不同养殖模式池塘沉降颗粒营养物质组成特征

2012年4~10月采用自制沉降颗粒收集装置收集主养草鱼和黄颡鱼池塘生态系统中沉降颗粒物,开展了颗粒物质的垂直沉降量以及沉降颗粒中碳氮磷等营养物质的组成及沉降通量的季节变化特征的研究。结果表明:养殖可以显著提高池塘颗粒物质的垂直沉降量,主养草鱼池塘中颗粒物质垂直沉降量显著高于主养黄颡鱼池塘(p0.01),且两种养殖模式池塘颗粒物质沉降量随着养殖时间推进有显著增加的趋势。主养草鱼的池塘中颗粒物质垂直沉降量在100.39~414.66g/(m2·d)之间变化,平均为224.46g/(m2·d),主养黄颡鱼池塘中沉降颗粒物质垂直沉降量在34.14~272.91g/(m2·d)之间变化,平均为155.18g/(m2·d)。两种养殖模式沉降颗粒的碳氮磷成分在养殖周期内的变化规律不明显但具有相似的变化趋势,主养黄颡鱼池塘沉降颗粒中TN、TC、TOC和TON的含量均比同时期主养草鱼高,且均随着养殖时间的推进,沉降颗粒中碳氮磷的总量呈增加趋势。两种养殖模式池塘沉降颗粒中的C/N比值与沉积物中的C/N比值较为接近,表明沉降颗粒与沉积物营养物质来源具有一定的相似性,同时养殖系统内养殖对象与其所处环境的相互依存和相互影响对颗粒物质的产生以及沉降具有重要作用。     

HNO_3在气相及SiO_2表面的紫外光解反应

利用紫外及红外吸收光谱等分析手段对365 nm光照下HNO3在气相与SiO2表面的光解反应进行了研究.考察了HNO3浓度、光照时间、相对湿度等条件对反应的影响.结果表明:随着HNO3浓度及光照时间的增加,光解产生的NO2和NO浓度均呈指数增加;无水汽情况下,400 Pa的HNO3光解45 min后,产生NO2及NO浓度比气相光解产生的分别高约3及1.7倍.HNO3光解产生的HONO的浓度随相对湿度的增加而呈线性增加,在SiO2颗粒物表面光解产生的NO2浓度随着相对湿度的增加而减少,而NO浓度则随之增大.400 Pa的HNO3光照45 min后,SiO2表面光解产生的HONO浓度是气相光解的3倍、SiO2表面暗反应的约30倍.     

Experimental and theoretical research on the inhibition performance of ethanol gasoline/air explosion by C6F12O

The safety issue of ethanol gasoline and the methods to control or weaken its explosion have attracted attention. To clarify the effect of C₆F₁₂O (perfluoro(2-methyl-3-pentanone)) on the explosion of ethanol gasoline-air mixtures and intrinsic mechanism, the explosion overpressure and flame propagation behavior under different equivalence ratios (φ = 0.6–0.8) and C₆F₁₂O concentrations (χ_inh = 0–4.0%) were experimentally obtained. The detailed inhibitor reaction process was also obtained by CHEMKIN based on a new assembly kinetic mechanism. The results show that the effects of C₆F₁₂O on the explosion characteristics of ethanol gasoline varied with χ_inh and φ. For rich flames, C₆F₁₂O is more effective than and heptafluoropropane (C₃HF₇) and nitrogen (N₂) in suppressing explosions; for lean and equivalence ratio flames, the addition of C₆F₁₂O may result in more severe explosions. The decrease in chemical reactivity is mainly because the mole fractions of OH and H radicals and the proportion of paths H radicals involved decrease after adding C₆F₁₂O, and R1500: CF₃COF + H = CF₃CO + HF, R965: CF₂:O + H = CF:O + HF, R863: CF₃ + H = CF₂ + HF are main suppressing reactions.     

Water quality modelling of the river Yamuna (India) using QUAL2E-UNCAS

This paper describes the utility of QUAL2E as a modelling package in the evaluation of a water quality improvement programme. In this study, QUAL2E was applied to determine the pollution loads in the river Yamuna during its course through the national capital territory of Delhi, India. The study aimed at examining the influence of different scenarios on river water quality. Four different pollution scenarios were analysed besides the 'business as usual' situation. The study revealed that it was necessary to treat the discharge from drains to the river Yamuna and diversion of a substantial load to the Agra canal for further treatment was also essential. It was also established through this study that maintaining a flow rate of more than 10 m(3)/s in the river could also help preserve the river's water quality. To clearly display the model outcomes and demarcate polluted zones in the river stretch, model results were interfaced with a Geographical Information System (GIS) to produce cartographic outputs. In addition, uncertainty analysis in the form of first-order error analysis and Monte Carlo analysis was performed, to realise the effect of each model parameter on DO and BOD predictions. The uncertainty analysis gave satisfactory results on simulated data.     

