养殖固体废物在硝酸和磷酸溶液中的水解特性

养殖固体废物掺杂磷肥工艺中养殖固体废物与酸的反应直接影响其有机组成。以鸡粪为研究对象,采用L16(45)正交试验研究了鸡粪粒径、酸浓度、鸡粪与酸溶液质量比、反应温度和反应时间对鸡粪在硝酸和磷酸溶液中水解过程的影响。结果表明,硝酸溶液中影响因素显著性依次为鸡粪与硝酸质量比、反应时间、硝酸浓度、鸡粪粒径、反应温度,最优工艺条件为鸡粪粒径0.20mm、硝酸质量分数15%、鸡粪与硝酸质量比0.2∶1.0、反应温度95℃、反应时间4h;在磷酸溶液中影响因素显著性依次为鸡粪与磷酸质量比、反应温度、鸡粪粒径、磷酸浓度、反应时间,鸡粪水解率与反应温度间呈正相关关系,最优工艺条件为鸡粪粒径0.40mm、磷酸质量分数60%、鸡粪与磷酸质量比0.1∶1.0、反应温度95℃、反应时间8h。鸡粪比表面积及其单位质量耗酸量、美拉德反应是制约鸡粪在硝酸和磷酸中水解反应的内因。研究结果为养殖固体废物掺杂有机磷肥的研发和推广提供了理论基础。     

废LCD面板有机材料水热资源化产乙酸

LCD面板主要由附着偏光片及液晶等有机材料的玻璃面板构成。有机材料的去除及资源化利用是废LCD面板处理的第一步。在水热条件下对废LCD面板进行了降解产酸研究。研究考察了反应温度、反应时间、氧化剂用量、水用量及pH值等对水热产乙酸产率及选择性的影响。通过正交实验确定了水热产乙酸的最佳操作条件：反应温度325℃,反应时间5min,氧化剂（30％H2O2）0．6mL,用水量2mL,近中性环境（pH6-6．5去离子水）。此条件下,乙酸产率及选择性分别为68．83％及70．56％。结果表明,以废LCD面板有机材料为原料,采用水热技术进行产乙酸反应,可实现其资源化再利用。     

重庆市大气污染对锌材料腐蚀的经济损失分析

简要介绍了材料大气腐蚀经济损失的估算方法,并以2002年为基准年,选择了重庆市主城中心的6个功能区作为代表性区域,运用腐蚀破坏剂量响应函数和使用寿命计算公式对锌材料的腐蚀经济损失进行了定量估算.结果表明,由大气污染腐蚀破坏锌材料造成的年直接经济损失约为4061.7万元,约为同期GDP的0.1%.其中,干沉降对经济损失总量的贡献率在71%～99%之间,均值为92%.     

不同物质对垃圾渗滤液中腐殖酸的吸附研究

垃圾渗滤液是一种有毒有害的高浓度有机废水,其中含大量腐殖酸。腐殖酸具有离子交换能力、吸附能力和脱除杂质能力,因此在很多方面有实用价值。活性碳、土壤、堆肥对废水中的有机物有一定的吸附能力。本文采用正交设计的方法,研究了活性碳、土壤、堆肥在不同温度,液／固,腐殖酸初始浓度的条件下对垃圾渗滤液中腐殖酸的吸附效果。实验结果表明：四种实验因素对吸附剂的吸附能力的影响程度为：吸附剂类型〉腐殖酸的初始浓度〉吸附反应温度〉液固比。在温度为25℃,液固比为50／0．5（mL/g）,腐殖酸初始浓度为41．99（mg／L）,吸附剂类型为活性碳时,腐殖酸吸附量最大,为40．86mg。同时分析了响应指标随因素的变化趋势。     

Photocatalytic bacterial inactivation by polyoxometalates

The photocatalytic inactivation (PCI) of Escherichia coli (Gram-negative) and Bacillus subtilis (Gram-positive) was performed using polyoxometalate (POM) as a homogeneous photocatalyst and compared with that of heterogeneous TiO₂ photocatalyst. Aqueous suspensions of the microorganisms (10⁷–10⁸ cfu ml⁻¹) and POM (or TiO₂) were irradiated with black light lamps. The POM-PCI was faster than (or comparable to) TiO₂-PCI under the experimental conditions employed in this study. The relative efficiency of POM-PCI was species-dependent. Among three POMs (H₃PW₁₂O₄₀, H₃PMo₁₂O₄₀, and H₄SiW₁₂O₄₀) tested in this study, the inactivation of E. coli was fastest with H₄SiW₁₂O₄₀ while that of B. subtilis was the most efficient with H₃PW₁₂O₄₀. Although the biocidal action of TiO₂ photocatalyst has been commonly ascribed to the role of photogenerated reactive oxygen species such as hydroxyl radicals and superoxides, the cell death mechanism with POM seems to be different from TiO₂-PCI. While TiO₂ caused the cell membrane disruption, POM did not induce the cell lysis. When methanol was added to the POM solution, not only the PCI of E. coli was enhanced (contrary to the case of TiO₂-PCI) but also the dark inactivation was observed. This was ascribed to the in situ production of formaldehyde from the oxidation of methanol. The interesting biocidal property of POM photocatalyst might be utilized as a potential disinfectant technology.     

