低温低浊微污染水源水预氧化处理工艺设计

选用预氧化处理工艺以提高混凝絮凝效果,减少停留时间从而实现在小型设备中较高的处理量;占地面积小且速度快的气浮池代替了普通的沉淀池,并在混凝沉淀处理药剂和消毒处理药剂上选择了在低温条件下效果好的.     

火电厂烟道的优化分析

以某电厂2×1 000 MW机组的引增段烟道为例,基于CFD模拟软件开展了烟道系统的优化分析,优化后降低了系统压损122 Pa,年节约运行费用约35万元,投资回收期为0.57 a。优化后的方案较原方案大大降低了系统的磨损及振动,有利于电厂的安全可靠运行。     

臭氧对有机物混凝的影响

采用PDA(Photometric Disperse Analysis)和有机物表观分子量分级、有机物化学极性分级技术从絮体形成过程、絮体表现、有机物分子水平变化等方面研究了臭氧预氧化对混凝过程的影响;并对比了不同混凝剂在预臭氧条件下的混凝过程和效率.结果表明:臭氧预氧化对混凝过程有复杂的影响,其剂量和水体有机物特征决定了其对混凝的整体影响效果.有机物分级显示,臭氧化对有机物结构有重要影响,导致有机物极性、亲水性组分含量大幅提高(36.7%),小分子量组分(<10×10³)大幅增高(100%左右);但总的DOC去除率不高(3.28%).对PACl而言,在中、低剂量(O₃/TOC<0.7)下,臭氧对絮体形成过程影响较小,但对絮体沉降性和浊度去除已经有阻碍作用.在中、高剂量下(O₃/TOC>0.7),对絮体形成有显著滞后,浊度、有机物去除效率下降.AlCl₃对臭氧化作用反应敏感,臭氧化在试验剂量条件下,对絮体形成和浊度、有机物去除都有明显的阻碍作用.     

舟山高浊度海水混凝除浊研究

测定了舟山高浊度海水悬浮物的粒度分布,分析了高浊度海水自由沉降特性,选用氯化铁(FeCl)3、聚合氯化铁(PFC)、聚合硫酸铁(PFS)3种混凝剂,利用正交试验方法对高浊度海水进行混凝沉淀对比试验,采用极差分析方法研究了影响混凝效果的因素。试验结果表明:舟山海域悬浮物组成以粉砂为主,用自然沉降的方法是很难去除;各因素对浊度去除率影响的主次顺序均为:慢搅时间>慢搅速度>快搅时间>快搅速度;对于高浊度海水混凝除浊最佳水力条件为:快搅时间为2 min,快搅速度为300 r/min,慢搅时间为15 min,慢搅速度为60 r/min;聚合硫酸铁是较理想的絮凝剂,最佳投药量范围在15～25 mg/L,对浊度去除率高达99%以上。     

Removal and transformation of organic matters in domestic wastewater during lab-scale chemically enhanced primary treatment and a trickling filter treatment

To find a simple and economical way for treating the domestic wastewater in small counties and towns, a process combining chemically enhanced primary treatment and a trickling filter (CEPT-TF, representing the physical and biological effects) was constructed and operated in laboratory conditions. The characteristic behaviors of dissolved organic matter in raw wastewater and effluents were examined during steady-state operation. Experimental results showed that the process of CEPT and TF in series was beneficial for the removal of hydrophobic and hydrophilic organics. Specially, the hydrophobic and aromatic materials could be preferentially removed in the CEPT unit, and the hydrophilic fraction in the TF. Structural changes of the organic fractions during the operation of the different units were also characterized via spectrum analysis.     

Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

Evaluation of reusing alum sludge for the coagulation of industrial wastewater containing mixed anionic surfactants

A coagulation-flocculation process is typically employed to treat the industrial wastewater generated by the consumer products industry manufacturing detergents, soaps, and others. The expenditure of chemicals including coagulants and chemicals for pH adjustment is costly for treating this wastewater. The objective of this study was to evaluate the feasibility of reusing the aluminum sulfate (alum) sludge as a coagulant or as a coagulation aid so that the fresh alum dosage can be minimized or the removal e ciency can be enhanced. The experiments were conducted in a jar-test apparatus simulating the coagulation-flocculation process for simultaneous removals of organic matters, anionic surfactants, suspended solids, and turbidity. At the optimum initial pH value of 10 and the fresh alum concentration of 400 mg/L, the total suspended solids (TSS), total chemical oxygen demand (TCOD), total anionic surfactants, and turbidity removal e ciencies were 71.5%, 76.4%, 95.4%, and 98.2%, respectively. The addition of alum sludge as a coagulant alone without any fresh alum addition could significantly remove the turbidity, TCOD, and anionic surfactants. The TSS was left in the supernatants after the settling period, but would subsequently be removed by adding the fresh alum. The TSS, TCOD, and turbidity removal e ciencies were also enhanced when both the alum sludge and the fresh alum were employed. The TCOD removal e ciency over 80% has been accomplished, which has never fulfilled by using the fresh alum alone. It is concluded that the alum sludge could be reused for the treatment of industrial wastewater generated by the consumer products industry.     

原水性质对新型含Ca2+复合混凝剂混凝过程的影响

为了提高水处理效率,保证出水水质,需要开发新型高效混凝剂.本实验采用经过Ca2+改性的混凝剂针对不同水样进行混凝实验,考察了浊度、有机物去除、余铝和形成絮体性质.结果表明在纯颗粒物体系中,PACl(聚合氯化铝)和Al Cl3中加入的Ca2+对于浊度去除率无明显影响,在低投加量下能够有效降低沉后水中余铝浓度,Al Cl3做混凝剂,投加量0.10mmol·L~(-1)时,沉后水余铝浓度从0.15 mg·L~(-1)降低到0.10 mg·L~(-1).在腐殖酸体系中,混凝剂中的钙离子可明显降低腐殖酸分子的负电荷,降低沉后水余铝浓度以及增大絮体粒径.对于腐殖酸与蛋白质体系,当投加量为0.16 mmol·L~(-1)时,使用含有Ca2+的PACl做混凝剂时,钙离子的存在使得平衡时絮体粒径增加了大约50μm,可明显改善絮体的沉降性.碱性条件(pH=8.5)下改性混凝剂沉后水中DOC浓度降低0.2~0.6 mg·L~(-1),余铝降低0.4~0.7 mg·L~(-1).酸性条件(pH=5.5)下改性混凝剂沉后水DOC、余铝浓度无明显变化.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

壳聚糖复合粘土矿凝聚铜绿微囊藻的研究

对壳聚糖与天然粘土矿物海泡石复配凝聚水体中铜绿微囊藻进行了研究 ,结果表明 :在壳聚糖用量为0 5 6mg L、海泡石用量为 32mg L的情况下 ,藻个数由 1 94 4× 10 6 个 mL降为 1 38× 10 3个 mL ,去除率达到 99 93% ;浊度由 6 5NTU降到 0 1NTU ,去除率达 99 6 % ;叶绿素a去除率达 10 0 % (用常规方法无法检测到 )。实验还确定了最佳pH值范围是 4～ 8;并且探讨了壳聚糖的絮凝机理。