汽油机排气颗粒粒径分布特征试验研究

对汽油机排气中颗粒的数浓度和粒径分布特征进行了测试.在测试工况下,汽油机排气中的颗粒呈包含核模态粒子(10 nm＜DP＜50 nm)和积聚模态粒子(50 nm＜DP＜487 nm)的双峰分布,排气颗粒的总数和总质量浓度分别为4.2×105-7.9×106个·cm-3和0.02-0.27 mg·m-3.汽油机在开环控制状态下(车速不低于90 km·h-1时)的颗粒数量排放明显高于闭环控制状态(车速不高于70 km·h-1),总颗粒质量浓度随车速的增大显著增加.随车速增大,积聚模态粒子的平均粒径先减小后增大,核模态粒子的几何平均粒径先增大后减小,低车速时,有大量10-20 nm的核模态粒子生成.柴油机和汽油机排气颗粒中核模态粒子通常占有大的数量百分比,为75%-95%,而其质量百分比仅为5%-25%.汽油机的总颗粒、核模态粒子和积聚模态粒子的数量和质量排放均远低于柴油机.     

珠三角秋冬季节长时间灰霾污染特性与成因

利用珠三角大气超级站2012年10月与2013年1月能见度、不同粒径颗粒物与BC质量浓度、气溶胶光散射系数、O3、相对湿度等在线监测数据,分析秋冬季节2次持续时间超过10 d的长时间灰霾过程污染特性与成因。结果表明,冬季灰霾过程中气溶胶吸光系数和光散射系数对大气总消光系数的贡献分别为13%和67%;PM2.5、PM1占PM10质量浓度分别为66%和39%;较高的PM2.5与BC日均浓度相关系数(R2=0.88)体现了一次排放对颗粒物质量浓度及能见度的显著影响。秋季灰霾过程中气溶胶吸光系数和光散射系数对大气总消光系数的贡献分别为11%和69%,由BC导致的吸光效应较冬季下降了约20%;PM2.5和PM1占PM10质量浓度比例分别为68%和45%,均高于冬季;O3浓度日最大小时值的平均值接近冬季的2倍;二次来源对PM2.5浓度升高和能见度下降起主导作用。来自不同方向的2种气团在珠三角僵持,大气扩散条件差是导致这2次灰霾过程的重要外在条件,应成为灰霾预报预警的重点关注对象。     

低进水浓度CASS工艺沿程污染物去除特征及微生物群落变化

南方部分城镇污水浓度偏低,而循环式活性污泥法(CASS)能较好地处理低浓度污水,处理性能与微生物群落特征密切相关,但鲜有研究涉及其沿程微生物群落结构变化。本研究选取广东省某CASS城镇污水厂作为典型案例,分析其沿程污染物去除特征和微生物变化,从微生物学角度探讨污染物的去除机理。结果表明：低进水浓度CASS生化池沿程耗氧有机物(以COD计)、TN、NO₃⁻-N、TP主要在污泥选择区被吸附降解,进水1 h COD和TP值降至最低,NH₄⁺-N主要在主反应区被氧化降解,生化池可去除污水中56.42%的耗氧有机物(以COD计)、41.71%的TN、77.78%的NH₄⁺-N、99.59%的TP。生化池主要优势菌门有变形菌门、拟杆菌门、绿弯菌门和浮霉菌门,变形菌门是影响微生物多样性变化的关键菌门。属水平上,进水1 h选择区Zoogloea、Aeromonas和Thauera丰度较高,主反应区Nitrospira丰度较高;进水结束选择区Nitrospira丰度较高,主反应区Terrimonas和Lactobacillus丰度较高;沉淀1 h选择区Thauera丰度提高,主反应区Nitrosomonas丰度较高,主要发生氨氧化;闲置结束选择区脱氮菌类型多丰度高,主反应区Sulfuritalea、Haliangium、Zoogloea丰度较高。沿程功能性微生物丰度变化与污染物浓度变化相对应。NO₃⁻-N对微生物群落结构的塑造影响最显著(解释度为38.92%)。氮代谢途径表明沿程主反应区均发生全程硝化反硝化,选择区均发生短程硝化和全程反硝化,除进水1 h外,其余阶段选择区的反硝化功能基因丰度均比主反应区高。     

Influences and mechanisms of nanofullerene on the horizontal transfer of plasmid-encoded antibiotic resistance genes between E. coli strains

• Sub-inhibitory levels of nC₆₀ promote conjugative transfer of ARGs. • nC₆₀ can induce ROS generation, oxidative stress and SOS response. • nC₆₀ can increase cell membrane permeability and alter gene expression. • Results provide evidence of nC₆₀ promoting antibiotic resistance dissemination. The spread and development of antibiotic resistance globally have led to severe public health problems. It has been shown that some non-antibiotic substances can also promote the diffusion and spread of antibiotic resistance genes (ARGs). Nanofullerene (nC₆₀) is a type of nanomaterial widely used around the world, and some studies have discovered both the biological toxicity and environmental toxicity of nC₆₀. In this study, cellular and molecular biology techniques were employed to investigate the influences of nC₆₀ at sub-minimum inhibitory concentrations (sub-MICs) on the conjugation of ARGs between the E. coli strains. Compared with the control group, nC₆₀ significantly increased the conjugation rates of ARGs by 1.32‒10.82 folds within the concentration range of 7.03‒1800 mg/L. This study further explored the mechanism of this phenomenon, finding that sub-MICs of nC₆₀ could induce the production of reactive oxygen species (ROS), trigger SOS-response and oxidative stress, affect the expression of outer membrane proteins (OMPs) genes, increase membrane permeability, and thus promote the occurrence of conjugation. This research enriches our understanding of the environmental toxicity of nC₆₀, raises our risk awareness toward nC₆₀, and may promote the more rational employment of nC₆₀ materials.     

