腈纶污水的分质处理

介绍某公司腈纶污水的水质特点，处理工艺、主要设备及构筑物设计参数。该污水预处理装置运行以来，处理效果良好，符合后续生化处理的进水要求。     

ORBAL氧化沟在炼油污水处理上的应用

总结了石炼污水处理场采用ORBAL氧化沟做为二级生化处理设施的成功经验，并对ORBAL氧化沟和周边进水，周边出水二沉池的运行机理进行了说明。     

难降解有机废水处理新技术

介绍了光氧化法、超临界氧化和低温等离子体化学三种废水处理新技术的原理,国内外研究的现状和未来的发展前景,分析了这些新技术在优化污染物废水处理方面得到工业应用所必须解决的主要技术问题.     

三唑磷农药废水厌氧处理可行性研究

采用厌氧流化率工艺处理在唑磷农药废水，必须降低原水中ＮＨ３－Ｎ含量，调整营养比例，当ＣＯＤ：Ｎ：Ｐ＝（１８０～２００）：５：１时，在中温厌氧消化条件下，ＣＯＤ含量可从４１７０ｍｇ／ｌ，去除率约５０％，沼气产率达到０．２５６ｍ＾３／ｍ＾３．ｄ。因此，把厌氧处理作为好氧处理的预处理单元，能确保整个处理系统出水达标。     

GdFeO3上CO氧化的Redox机理动力学

ＧｄＦｅＯ３用柠檬酸络合制备。用ＸＲＤ测定ＧｄＦｅＯ３为钙钛矿结构。用ＣＯ还原脉冲及用Ｏ２再氧化脉冲证实在ＧｄＦｅＯ３上ＣＯ氧化为Ｒｅｄｏｘ机理。用外循环流动无梯度反应顺研究了ＣＯ氧化稳态动力学。用正交设计法估计动力学方程中的参数。还原催化剂再氧化为控制步骤。     

微量营养物质对有机废水厌氧消化过程的调控作用

通过向处理酸性葡萄酒蒸馏废水的厌氧移动床生物膜反应器中投加微量营养物质的试验,得出利用微量营养物质调控厌氧消化过程在技术上是可行的。Fe、Ni、Co组合不仅能加快挥发性有机酸(VFA),特别是丙酸的降解速率,进而提高厌氧反应器的溶解COD去除率,同时,还有利于厌氧反应器有机负荷的快速提升和较强pH缓冲能力的形成。B族维生素对厌氧移动床生物膜反应器运行效果影响不大。Fe对厌氧移动床生物膜反应器运行有一定影响,但效果也不十分明显。     

高压脉冲电凝聚技术处理活性染料废水试验研究

难生物降解有机废水是废水处理的难点。阐述了高压脉冲电凝聚技术处理高浓度、难生物降解有机废水的最新机理。采用高压脉冲电凝聚技术处理活性染料（活性红）生产废水．研究了影响高压脉冲电凝聚技术处理活性染料废水效果的操作条件及影响因素．结果表明，在最佳处理工艺条件下。CODCr浓度12628mg／L的生产废水经处理后CODCr去除率为65％左右。再经后续混凝沉淀，最终出水CODCr可降低到1000mg／L以下。     

Comparison of UV-based advanced oxidation processes for the removal of different fractions of NOM from drinking water

This study examined the effectiveness for degradation of hydrophobic (HPO), transphilic (TPI) and hydrophilic (HPI) fractions of natural organic matter (NOM) during UV/H₂O₂, UV/TiO₂ and UV/K₂S₂O₈ (UV/PS) advanced oxidation processes (AOPs). The changing characteristics of NOM were evaluated by dissolved organic carbon (DOC), the specific UV absorbance (SUVA), trihalomethanes formation potential (THMFP), organic halogen adsorbable on activated carbon formation potential (AOXFP) and parallel factor analysis of excitation–emission matrices (PARAFAC-EEMs). In the three UV-based AOPs, HPI fraction with low molecular weight and aromaticity was more likely to degradate than HPO and TPI, and the removal efficiency of SUVA for HPO was much higher than TPI and HPI fraction. In terms of the specific THMFP of HPO, TPI and HPI, a reduction was achieved in the UV/H₂O₂ process, and the higest removal rate even reached to 83%. UV/TiO₂ and UV/PS processes can only decrease the specific THMFP of HPI. The specific AOXFP of HPO, TPI and HPI fractions were all able to be degraded by the three UV-based AOPs, and HPO content is more susceptible to decompose than TPI and HPI content. UV/H₂O₂ was found to be the most effective treatment for the removal of THMFP and AOXFP under given conditions. C1 (microbial or marine derived humic-like substances), C2 (terrestrially derived humic-like substances) and C3 (tryptophan-like proteins) fluorescent components of HPO fraction were fairly labile across the UV-based AOPs treatment. C3 of each fraction of NOM was the most resistant to degrade upon the UV-based AOPs. Results from this study may provide the prediction about the consequence of UV-based AOPs for the degradation of different fractions of NOM with varied characteristics.     

Catalytic oxidation effect of MnSO4 on As(III) by air in alkaline solution

The catalytic oxidation effect of MnSO₄ on As(III) by air in an alkaline solution was investigated. According to the X-ray diffraction (XRD), scanning electron microscope-energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS) analysis results of the product, it was shown that the introduction of MnSO₄ in the form of solution would generate Na_0.55Mn₂O₄·1.5H₂O with strong catalytic oxidation ability in the aerobic alkaline solution, whereas the catalytic effect of the other product MnOOH is not satisfactory. Under the optimal reaction conditions of temperature 90°C, As/Mn molar ratio 12.74:1, air flow rate 1.0 L/min, and stirring speed 300 r/min, As(III) can be completely oxidized after 2 hr reaction. The excellent catalytic oxidation ability of MnSO₄ on As(III) was mainly attributed to the indirect oxidation of As(III) by the product Na_0.55Mn₂O₄·1.5H₂O. This study shows a convenient and efficient process for the oxidation of As(III) in alkali solutions, which has potential application value for the pre-oxidation of arsenic-containing solution or the detoxification of As(III).     

甲烷高温自燃诱导过程实验与数值模拟研究

甲烷的转化在化工产业中具有举足轻重的地位与战略意义,近年来涌现的氧化偶联制烯烃等多种新型化工工艺涉及高温条件的甲烷-纯氧等体系的混合与反应过程,明确甲烷高温自燃诱导与爆炸规律是实现工艺安全设计与运行的前提,然而相关研究与基础数据仍较为欠缺。通过利用基于快速压缩装置的高温高压燃爆测试系统开展甲烷-纯氧等典型混合体系的自燃诱导过程研究,同时基于GRI-Mech 3.0机理的数值模拟方法进行了数值模拟研究。实验结果与数值模拟结果吻合较好,随着温度/压力的增加及氧气含量的下降,混合体系自燃诱导时间均缩短;燃料气中加入乙烷或氢气则会大幅缩短自燃诱导过程。对于多个工艺过程中涉及的低氧含量体系率先开展了研究,得到了不同当量比及温度条件下的典型体系自燃诱导时间,同时考察了惰性气的加入对于自燃诱导过程的延长作用。研究结果有助于深入理解甲烷自燃诱导机理,同时指导高温条件的甲烷转化工艺的本质安全化设计与爆炸防控。