固相萃取- GC/MS法测定水中邻苯二甲酸酯类

采用固相萃取-GC／MS法测定水中6种邻苯二甲酸酯类有机污染物,比较了不同固相萃取柱对萃取效果的影响,优化了水样pH值、水样流量、穿透体积、洗脱溶剂、洗脱剂体积、洗脱流量等萃取条件。方法在0．050μg/L-800μg/L范围内线性良好,检出限为0．008μg/L～0．03μg／L,标准溶液测定的RSD≤10．5％,实际水样加标回收率为80．0％-100％。     

浊点萃取分离富集荧光光度法测定水中α - 萘酚

基于非离子表面活性剂Triton X-114,采用浊点萃取分离富集荧光光度法测定水中α-萘酚,优化了影响浊点萃取的各种因素,包括样品酸度、表面活性剂体积分数、氢氧化钠溶液浓度、平衡温度和时间等,讨论了常见无机离子和可能共存的有机物的干扰。方法在0.010 mg/L～0.400 mg/L范围内线性良好,检出限为3.0μg/L,标准溶液测定的RSD为4.8%,水样加标回收率为94.3%～103%。     

Metal concentrations in used engine oils: Relevance to site assessments of soils

Used engine oils contain metals, which upon entering soils may pose risks to human health or the environment. In this study, previously published concentrations of 23 metals in 213 used engine oil samples from the early 1970s to the mid-1990s are statistically evaluated. Neat (100%) used engine oils were found to contain relatively high concentrations of lead, calcium, and zinc, attributable to piston blow-by of leaded gasoline, calcium salt detergent additives, and zinc-bearing anti-corrosion/anti-oxidation additives, respectively. Wear metal concentrations were lower. The lead concentration in used engine oils in the U.S. declined between the 1970s and early 1990s, potentially providing a basis to constrain the “age” of used engine oil(s) in soils. The concentrations of 23 metals in used engine oils were compared to soil risk benchmarks in 15 representative jurisdictions in the U.S., Canada, Australia, and Europe. The maximum concentrations in neat (100%) used engine oil of eight metals – Be, Co, Fe, Mn, Ni, Se, Ag, and Ti – were lower than their collective minimum benchmarks in soils for the jurisdictions surveyed, indicating their concentrations in soils could not be reasonably expected to exceed any soil benchmarks. Nine metals (As, Ba, Cd, Cr, Cu, Pb, Sn, V and Zn), but particularly arsenic, cadmium, lead, tin, and zinc, were identified as potential contaminants of concern (PCOC) for soils from locations impacted with used engine oils, owing to their higher median concentrations (i.e., 2.5, 1.4, 1038, 5.0, and 922 mg/kg in oil, respectively) relative to most soil benchmarks. Site-specific benchmarks and metal concentrations at reasonable oil in soil concentrations require consideration when developing the suite of PCOC metal analytes for conducting site assessments of soils impacted by used engine oil.     

电石渣－铁屑法去除硫酸废水中的氟和砷

对各种处理含氟、砷废水的方法进行了探讨，选择了以电石渣和废铁屑为药剂去除硫酸废水中氟和砷的方法，取得了较好的效果。该法以废治废、工艺简便、运行费用低，处理后的废水可达排放标准。     

分子筛生产废水中悬浮物的絮凝与回用

对分子筛生产废水进行了絮凝沉降分离试验，确定了絮凝剂、助凝剂及絮凝敢分离条件。试验结果表明，絮凝沉降所得到的絮凝物料的化学组成、结构、性能与絮凝前原废水中的悬浮物基本一致，可返回原生产工序中使用。     

O／W型乳化液的处理

采用药剂破乳－电解破乳工艺处理Ｏ／Ｗ型乳化液，药剂破乳选用聚合硫酸铁为破乳剂，破乳时最佳ＰＨ为８，聚合硫酸铁的最佳投量为１５００ｍｇ／Ｌ，电解破乳选用铁作阳极，铝作阴极，电流密度０．８６Ａ／ｄｍ＾２，极距２５ｍｍ，电解时间３ｈ。在上述条件下，破乳效果良好，出水清澈透明，ＣＯＤ总去除率可达到９６－９７％。     