APPLICATION OF THE GREEN-AMPT INFILTRATION EQUATION TO WATERSHED MODELING1

ABSTRACT: A computer model was developed, based on the Green-Ampt infiltration equation, to computed rainfall excess for a single precipitation event. The model requires an estimate of parameters related to hydraulic conductivity, wetting front section, and fillable porosity of the soil layers. Values of parameters were estimated from soil textural averages or regression equations based on percent sand, percent clay, and porosity. Average values of effective porosity and wetting front suction were largely acceptable due to the relatively low variability and low model sensitivity to the parameters. Hydraulic conductivity was the most erratic constituent of the loss rate computation due to the high variability and the high sensitivity of the computed infiltration to the parameter. The performance of the Green-Ampt infiltration model was tested through a comparison with the SCS curve number procedure. Seven watersheds and 23 storms with precipitation of one inch or greater were used in the comparison. For storms with less than one inch of rainfall excess, the SCS curve number procedure generally gave the best results; however, for six of the seven storms with precipitation excess greater than one inch, the Green-Ampt procedure delivered better results. In this comparison, both procedures used the same initial abstractions. The separation of rainfall losses into infiltration, interception, and surface retention is, in theory, an accurate method of estimating precipitation excess. In the second phase of the study using nine watersheds and 39 storms, interception and surface retention losses were computed by the Horton equations. Green-Ampt and interception parameters were estimated from value sin the literature, while the surface retention parameter was calibrated so that the computed runoff volumes matched observed volumes. A relationship was found between the surface retention storage capacity and the 15-day antecedent precipitation index, month of year, and precipitation amount.     

RUNOFF VOLUME ESTIMATION USING GIS TECHNIQUES1

ABSTRACT: Rainfall runoff of six watersheds was modeled via the Soil Conservation Service runoff curve number model in two ways: conventionally (manually) and via a geographic information system (GIS). Input data (elevation, soils, and landcover) were digital for the latter method. In contrast to previous studies, the GIS was ised for all phases of the modeling process, including watershed delineation and routing of runoff. A comparison between the two methods was consistent with results reported by others and indicates that the use of a GIS is an acceptable alternative to the conventional method for watersheds lacking relatively flat terrain. Given this limitation, the GIS method may prove advantageous over manual methods when study areas are large or numerous, runoff is modeled repetitively, alternative landcover scenarios are explored, or a digital database already exists for the study area.     

Numerical simulation of stratified turbulent two phase flow in aquatic environment

Ｉｎｅｓｔｕａｒｙ,ｄｅｎｓｉｔｙｓｔｒａｔｉｆｉｅｄｆｌｏｗｅｘｉｔｓｗｉｄｅｌｙｂｅｃａｕｓｅｆｒｅｓｈｗａｔｅｒｊｏｉｎｓｉｎｔｏｓｅａｗａｔｅｒａｎｄｔｈｅｄｅｎｓｉｔｙｏｆｆｒｅｓｈｗａｔｅｒｉｓｄｉｆｆｅｒｅｎｔｆｒｏｍｔｈａｔｏｆｓｅａ?..     

Formation and harmfulness of high fluoride-bearing ground-water

ＩｎｔｒｏｄｕｃｔｉｏｎＩｎｓｏｍｅｓｐｅｃｉａｌｇｅｏｍｏｒｐｈｉｃ,ｇｅｏｌｏｇｉｃａｌ,ｌｉｔｈｏｇｅｏｃｈｅｍｉｃａｌａｎｄｈｙｄｒｏｇｅｏｃｈｅｍｉｃａｌｅｎｖｉｒｏｎｍｅｎｔ,ｔｈｅｇｒｏｕｎｄｗａｔｅｒａｎｄｓｏｉｌｉｎｓｏｍｅａｒｅａｓ?..     

Arbuscular mycorrhizal fungi, rhizobia, available soil P and nodulation of groundnut (Arachis hypogaea) in Zimbabwe

Arbuscular mycorrhizal fungal (AMF) colonization and nodulation of groundnut were examined in nine soils collected from subsistence farmers’ fields in Zimbabwe. Nodule number, shoot dry weight, shoot N and P contents, and AMF colonization were assessed after 6 weeks growth. Both nodule number and AMF colonization differed by an order of magnitude among the nine soils. Soil available P explained almost all the variability in nodule number (r² = 0.98), but had no significant effect on percent AMF colonization. By adding P to one soil, nodule numbers increased four-fold resulting in a significantly higher N content in the shoots. Similar, but smaller, effects were obtained by increasing the abundance of AMF through an inoculation with Glomus intraradices, suggesting that nodulation in this soil was limited by AMF abundance and that the fungi could, to a limited extent, substitute for P fertilizer.     

Filtration improvement of zinc sludge by using unconventional alkalization sequence

ＩｎｔｒｏｄｕｃｔｉｏｎＺｉｎｃｉｓｏｎｅｏｆｔｈｅｍｏｓｔｉｍｐｏｒｔａｎｔｍｅｔａｌｓｉｎｍｏｄｅｒｎｉｎｄｕｓｔｒｙａｎｄｈａｓｂｅｅｎｕｓｅｄｗｉｄｅｓｐｒｅａｄｌｙ.Ｍｏｓｔｏｆｔｈｅｚｉｎｃｍｅｔａｌｓｉｎｔｈｅｗｏｒｌｄｉｓｐｒｏｄｕｃ?..