Biodegradation of 2-methylquinoline by Enterobacter aerogenes TJ-D isolated from activated sludge

Bacterial strain Enterobacter aerogenes TJ-D capable of utilizing 2-methylquinoline as the sole carbon and energy source was isolated from acclimated activated sludge under denitrifying conditions. The ability to degrade 2-methylquinoline by E. aerogenes TJ-D was investigated under denitrifying conditions. Under optimal conditions of temperature (35℃) and initial pH 7, 2-methylquinoline of 100 mg/L was degraded within 176 hr. The degradation of 2-methylquinoline by E. aerogenes TJ-D could be well described by the Haldane model (R² > 0.91). During the degradation period of 2-methylquinoline (initial concentration 100 mg/L), nitrate was almost completely consumed (the removal efficiency was 98.5%), while nitrite remained at low concentration (< 0.62 mg/L) during the whole denitrification period. 1,2,3,4-Tetrahydro-2-methylquinoline, 4-ethyl-benzenamine, N-butyl-benzenamine, N-ethyl-benzenamine and 2,6-diethyl-benzenamine were metabolites produced during the degradation. The degradation pathway of 2-methylquinoline by E. aerogenes TJ-D was proposed. 2-Methylquinoline is initially hydroxylated at C-4 to form 2-methyl-4-hydroxy-quinoline, and then forms 2-methyl-4-quinolinol as a result of tautomerism. Hydrogenation of the heterocyclic ring at positions 2 and 3 produces 2,3-dihydro-2-methyl-4-quinolinol. The carbon-carbon bond at position 2 and 3 in the heterocyclic ring may cleave and form 2-ethyl-N-ethyl-benzenamine. Tautomerism may result in the formation of 2,6-diethyl-benzenamine and N-butyl-benzenamine. 4-Ethyl-benzenamine and N-ethyl-benzenamine were produced as a result of losing one ethyl group from the above molecules.     

三槽氧化沟内底推位置与积泥厚度的分析研究

氧化沟工艺由于进水中含有大量的无机颗粒,无机颗粒的沉淀导致沟内积泥较厚。为了不影响正常生产,依据经验数据,依次对1号、2号氧化沟安装底推。对沟内积泥情况及影响因素进行分析比较,得出氧化沟的积泥主要由进水中密度较大的无机颗粒造成,且积泥规律与底推安装位置和运行情况相关。     

Differences in rheological and fractal properties of conditioned and raw sewage sludge

Rheological tests for raw and conditioned activated sludge(AS) or anaerobic digested sludge(ADS) show that power-law relationships can be used to describe the evolution of several rheological parameters,i.e.,limiting viscosity(η∞),yield stress(τy),cohesion energy of the sludge network(Ec),and storage modulus(G’),with total suspended solid(TSS) content in raw and conditioned sludge.A gel-like structure that behaves similar to weak-link flocs/aggregates was observed in AS and ADS.As derived from the double-logarithmic plots of G’-TSS content,the mass fractal dimensions of the raw and conditioned AS or ADS flocs/aggregates were 2.70 and 2.53 or 2.85 and 2.79,respectively.The rheological tests also indicate that both polymer conditioning and increased TSS content led to improved elastic behavior,cohesion energy,and yield stress of the sludge network,as well as expanded the corresponding linear viscoelastic range.The porosity of AS or ADS flocs/aggregates will be improved by polymer conditioning.     

活化温度对SCAC制备过程中副产物生成规律的影响

文章研究了污泥-玉米芯活性炭(SCAC)制备过程中,活化温度对副产物(热解气和热解油)生成规律的影响。热解气和热解油分别采用气相色谱仪和气质联用仪进行分析检测。试验结果表明,随着活化温度的升高,SCAC的产量逐渐降低,热解气与热解油的产量则随之增多。不同温度条件下,热解气的主要成分均为H2和CO2,热解气中H2所占的体积百分数随着活化温度的升高而增加,而CO2则相应降低。此外,热解气中CH4的含量也会随着活化温度的上升而略有提高,说明较高的活化温度更有利于热解气的资源利用。热解油组分较为复杂,每个温度条件下的液态产物都包括上百种化合物,可分为烷烃,烯烃,苯类,酚类,腈类,杂环化合物,多环芳烃,有机酸,酰胺,酯类,甾体,醇,酮以及其他类共14大类型,其中以有机酸、腈类和甾体类有机物含量居多。随着活化温度的升高,有机酸和多环芳烃的含量有所增加,而酚类化合物的含量则有所降低;当活化温度升高至650℃以上时,甾体类有机物含量明显降低。     

