3 to 95% within irradiation time of 30-480 min, respectively. Insignificant difference in concentration reduction among these photocatalytic lamps was pronounced.     

微波诱导催化技术在环境治理中的应用研究

微波诱导催化技术以其快速、高效和无二次污染等特点,日益受到环保研究者的重视。目前,微波诱导催化技术已在大气污染控制、水污染控制及固体废弃物处理与处置等环境治理领域取得了显著效果。阐述了微波诱导催化技术的基本原理、催化反应的催化剂和载体及催化反应的机制,归纳了微波诱导催化技术在环境治理中的应用现况及实例,分析了微波诱导催化技术在实际应用中存在的问题,并提出相应的解决措施,最后对微波诱导催化技术在环境治理领域中的进一步应用进行了展望。     

碱熔融—微波晶化法合成粉煤灰沸石及其对Cd2+的吸附

以粉煤灰为主要原料,采用碱熔融—微波晶化法合成粉煤灰沸石。采用XRD,SEM,TEM等技术表征了粉煤灰沸石的微观结构,并对其吸附Cd²⁺的性能进行了研究。表征结果显示,粉煤灰沸石主要由X型沸石、P型沸石和铝组成,粉煤灰沸石中有排列规则、呈蜂窝状的孔穴和孔道存在,其孔穴和孔道大小分布均匀,致密。粉煤灰沸石的比表面积为108.49 m²/g,平均孔径为3.779 nm,孔体积为0.221 mL/g。实验结果表明,在溶液pH为7、吸附时间30 min的最佳吸附条件下,Cd²⁺去除率均大于94%。粉煤灰沸石对Cd²⁺的吸附可很好地用二级动力学方程进行拟合,相关系数为0.999 99。可用Langmuir等温吸附模型描述该吸附过程,该吸附过程是单分子层吸附,主要是化学吸附,粉煤灰沸石对Cd²⁺的饱和吸附量为49.261 mg/g。     

微波消解石墨炉原子吸收法测定空气中的锰(铅)

本文介绍了用微波消解技术消解滤膜以测定空气中的锰（铅）的方法，与传统的稀硝酸浸出法、流酸-灰化法相比，微波消解更加简单、快速、节省、准确、沾污少、环境污染少，回收率高。     

微波消解法测定农药废水中的总磷

介绍了一种测定农药废水中总磷的新的预处理方法－微波消解法。其消解时间从传统法的40min缩短到8min，精确度和准确度与传统的消解法相比无显著性差异。     

微波技术在环境保护领域的应用

综述了当前微波技术在环境保护领域的应用和研究状况，着重介绍了微波技术在废气处理，废水处理，固体废弃物处理，环境监测等方面的应用，讨论了应用存在的一些问题，并展望了微波技术在环境保护领域的应用前景。     

污染治理中的微波诱导催化技术

归纳了微波诱导催化技术在大气羡染控制、水污染控制、固体废弃物处理与处置等污染治理中的应用状况及应用实例，阐述了微波诱导催化技术的基本原理，提出了微波诱导催化技术在实践应用环节中存在的问题及解决措施，展望了微波诱导催化技术在污染治理领域中的应用前景。     

微波消解法快速测定渗滤液化学需氧量

针对国标回流法测定化学需氧量消耗时间长,分析费用高等不足,研究了微波消解法测定垃圾渗滤液的试验方法.通过微波消解功率、消解时间、催化剂用量等试验,确定了微波消解测定渗滤液CODCr的最佳条件.该方法具有省时间、省试剂、准确度高等优点.     

微波消毒技术在医疗废物处理中的应用

本文通过对微波技术的调查,全面总结了医疗废物微波消毒系统的机理、设备组成、影响消毒效果的主要因素、设备的优越性和人体保护注意事项等。     

ESTIMATION OF SOIL MOISTURE WITH API ALGORITHMS AND MICROWAVE EMISSION1

Large area soil moisture estimations are required to describe input to cloud prediction models, rainfall distribution models, and global crop yield models. Satellite mounted microwave sensor systems that as yet can only detect moisture at the surface have been suggested as a means of acquiring large area estimates. Relations previously discovered between microwave emission at the 1.55 cm wavelength and surface moisture as represented by an antecedent precipitation index were used to provide a pseudo infiltration estimation. Infiltration estimates based on surface wetness on a daily basis were then used to calculate the soil moisture in the surface 0–23 cm of the soil by use of a modified antecedent precipitation index. Reasonably good results were obtained (R²= 0.7162) when predicted soil moisture for the surface 23 cm was compared to measured moisture. Where the technique was modified to use only an estimate of surface moisture each three days an R² value of 0.7116 resulted for the same data set. Correlations between predicted and actual soil moisture fall off rapidly for repeat observations more than three days apart. The algorithms developed in this study may be used over relatively flat agricultural lands to provide improved estimates of soil moisture to a depth greater than the depth of penetration for the sensor.