SO2在碳钢初期大气腐蚀中的作用

通过自建的模拟大气腐蚀系统,借助金相显微镜、扫描电镜(SEM/EDX)、X-射线衍射(XRD)和x-射线光电子能谱(XPS),研究了SO2对碳钢初期大气腐蚀行为的影响,并进一步用原子力显微镜从更微观的角度观察了在SO2环境中初期阶段腐蚀形貌变化.研究结果表明:在SO2污染大气环境中,随SO2浓度的升高碳钢腐蚀加快.在体积分数为5×10(-6)SO2的大气环境中,碳钢和耐候钢表面腐蚀主要以条状物生长,随着SO2浓度的升高,腐蚀产物的形貌发生改变,在体积分数为5×10(-5)SO2的大气环境中,条状锈和胞状锈同时生长.在锈层中S元素以FeSO4·4H2O的形式存在,腐蚀产物中还有γ-FeOOH.SO2在初期阶段加速了碳钢的腐蚀,降低了碳钢的耐蚀性.     

不同粘土矿物材料对Pb2+的吸附特征

探讨了在不同矿物投加量、不同振荡时间、不同Pb2 浓度、不同矿物颗粒细度和不同pH条件下,钠基膨润土、膨胀蛭石和沸石3种粘土矿物对Pb2 的吸附效果.结果表明:对于具有可膨胀层间的粘土矿物而言,其对溶液中Pb2 的吸附量不仅仅由单一的阳离子交换量所决定;Pb2 在矿物表面的吸附过程是个迅速的过程,矿物对Pb2 的吸附在10 min内即可完成;粘土矿物不同颗粒细度对Pb2 的去除率有所不同,但考虑到实际应用中的成本问题,并非颗粒越细越好;就试验所采用的3种粘土矿物而言,其对Pb2 的吸附效果是,钠基膨润土和沸石明显优于膨胀蛭石;较高的pH有助于粘土矿物对溶液中Pb2 的吸附,但考虑到实际操作的其他因素,不能把pH调得过高.     

H2S、NH3混合臭气在生物滴滤池中的净化研究

研究了生物滴滤塔净化含H2S与NH3臭气最佳的生态条件为:在温度为25 ℃、气体通气量为0.4 m3/h、营养盐喷淋量为8.0 L/h、入口H2S质量浓度712.80-948.80 mg/m3、入口NH3质量浓度422.20-795.40 mg/m3、pH值7.0-8.0之间的情况下,去除效率可达90%以上.生物滴滤塔在处理H2S和NH3混合气时,塔内pH值保持在6.5-8.5之间,此pH值对反应器中优势菌的生长繁殖不会造成太大影响,对处理效果影响不大,因此反应过程可不用对pH值进行调节,节约运行成本.     

纳米TiO2/CNTs复合材料的制备及其光学性质

TiO2在碳纳米管上的复合材料可以增加材料的光催化性能,已成为新的研究热点.本文采用低温液相法成功地合成了TiO2/CNTs复合材料,并用TEM、XRD和UV-vis对材料进行了表征,结果表明,TiO2很好地分散在CNTs上,具有显著的催化效果,有很好的应用前景.     

Distribution and persistence of carbaryl in some terrestrial and aquatic components of a forest environment

Abstract

An oil‐based formulation of carbaryl (1‐naphthyl N‐methyl‐carbamate) (Sevin‐2‐Oil) was applied twice by a fixed‐wing aircraft at a dosage rate of 280 g of A.I./ha/application to a coniferous forest near Allardville, New Brunswick. The highest concentrations of the chemical in fir foliage, litter and forest soil 1 h after application were respectively 4.20, 1.21 and 0.59 ppm (fresh weight). The residues dissipated rapidly and the DT50 values obtained from the depletion curves were 2.3 d for foliage and 1.5 d for litter and soil samples. Very low levels (<0.1 ppm) of carbaryl persisted in foliage and litter beyond the 10 d sampling period. The maximum residue level found in stream water was 0.314 ppm and more than 50% of it had dissipated within 1 h. Low but detectable levels (0.001 ppm) of the chemical persisted in water until the end of the 10 d sampling period. Sediment samples contained a maximum level of 0.04 ppm, which dissipated below the detection limit within 5 h. Brook trout and slimy sculpins captured in the stream 1 d after the spray contained on average about 0.04 ppm of carbaryl and none of it was found in 3 d postspray samples.     

Ozone-driven photocatalyzed degradation and mineralization of pesticide,Triclopyr by Au/TiO2

Triclopyr is a widely used pesticide which is non-biodegradable and enters aquatic systems. The ozone facilitated photocatalyzed degradation and mineralization of Triclopyr using Au-loaded titania as heterogeneous catalyst is reported. The oxidative degradation activity of the hazardous pesticide was investigated at pH 7.8 under varied reaction conditions, including in presence and absence of ozone, titania alone, in presence and absence of light and with different loadings of Au on support. Photocatalysis with 2% Au/TiO₂ in the presence of ozone yielded 100% degradation of Triclopyr in 2 h. The extent of degradation of pesticide and its mineralization were confirmed by GC-MS. For 10 mg/L of Triclopyr, 0.1 g/L of catalyst was found to be the optimum for mineralization. Results show that photocatalyzed ozonation with Au/TiO₂ as catalyst is a very effective for its removal. No leaching of Au was observed in triplicate runs. Catalyst was fully recoverable and reusable with no loss of activity.     

电解法处理含镍废水及纯镍的回收

采用电解回收法处理Ni2+含量为2g/L的废水,在阴极回收纯镍。研究了电解电流、极距、NH4Cl浓度、pH值等因素对Ni2+去除率、槽压、阴极能耗的影响,得出最优工艺参数为:温度20℃,电解时间20min时、电解电流300mA,极距15mm,NH4Cl浓度5g/L,pH值8.0,该条件下Ni2+去除率为96.926%,槽压16.21V,阴极能耗22.418kW.h/kg,在阴极可得到沉积6.45μm厚的镍板。     

高含盐水样中悬浮物的准确测定

通过理论分析和大量实验工作，找出了现行国家标准的悬浮物测定方法在测定高含盐污水时的不足之处，并且提出了准确的测定方法。新方法不仅能很好地反映水样的实际状况，而且可以推广应用于各种复杂水样的悬浮物的测定。     

CHEMICAL ANALYSIS OF CO2 REMOVAL IN TRAY AERATORS1

ABSTRACT: This paper presents a discussion of the chemistry of CO₂ removal in tray aerators, and different sets of equations that are applicable to several initial water chemical conditions are proposed. These chemical equations and a statistical model to predict the kinetic constant were tested with field data observed by other researchers in pilot units and in a full scale plant. The water temperature in their experiments was around 15°C.