不同市场结构组合下稀土最优开采路径研究

本文从价格视角将我国稀土市场结构的变化历程划分为不同阶段,分别从理论和现实视角上探讨了在国际、国内都是完全竞争市场,国际市场垄断、国内市场完全竞争,国际市场完全竞争、国内市场垄断,国际、国内都是垄断市场条件下稀土最优开采路径及最优耗竭时间,并通过设定参数判断其相对大小关系。发现在一定的假设条件下,开采前期当国内和国际市场都是完全竞争时,稀土最优开采量是最大的;当国内和国际市场都是垄断时,稀土最优开采量是最小的;其他两种市场情况下稀土最优开采量居于中间,当国际市场是稀土的主要消费地时,国际竞争-国内垄断市场情况下稀土最优开采量大于国际垄断-国内竞争市场情况下稀土最优开采量,反之,国际垄断-国内竞争市场情况下稀土最优开采量大于国际竞争-国内垄断市场情况下稀土最优开采量。     

Producing biodiesel from waste animal oil by modified ZnO

Biodiesel produced by transesterification of waste animal oil is a promising green fuel in the future. ZnO-Al₂O₃ and ZnO/Zn₂Al composition oxides were prepared by co-precipitation method and impregnation method, respectively. The above catalysts were characterized by X-ray diffraction (XRD), Brunauer--Emmett--Teller (BET) and CO₂ adsorption and temperature-programmed desorption (CO₂-TPD) and show that the high activity for the catalyst is attributed to its high alkalinity. The reaction parameters were optimized and the results show that the transesterification ratio of waste animal oil can reach 98.7% with 10% ZnO/Zn₂Al catalyst after 2 h. Moreover, 10%ZnO/Zn₂Al compound oxides can be active for the successive cycles. The glycerol as a predominant by-product after transesterification is of high purity with high use value.     

移动床生物膜反应器—膜生物反应器深度处理模拟废水及工业园区综合废水

将移动床生物膜反应器(MBBR)与膜生物反应器(MBR)有机结合,研究了该MBBR—MBR串联系统在水力停留时间(HRT)为17.50、11.75h条件下的脱碳脱氮的效果以及对工业园区综合废水污染物的去除情况。结果表明:(1)MBBR—MBR串联系统脱碳脱氮的效果良好,HRT的改变对系统的去除效果有一定的影响,随着总HRT由17.50h变为11.75h,模拟废水中COD的去除效果降低,但氨氮、硝态氮和TN的去除效果基本不受影响。(2)MBBR—MBR串联系统处理印染工业园区综合废水也有较好的效果,当进水COD、氨氮分别为150~450、20~40mg/L时,出水COD、氨氮平均分别为53.1、1.8mg/L,MBBR—MBR串联系统对COD、氨氮的去除率平均分别为80.4%、93.1%,但系统对TN的去除效果不是很理想。     

生活垃圾催化热解液体产物特性

为探索生活垃圾催化热解液体产物特性变化规律,选取Na2CO3、CaO、Fe2O33种催化剂,利用固定床实验、红外分析(FT-IR)进行生活垃圾热解液体产物产率和组分特性研究.结果表明,热解终温600℃无催化剂时,生活垃圾热解液产率为39.80 wt％,添加3种催化剂后热解液产率均降低;生活垃圾分别添加1％的Na2CO3和CaO后,热解油氧含量由22.49％分别降低到20.12％和18.53％,低位热值由30.30 MJ/kg分别提高到33.79和32.74 MJ/kg;无催化剂时热解油成分为脂肪类、含氧化合物及少量芳香类混合物,加催化剂后热解油中芳香类物质峰面积比例显著增加,而含氧化合物峰面积比例降低,羟基类及羧酸类含氧化合物峰面积比例明显减少,其他含氧物峰面积比例却增加;CaO催化效果较明显,生活垃圾添加1％的CaO热解油中芳香类物质峰面积比例从4.36％增加到29.46％,含氧化合物峰面积比例由49.42％降低到23.12％,其中羟基类和羧酸类化合物峰面积比例分别由34.03％和10.65％降低到0.00％和3.34％,其他含氧化合物峰面积比例由4.73％增加到19.77％.