高锰酸钾净水的氧化副产物研究

在高锰酸钾预氧化条件下 ,对北京京密引水渠水和松花江水进行混凝处理 ,并将原水与出水水样经色谱 质谱联用仪分析 ,以 1997年美国国家环保局 (USEPA)提出的饮用水规程和健康建议为标准 ,初步探讨了高锰酸钾净水过程中产生的副产物是否对人体有毒害作用 .试验结果表明 :在试验条件下 ,尚未发现高锰酸钾氧化生成USEPA规定的有毒有害副产物 ,并认为其原因可能与高锰酸钾氧化作用方式以及氧化过程中生成的新生态水合二氧化锰的吸附作用有关 .     

Kinetics of aniline oxidation with chlorine dioxide

For the first time, kinetics of aniline oxidation with chlorine dioxide(ClO2) were investigated systematically by detecting concentration of aniline with HPLC at regular intervals. Results showed that the reaction was first-order both in ClO2 and in aniline, and the oxidation reaction could be described as second-order reaction. Stoichiometric factor η was experimentally determined to be 2.44. The second-order-reaction rate constant k was 0.11L/(mol.s)under condition of pH 6.86 and water temperature(Tw) 287K. Reaction activation energy was 72.31 kJ/mol, indicating that the reaction could take place under usual water treatment conditions. The reaction rate constants in acidic and alkali media were greater than that in neutral medium. Chlorite ion could slightly increase reaction rate in acidic medium. p-aminophenol and azobenzene were detected by GC-MS as intermediates.     

酸性氯化铜蚀刻废液一步沉淀法制备碱式碳酸铜

以酸性氯化铜蚀刻废液为原料,在Na₂CO₃和助剂A存在下,采用一步沉淀法制备碱式碳酸铜。考察了反应pH、n（Na₂CO₃）∶n（助剂A）、反应时间和反应温度对碱式碳酸铜制备效果的影响,并采用XRD、TG 及SEM对产品进行了表征。实验结果表明：在反应pH 7.0、沉淀剂配比n（Na₂CO₃）∶n（助剂A）=1∶2、反应时间1.0 h、反应温度70 ℃的条件下,产品的w（Cu²⁺）达55.62%,w（Cl^-）为0.013%,符合HG/T 4825—2015《工业碱式碳酸铜》的要求;蚀刻废液中Cu²⁺的回收率接近100%。表征结果表明,制得的产品为单一组分CuCO₃·Cu（OH）₂,小颗粒为直径1.8~5.4 μm的不规则球形,团聚后的大颗粒呈姜块状形貌,粒径为48~75 μm。     

亚硝酸型反硝化除磷工艺特性及其应用

以亚硝酸盐作为电子受体进行反硝化除磷污泥的驯化,并探究了工艺运行条件、性能及实际应用情况.研究表明:厌氧-缺氧-好氧驯化方式可快速富集以亚硝酸盐为电子受体的反硝化聚磷菌,通过逐步提高底物浓度可以驯化富集耐受高NO₂^--N浓度的DNPAOs.实际废水运行实验表明,反硝化除磷法处理猪场废水UASB-SFSBR尾水是可行的,当缺氧进水NO₃^--N、NO₂^--N和PO₄^3--P浓度分别为5,70,30mg/L时,出水NO₃^--N和NO₂^--N浓度基本为0,PO₄^3--P浓度在1.0mg/L以下.     

冬季不同污水处理工艺对溶解性有机物的去除

以东北地区4个城市污水处理厂为研究对象,考察冬季不同污水处理工艺对溶解性有机物(DOM)组分的去除效果,以及对DOM组分的光谱学特性和卤代活性的影响.利用XAD树脂将DOM分为5个部分:疏水性有机酸(HPO-A)、疏水性中性有机物(HPO-N)、过渡亲水性有机酸(TPI-A)、过渡亲水性中性有机物(TPI-N)和亲水性有机物(HPI).结果表明,A/O法、曝气生物滤池、浮动填料法和A2/O法对DOM都具有较高的去除能力,其中曝气生物滤池对DOM的处理效果最好.经4种污水处理工艺处理后,5种组分的芳香性和三卤甲烷生成活性(STHMFP)均升高.A2/O法对HPO-A和TPI-A的芳香性增强程度最高,而曝气生物滤池对HPO-N,TPI-N和HPI的芳香性增强程度最高.浮动填料法对HPO-A,TPI-A和HPI的STHMFP升高最显著,A2/O法对HPO-N的STHMFP增加最显著,曝气生物滤池对TPI-N的STHMFP升高最显著.4种污水处理工艺对HPI中荧光物质的去除率高于非荧光物质.而对于其他4种DOM组分来说,不同的污水处理工艺对不同荧光峰的改变不相同.     