2,2′-二硝基联苄生产废水的处理研究

对十六烷基三甲基溴化铵改性凹凸棒土、凹凸棒土负载TiO2采用XRD、FTIR以及TG等手段进行了分析和表征,对比了改性凹凸棒土、活性炭、大孔树脂等不同吸附剂和凹凸棒土负载TiO2对二硝基联苄生产废水的处理效果。结果表明:十六烷基三甲基溴化铵改性凹凸棒土的废水中污染物的去除率比凹凸棒土提高了2.5倍;凹凸棒土负载TiO2在波长λ=254 nm下光照0.5 h,对废水中污染物的去除率是凹凸棒土的2.0倍;投加量为3%活性炭在pH为2.0⁵.0时,对该类废水中污染物的去除率可达80%以上。     

原子吸收火焰法次灵敏线测定污水和电镀污泥中高含量的锌

对采用原子吸收火焰法次灵敏线测定污水和电镀污泥中高含量的锌进行了研究。试验结果表明：在锌浓度50．0～600．0mg/L之间,溶液锌含量与吸光度呈线性关系。线性回归方程为y＝0．000661x-0．0007,相关系数γ＝0．9998。方法检出限为25．0mg/L,相对标准误差（RSD）＜2．96％,加标回收率为92．5％～105％,与标准法的相对误差＜2．76％。     

污泥减量化技术研究进展与发展趋势

污泥的处理与处置已成为国内外污水处理厂的沉重负担,污泥减量成为解决此问题的重要途径。针对污泥处理处置过程中的环境问题和经济效益,在隐性生长、代谢解偶联、微型动物捕食作用等方面阐述了在水处理方面污泥减量化技术的研究进展,综述了污泥减量技术的研究应用现状,同时探讨了各技术存在的问题及其重点发展方向。     

活性污泥模型参数实际可识别性研究方法

可识别性研究是参数估计的第一步。对目前应用于活性污泥模型参数实际可识别性研究的三种方法进行了综述,根据模型的复杂程度以及所要研究的参数数量,研究者可选用不同的方法。     

高碳氮负荷下同时脱氮除碳好氧颗粒污泥研究

在4 L反应器中,以补加葡萄糖和硫酸铵的猪场废水为基质,不接种活性污泥,加入粉末状活性炭对废水土著微生物进行预固定.通过批次进水并控制运行条件（逐渐提高COD、NH 4＋-N负荷、缩短沉降时间、提高曝气量）培养同时脱氮除碳好氧颗粒污泥,研究了该好氧颗粒污泥的脱氮除碳功能及对高碳氮负荷冲击的响应.结果表明,成熟好氧颗粒污泥为土黄色不规则球状,粒径为0.5～3.5 mm.COD和NH 4＋-N负荷分别在4.80～12.6 kg.（m3.d）-1和0.217～0.503 kg.（m3.d）-1时,好氧颗粒污泥对COD的去除率〉94%,对NH 4＋-N的去除率〉98%.当COD和NH 4＋-N负荷分别提高至15.70 kg.（m3.d）-1和0.723kg.（m3.d）-1并运行4 d后,反应器内絮体激增,颗粒沉降变差并开始破碎,NH 4＋-N去除率下降至81.6%.排出部分污泥并降低负荷继续运行,颗粒污泥的NH 4＋-N去除率可迅速恢复至98%以上.本研究培养的好氧颗粒污泥具有良好的同时脱氮除碳功能,可以耐受高COD和NH 4＋-N负荷的双重冲击.     

pH和DO对好氧颗粒污泥去除高氨氮废水的影响研究

研究使用SBR成功培养的结构紧密、外形规则,具有良好脱氮性能的成熟好氧颗粒污泥处理高浓度氨氮废水,并探讨pH和DO对其处理效果的影响,旨在为工程实践提供理论依据。通过人工模拟废水,以蔗糖作为唯一碳源,NH4Cl为氮源,将进水NH4+-N浓度由300 mg/L逐步提高至900 mg/L,相应的NH4+-N负荷由0.6 kg/(m3.d)提高至1.8 kg/(m3.d),考察pH和DO对其处理效果的影响。研究结果表明:当控制反应器pH为8.0,曝气量为75 L/h时,好氧颗粒污泥脱氮的效果最好,氨氮去处率分别为96.70%9、2.33%。由于运行过程中每隔15 min监测每个反应器pH值,使其维持在各自pH值7.0±0.1范围内。这种酸碱度环境对异养菌等微生物并没有产生抑制作用;因此在各pH条件下,COD去除的所需时间和去除率基本没有差别。在不同的DO下,COD在初始的60 min里降解速度有明显区别。曝气量为150 L/h时,COD的降解速度最快,但是曝气量过大颗粒污泥内部厌氧区被压缩,因此选择最佳的曝气量为75 L/h。