Pre-concentration and separation of heavy metal ions by chemically modified waste paper gel

Iminodiacetic acid was immobilized on waste paper by chemical modification in order to develop a new type of adsorption gel for heavy metal ions. Adsorption behavior of the gel was investigated for a number of metal ions, specifically Cu(II), Pb(II), Fe(III), Ni(II), Cd(II), and Co(II) at acidic pH. From batch adsorption tests, the order of selectivity was found to be as follows: Cu(II)  Fe(III) > Pb(II) > Ni(II)  Co(II) > Cd(II). Column tests were carried out for pairs of metal ions to understand the separation and pre-concentration behavior of the gel. It was found that mutual separation of Ni(II) from Co(II) and that of Pb(II) from Cd(II) can be achieved at pH 3. Similarly, selective separation of Cu(II) from Cu(II)–Fe(III) and Cu(II)–Pb(II) mixtures at pH 1.5 and 2, respectively, was observed by using this new adsorption gel. In all cases, almost complete recovery of the adsorbed metal was confirmed by elution tests with HCl.     

吸收液pH值对锌合金白烟处理效果的影响

为了治理同时含有气态和粒状污染物的锌合金白烟,采用填料塔对其进行洗涤和吸收,考察了吸收液的pH值以及喷淋密度对锌合金白烟处理效果的影响,并根据碱洗和酸洗的特点,考察了碱酸两级处理的效果.结果显示,吸收液的喷淋密度与氯化铵烟尘、氯化氢和氨的处理效率成正比.吸收液的pH值也会影响白烟的处理效果,主要是通过吸收液与污染物之间的化学反应来进行,碱洗时氯化铵烟尘和氯化氢获得了较高的处理效率,但碱洗过程有氨生成,限制其应用;酸洗对氨的处理效率较高,但氯化铵烟尘和氯化氢的处理效率都比较低,达不到国家排放标准.尽管对锌白烟的处理效果还不理想,但试验结果对于锌白烟的治理具有重要的参考价值和指导意义.     

盐酸溶液改性蛭石对气态单质汞的吸附性能

采用盐酸溶液对蛭石进行浸渍处理,考察了盐酸溶液改性蛭石对气态单质汞的吸附能力。研究结果表明：盐酸溶液改性蛭石对气态单质汞的吸附效果好于未改性蛭石,盐酸浓度为4．0mol／L时,盐酸溶液改性蛭石对气态单质汞的吸附效果较佳;进气中气态单质汞的质量浓度越高,盐酸溶液改性蛭石对气态单质汞的去除率越低;适当提高吸附温度对盐酸溶液改性蛭石吸附气态单质汞较有利;降低蛭石粒径,盐酸溶液改性蛭石对气态单质汞的去除率提高。     

自催化法合成聚天冬氨酸

以马来酸酐和乙酸铵为原料,在微波条件下用自催化法合成了聚天冬氨酸（PASP）。通过正交实验确定了最佳合成条件：n（乙酸铵）：n（马来酸酐）=1．2,微波功率为1200W,反应时间为10min。在最佳合成条件下,PASP的收率为91．6％,PASP的黏均相对分子质量约为1．5×10^4。经红外光谱表征和核磁共振氢谱测试结果表明,PASP的各种主要官能团表现明显。当Ca^2＋质量浓度为250mg／L、PASP加入量为3mg／L时,PASP的阻垢率达到95％,表明PASP具有较好的阻垢性能。     

Mechanical Property Characterization of Plasticized Sugar Beet Pulp and Poly(Lactic Acid) Green Composites Using Acoustic Emission and Confocal Microscopy

Sorbitol and glycerol were used to plasticize sugar beet pulp-poly(lactic acid) green composites. The plasticizer was incorporated into sugar beet pulp (SBP) at 0%, 10%, 20%, 30% and 40% w/w at low temperature and shear and then compounded with poly(lactic acid) (PLA) using twin-screw extrusion and injection molding. The SBP:PLA ratio was maintained at 30:70. As expected, tensile strength decreased by 25% and the elongation increased. Acoustic emission (AE) showed correlated debonding and fracture mechanisms for up to 20% w/w plasticizer and uncorrelated debonding and fracture for 30–40% sorbitol and 30% glycerol content in SBP–PLA composites. All samples had a well dispersed SBP phase with some aggregation in the PLA matrix. However, at 40% glycerol plasticized SBP–PLA composites exhibited unique AE behavior and confocal microscopy revealed the plasticized SBP and PLA formed a co-continuous two phase system.