Treatment,residual chlorine and season as factors affecting variability of trihalomethanes in small drinking water systems

Seasonal variability in source water can lead to challenges for drinking water providers related to operational optimization and process control in treatment facilities. The objective of this study is to investigate seasonal variability of water quality in municipal small water systems (<3000 residents) supplied by surface waters. Residual chlorine and trihalomethanes (THM) were measured over seven years (2003–2009). Comparisons are made within each system over time, as well as between systems according to the type of their treatment technologies. THM concentrations are generally higher in the summer and autumn. The seasonal variability was generally more pronounced in systems using chlorination plus additional treatment. Chloroform, total THM (TTHM) and residual chlorine concentrations were generally lower in systems using chlorination plus additional treatment. Conversely, brominated THM concentrations were higher in systems using additional treatment. Residual chlorine was highest in the winter and lowest in the spring and summer. Seasonal variations were most pronounced for residual chlorine in systems with additional treatment. There was generally poor correlation between THM concentrations and concentrations of residual chlorine. Further study with these data will be beneficial in finding determinants and indicators for both quantity and variability of disinfection byproducts and other water quality parameters.     

塑料管材输配水过程中有机物释放规律研究

研究了目前给水管网中常用的3种塑料管材,未增塑聚氯乙烯(uPVC),聚乙烯(PE)和无规共聚聚丙烯(PPR)管在输配水过程中有机物的释放规律.通过静态管段实验模拟给水管网中不同输配水状态,选取总有机碳(TOC)为综合评价指标,考察了不同塑料管材中有机物随时间的迁移释放特性,并分析了管材有机物释放对管网水中余氯消耗的影响.随着管材输配水次数的增加,uPVC管释放至水中的TOC浓度和TOC释放速率分别在0.03mg/L和0.04μg/(d?cm2)以下,而PE管和PPR管在输配水过程中TOC的释放浓度和释放速率在初期最大[PE: 0.19mg/L,0.25μg/(d?cm2);PPR:0.07mg/L,0.09μg/(d?cm2)],且后期递减并趋于平稳[PE:0.03~0.08mg/L,0.05~0.10μg/(d?cm2);PPR:0.01~0.03mg/L, 0.01~0.04μg/(d?cm2)].随着水力停留时间的增加,不同管材释放的有机物浓度持续升高.不同管材有机物的释放能力排序为:PE>PPR>uPVC.各管材的有机物释放特性直接影响管网水的余氯消耗特性,且管材的有机物释放量越多,管网水的余氯消耗越快.PE管的使用易引起水体有机污染问题.本研究明确了3种常用塑料管材的有机物释放规律,将进一步为与塑料管材安全性能评价相关的国家标准的修订提供理论依据.     

一起液氯泄漏事故的分析及预防对策

针对国内近年来氯气泄漏、爆炸事故频发的现状,选择其中具有典型性的江西某厂氯气泄漏事故,运用因果分析方法对其事故原因进行系统分析,根据分析结果,以降低事故发生概率和严重度为目标,从管理角度提出预防对策.     

因果图分析法应用于液氯泄漏事故分析

针对国内近年来氯气泄漏／爆炸事故频发的现状,选择其中具有典型性的江西油脂厂氯气泄漏事故,运用因果分析方法对其事故原因进行系统分析。并根据分析结果,以降低事故发生概率和严重度为目标,从管理角度提出预防对策。     

氯气泄漏后毒害区的估算及泄漏的处置

运用毒害区计算方法对本部贮存的氯气泄漏后扩散的半径进行估算,同时以扩散的半径作参考,提出氯气泄漏的处置方法.