Advanced oxidation treatment of physico-chemically pre-treated olive mill industry effluent

In this study, the applicability of physico-chemical methods was investigated for the pre-treatment of the olive mill effluents prior to the discharge into the common sewerage ending with a municipal wastewater treatment plant. The samples were taken from an olive oil industry operated as three-phase process located in Turkey. Various pre-treatment methods including acid craking, polyelectrolyte and lime additions were applied. Advanced oxidation study using Fenton's process was also investigated following pre-treatment by acid cracking and cationic polyelectrolyte. Acid cracking alone gave satisfactory treatment efficiencies and polyelectrolite additions to the acid-cracked samples enhanced treatment efficiency. Since a complete treatment plant is available at the end of the sewer system, results indicated that the effluents of the investigated industry could be discharged into the municipal sewerage in the case of total chemical oxygen demand (COD_tot), suspended solid (SS) and volatile suspended solid (VSS) concentrations according to the Turkish Water Pollution Control Regulation after pre-treatment with 5 ppm anionic polyelectrolyte following acid cracking. The minimum COD_tot, SS and VSS removals were observed when raw wastewater was pre-treated with lime and the discharge standards to the municipal sewer system could not be met. Advanced oxidation with Fenton's process was applied after acid cracking and cationic polyelectrolyte treatment in order to investigate further reduction in chemical oxygen demand (COD) concentration for minimizing the influence of this industrial discharge on the existing municipal wastewater treatment plant. Results indicated that COD_tot removal increased up to 89% from 74% after Fenton's oxidation for the acid cracked samples in which cationic polyelectrolite (10 ppm) was added.     

Bioconversion of wastes from olive oil industries by vermicomposting process using the epigeic earthworm Eisenia andrei

The present work evaluates the possible bioconversion of wet olive cake by low-cost biostabilization (vermicomposting process). Wet olive cake fresh (WOC), precomposted (WOCP), or mixed with biosolids (WOCB), were vermicomposted for 6 months to obtain organic amendments for agricultural and remediation purposes. The results showed initial differences depending on previous treatment. WOCP was initially more stable, presented a low C:N ratio, and showed more dehydrogenase and urease activity. By contrast, there was no dehydrogenase activity initially in WOC and WOCB, due to the presence of some different types of polyphenols. Finally, the end product showed relatively higher amounts of total nitrogen and humic acid and met the standard of quality for composts and vermicomposts for use both in conventional and organic agriculture and soil-restoration programs.     

响应面法优化克浅十油田废水的混凝沉淀工艺

以克浅十污水处理站原水为研究对象,采用混凝沉淀工艺,探讨优选出的复配混凝剂投加量、助凝剂投加量及静置时间对原水中浊度和总铁去除效果的影响.应用Box-Behnken中心组合实验和响应面分析法,建立混凝剂对处理原水的二次多项式数学模型,确定了混凝沉淀去除原水浊度和总铁的优化工艺参数分别为:复配混凝剂投加量为152.15 mg/L、143.84 mg/L,助凝剂投加量为4.14 mg/L、4.32 mg/L,静置时间为11.77 min、11.22 min.在此工艺条件下回归方程得到的浊度和总铁的去除率预测值与实验值接近,且拟合性良好,误差介于3％～5％之间.通过均值内插法,对比浊度和总铁的多元二次回归方程,推导得出的2组最佳工艺条件均能满足浊度和总铁的去除要求.     

罐底含油污泥萃取溶剂的选择与优化

针对某炼化企业在石油储运过程中产生的罐底油泥,进行了油泥样分析和不同萃取剂萃取回收油分实验.经分析该罐底油泥含水率约16.1％,总有机物含量约34.8％,其中可萃取石油类物质约占总有机物成分的67.0％.考察不同溶剂的萃取效果,结果表明,石脑油90 ～ 110℃沸程段的馏分油的萃取效果和工艺可操作性优越于其他常用溶剂,其萃取效果排序为石脑油90～ 110℃沸程段的馏分油＞120#溶剂油＞正庚烷＞石油醚(90 ～ 120℃)＞石油醚(60 ～ 90℃);用石脑油90 ～ 110℃沸程段的馏分油在优化萃取工艺条件下,经两次萃取可分离出大于96％的可萃取油分,罐底油泥中有机物的萃出率可达64％以上,比120#溶剂油萃取效果高出约3％～5％,实现了罐底油泥更深程度的萃取和资源化利用.     

基于GA-BP算法的含油污泥处理 工艺参数优化

在含油污泥进行资源化处理过程中,针对处理目标受多个因素影响的实际,为了解决工艺之间的耦合问题,采用正交实验的方法来解决,并把主要参数作为优化对象,把含油污泥的脱水率作为评价目标,通过采用GA-BP算法对含油污泥耦合工艺正交实验参数进行了线性与非线性分析.在采用遗传算法优化神经网络的权值和阈值的基础上,用优化后的权值和阈值对测试样本和训练样本进行了预测.预测结果表明,预测误差都有明显减小,分别由0.34211减少到0.031549和0.15476减少到0.040682,可见耦合参数趋向于非线性优化.     

废轮胎热解衍生油非加氢脱硫

衍生油是废轮胎热解过程中最重要的产品之一,其最有意义的一种用途是作为燃料来得到较高的附加值.但是衍生油的硫含量较高,且具有恶臭味道,妨碍了它作为燃料的广泛应用.在管式反应器上分别考察了氧化锌、混合脱硫剂、A.D.A和MDEA+环丁砜法对废轮胎高温热解气的非加氢脱硫效果,并对不同的脱硫工艺作了简要的经济评价.结果发现,白土、陶土和石灰粉混合脱硫剂与氧化锌的热解气直接脱硫效果较好,衍生油的硫含量可降低到0.11％左右.采用油气分离的A.D.A脱硫工艺最经济.     

改性油页岩灰渣对水中DNBP吸附去除效果

采用PDMDAAC改性方法对油页岩灰渣进行改性,确定最佳改性方案,并研究了环境因素对改性油页岩灰渣吸附DNBP的影响。实验研究结果表明,油页岩灰渣经20 g/L 的PDMDAAC处理时,对DNBP的吸附能力最强。在吸附温度为30℃,初始溶液pH值为4的条件下,0.3 g 的改性油页岩灰渣对30.0 mg/L DNBP溶液50 mL,吸附120 min时,其吸附率达到94.48%以上。在实验条件下,改性油页岩灰渣对DNBP的吸附符合Langmuir和Freundlich等温吸附方程,相关系数分别为0.9985和0.9776,其对DNBP的理论饱和吸附量达到6.196 mg/g。改性油页岩灰渣对DNBP的吸附主要归因于离子交换和表面吸附作用。     

稠油废水破乳剂的研究进展

介绍了稠油废水的来源、特点和乳化成因,综述了稠油废水破乳剂的研究进展,分析了不同破乳剂的破乳机理和优缺点,并对破乳剂的发展方向进行了展望和建议。     

浅谈突发溢油事件应急处置技术及装置的应用

概述了海洋溢油应急处置的技术方法,分析了溢油应急处置装置设备的应用特点,为海洋溢油应急处置工作提供理论依据。     

葡萄酒副产品深度利用的研究进展

介绍了葡萄皮渣、葡萄籽、酒脚的深度利用途径：葡萄皮渣可用于酿酒、酿醋、提取色素和多酚、吸附重金属;葡萄籽可以提取葡萄籽油、葡萄籽蛋白和抗氧化物质;酒脚可以提取酒石酸盐。开展葡萄酒副产品的深度利用,不仅可以获得良好的经济效益,而且可有效减轻环保压力,获得巨大的社会效益。