地下水PRB原位生物修复中一种释氧材料的改进技术及效果分析

释氧材料经济有效的释氧是地下水原位生物修复的关键因素。实验通过在释氧材料中加入膨润土、磷酸二氢钾和硫酸铵等,改进释氧材料的性能。柱实验结果显示,该释氧材料释氧速率缓慢,释氧时间长,可以使溶液中DO长期保持在5 mg/L以上;另外,释氧材料中添加的缓冲剂及天然含水层介质对pH值有较好的缓冲作用,可以使pH值达到后续生物修复的要求。     

陶瓷印花废水处理的混凝剂及工艺条件

采用混凝剂聚合氯化铝（PAC）、聚丙烯酰胺（PAM）、聚合硫酸铁（PFS）对陶瓷印花废水进行混凝沉降处理,监测水样的吸光度、浊度、悬浮物,以脱色率、浊度去除率、悬浮物去除率评价混凝处理的效果。结果表明：PAC是陶瓷印花废水沉降处理的理想混凝剂;水样的吸光度、浊度、悬浮物随混凝剂用量增大和沉降时间延长而呈降低趋势,而脱色率、浊度去除率、悬浮物去除率随混凝剂和沉降时间的增大呈增大的趋势;PAC投加量为20mg／L,沉降时间约为24h,水样脱色率达到90．0％,而当PAC投加量达到100mg／L,沉降时间约为4h,陶瓷印花水的脱色率可达到96．0％。证明了药剂用量的增加与沉降时间的延长对混凝过程具有增效作用。     

Facilitating substance phase‐out through material information systems and improving environmental impacts in the recycling stage of a product

The amount of electrical and electronic products is increasing rapidly, and this inevitably leads to the generation of large quantities of waste from these goods. Some of the generated e‐waste ends up in regions with sub‐standard recycling systems and may be processed under poor conditions. During uncontrolled incineration, halogenated dioxins and furans can be generated from brominated and chlorinated compounds in the products. In order to reduce the health and environmental risks involved in the recycling stage of the life cycle of electronics, an effective design‐for‐environment process must be established during the product development phase. Knowledge of the chemical substances in the product is crucial to being able to make informed decisions. Through full knowledge of the material content of procured components, phase‐outs of unwanted substances, such as halogenated substances, can be performed in an effective manner. Therefore, information is the key to success in phasing‐out substances; facilitating compliance of legal provisions for manufacturers of electrical and electronic devices; and improving the environmental footprint of products as they reach the end of the life cycle. After an introduction to the challenges of electronics waste management, this paper describes supply chain information systems and how they are used to facilitate substance phase‐outs in the electronics industry. Sony Ericsson has been working with phase‐outs of unwanted substances since it was founded in 2001. Through the introduction of a material declaration system that keeps track of all substances in the components used in the company's products, Sony Ericsson has been able to replace unwanted substances to improve environmental impacts at the recycling stage of a product.     

工业污染治理投资完成状况分析研究——以我国沿海省市为例

运用多元统计中的主成分分析法和系统聚类法对我国东部地区工业污染的治理投资完成情况进行了分析。根据主成分分析结果,对选取的11个省市进行分类,并在此基础上提出加强各区域环境污染治理的几点建议。     

铬酸钾和亚硝酸钠复合阻锈性能研究

在10%(wt)的氯化钠溶液中对不同浓度的铬酸钾、亚硝酸钠及其复配阻锈剂进行阻锈实验,采取失重法考察它对钢筋的阻锈性能。结果表明,铬酸钾的阻锈性能优于亚硝酸钠,主要是由于铬酸根离子对原电池阴阳两极反应的抑制作用较强;缓蚀剂浓度越高,缓蚀效果越好。两种缓蚀剂混合使用的效果比单独使用效果更好,这主要是它们能产生协同效应,降低阴极和阳极的活性,在钢筋上产生持续的保护膜。     

火电厂电除尘器电控系统的节能改造

电除尘器是火力发电厂的高能耗设备,从细节入手,挖掘电除尘器节能潜力,利用原有设备进行改造,采用简易脉冲供电方式和临界反电晕供电方式可以提高电除尘器电能的利用率,大幅度地降低电除尘器的能耗,实现节能。通过对电除尘器电控系统改造实例的前后电场参数进行比较,说明这种改造方法是可行的,实现了经济、节能与环保三者的兼顾与统一。     

无机陶瓷膜处理冷轧厂乳化液废水工艺

通过对冷轧厂乳化液(含油)废水处理方法的对比,说明处理该废水采用无机陶瓷膜处理装置完全可行;介绍了无机陶瓷膜处理冷轧厂乳化液(含油)废水的工艺过程及处理系统组成。     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

Variation of radiation level and radionuclide enrichment in high background area

Significantly high radiation level and radionuclide concentration along Quilon beach area of coastal Kerala have been reported by several investigators. Detailed gamma radiation level survey was carried out using a portable scintillometer. Detailed studies on radionuclides concentration in different environmental matrices of high background areas were undertaken in the coastal areas of Karunagapalli, Kayankulam, Chavara, Neendakara and Kollam to study the distribution and enrichment of the radionuclides in the region. The absorbed gamma dose rates in air in high background area are in the range 43-17,400 nGyh⁻¹. Gamma radiation level is found to be maximum at a distance of 20 m from the sea waterline in all beaches. The soil samples collected from different locations were analysed for primordial radionuclides by gamma spectrometry. The activity of primordial radionuclides was determined for the different size fractions of soil to study the enrichment pattern. The highest activity of ²³²Th and ²²⁶Ra was found to be enriched in 125-63 μ size fraction. The preferential accumulation of ⁴⁰K was found in <63 μ fraction. The minimum ²³²Th activity was 30.2 Bq kg⁻¹, found in 1000-500 μ particle size fraction at Kollam and maximum activity of 3250.4 Bq kg⁻¹ was observed in grains of size 125-63 μ at Neendakara. The lowest ²²⁶Ra activity observed was 33.9 Bq kg⁻¹ at Neendakara in grains of size 1000-500 μ and the highest activity observed was 482.6 Bq kg⁻¹ in grains of size 125-63 μ in Neendakara. The highest ⁴⁰K activity found was 1923 Bq kg⁻¹ in grains of size <63 μ for a sample collected from Neendakara. A good correlation was observed between computed dose and measured dose in air. The correlation between ²³²Th and ²²⁶Ra was also moderately high. The results of these investigations are presented and discussed in this paper.     

鲁南经济带"城市走廊"战略研究

城市走廊是区域发展的一种重要空间布局方式和发展策略.鲁南经济带规划的科学、高效实施对于鲁南地区加快发展,摆脱落后局面具有重大意义.规划建设鲁南"城市走廊"无疑是实施鲁南经济带规划的必然选择,更是关键措施.鲁南经济带"城市走廊"的空间结构基本呈"之"字形态,组团式发展,可以形成区域1个核心增长极、5个圈层型中小城市群、6个三角形特色小城市经济增长带;城市走廊的轴线发展趋势为"三纵两横".建设鲁南"城市走廊",需要优化产业分工,提升区域工业化水平;优化区域空闻结构,培育核心增长极,打造小城市群,尤其需要精心打造兖州-曲阜-邹城-滕州-微山-薛城-枣庄市中区-峄城区-台儿庄核心经济走廊,形成大中小城市合理布局发展的良好体系;尽快建设南部东西方向快速交通干线,建立区域共建互动机制,使鲁南"城市走廊"成为区域发展、产业振兴的动力和源泉.