An integrated impact assessment and weighting methodology: evaluation of the environmental consequences of computer display technology substitution

Computer display technology is currently in a state of transition, as the traditional technology of cathode ray tubes is being replaced by liquid crystal display flat-panel technology. Technology substitution and process innovation require the evaluation of the trade-offs among environmental impact, cost, and engineering performance attributes. General impact assessment methodologies, decision analysis and management tools, and optimization methods commonly used in engineering cannot efficiently address the issues needed for such evaluation. The conventional Life Cycle Assessment (LCA) process often generates results that can be subject to multiple interpretations, although the advantages of the LCA concept and framework obtain wide recognition. In the present work, the LCA concept is integrated with Quality Function Deployment (QFD), a popular industrial quality management tool, which is used as the framework for the development of our integrated model. The problem of weighting is addressed by using pairwise comparison of stakeholder preferences. Thus, this paper presents a new integrated analytical approach, Integrated Industrial Ecology Function Deployment (I2-EFD), to assess the environmental behavior of alternative technologies in correlation with their performance and economic characteristics. Computer display technology is used as the case study to further develop our methodology through the modification and integration of various quality management tools (e.g., process mapping, prioritization matrix) and statistical methods (e.g., multi-attribute analysis, cluster analysis). Life cycle thinking provides the foundation for our methodology, as we utilize a published LCA report, which stopped at the characterization step, as our starting point. Further, we evaluate the validity and feasibility of our methodology by considering uncertainty and conducting sensitivity analysis.     

Bi2MoO6/纳米棒ZnO异质结对MB的可见光-压电协同降解性能研究

采用水热法合成了一系列不同负载率的Bi₂MoO₆/纳米棒ZnO复合光催化剂.通过XRD、FT-IR、SEM、TEM、XPS、UV-Vis、EPR和PL等分析技术对合成的样品进行表征.在光/超声波条件下,以亚甲基蓝（MB）为目标降解物评价其压电-光催化性能.结果表明：Bi₂MoO₆/ZnO纳米棒（BZ-0.6）的降解速率常数约为ZnO传统光催化的9.25倍,其性能提升的主要原因在于ZnO的压电效应与Bi₂MoO₆/ZnO界面形成的异质结的耦合,有效地促进了电子和空穴的分离和转移.此外,同实验条件下,循环利用5次后Bi₂MoO₆/ZnO复合光催化剂降解率仍保持良好的稳定性.     

g-C3N4/TiO2纳米管阵列光阳极的制备及其光电催化降解邻氯硝基苯

采用阳极氧化-涂覆煅烧法成功制备了g-C₃N₄/TiO₂纳米管阵列（g-C₃N₄/TNAs）光阳极,并通过扫描电镜、X射线衍射仪、X射线光电子能谱仪、紫外可见漫反射光谱仪、光致发光光谱仪和电化学工作站等表征分析了g-C₃N₄/TNAs光阳极的形貌、晶形结构、光学特性和光电化学性能.表征结果证实,g-C₃N₄的引入通过缩小禁带宽度扩宽了TNAs的可见光响应范围,提高了光电流密度和光生电子寿命,促进了光生电子和空穴的分离.g-C₃N₄/TNAs光阳极在光电催化体系内对邻氯硝基苯（o-CNB）的降解效率高于其在光催化和电催化体系中对o-CNB的降解效率,且具有良好的稳定性和可重复性.活性物质捕获实验、电子自旋共振测试和能带结构分析表明,g-C₃N₄/TNAs光阳极中TNAs和g-C₃N₄之间存在Z型异质结相互作用机制.在光电催化体系内降解o-CNB的主要活性物质是^?O₂^-、^?OH和光生空穴,而光生电子是次要的活性物质.     

不同施肥方式对东北旱田黑土nirK和nirS型反硝化细菌群落结构的影响及黑土保护建议

反硝化过程是土壤氮素循环的重要过程之一,与土壤氮肥损失和温室气体排放紧密相关。通过分析不同施肥方式对东北旱田黑土nirK型和nirS型反硝化细菌群落结构的影响及其与N₂O排放的关系,证实黑土中nirK型比nirS型反硝化细菌多样性丰富,且更易受土壤理化性质的影响。施入化肥会降低东北旱田黑土反硝化细菌多样性、N₂O释放量和土壤养分含量,而有机肥的施入虽然可提高土壤养分含量,但是也会显著增加土壤反硝化作用,存在潜在的负面环境效应。因此对黑土地的保护要积极推行种养结合,建立可循环农业体系;适当配施有机肥料,调节黑土微生物活力;大力完善相关制度,营造科学管理新规范,从而构建我国黑土保护的立体格局。     

焊接工艺多源散发的高温颗粒污染物扩散特性数值模拟

为探究热工艺过程产生的热气流作用下颗粒的迁移规律,基于气固两相离散粒子模型(DPM)对多源浮射流伴生的高温颗粒的扩散特性进行了数值研究,讨论了两相流运动过程中热气流与颗粒群的温度和速度的瞬时变化情况.结果表明,对于473K£T₀£673K的高温颗粒群,温度衰减趋势类似,颗粒群温度分布呈中心对称;当5μm£d_p£20μm时,颗粒与气流之间的跟随性随着粒径的增大而降低;热羽流随时间经历了独立发展和相互合并的过程,羽流之间涡旋结构的消失导致中心位污染源散发的d_p=10μm的颗粒更容易发生沉降.     

纳米零价铁耦合黏土修复污染土壤的研究进展

黏土负载型nZVI具有低成本、易制备、环境相容性好、综合性能优越的特点.本文在归纳nZVI改性策略的基础上,比较了黏土种类对nZVI形貌和性能的影响,提出了理想黏土载体的优选顺序,分析了复合材料的铁含量、比表面积、nZVI尺寸等与去除性能之间的关系,对nZVI耦合黏土在修复土壤重金属、卤代有机物、硝酸盐、新型污染物等方面的研究进行了总结,并概述了nZVI技术在土壤修复中的负面效应,最后对nZVI耦合黏土修复污染土壤的未来方向进行了展望.