Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

壳聚糖复合粘土矿凝聚铜绿微囊藻的研究

对壳聚糖与天然粘土矿物海泡石复配凝聚水体中铜绿微囊藻进行了研究 ,结果表明 :在壳聚糖用量为0 5 6mg L、海泡石用量为 32mg L的情况下 ,藻个数由 1 94 4× 10 6 个 mL降为 1 38× 10 3个 mL ,去除率达到 99 93% ;浊度由 6 5NTU降到 0 1NTU ,去除率达 99 6 % ;叶绿素a去除率达 10 0 % (用常规方法无法检测到 )。实验还确定了最佳pH值范围是 4～ 8;并且探讨了壳聚糖的絮凝机理。     

阳离子染料废水处理的工艺研究

首先采用两级物化－电解－吸附工艺对高浓度阳离子染料生产废水进行预处理,再与低浓度生产废水、生活污水混合生化处理,总脱色率和CODcr去除率均可达到99．9％以上,达标排放。     

钢铁企业废水污染物形态分析及混凝深度处理试验研究

利用过滤试验与粒径分布试验分析了钢铁工业达标外排废水的各类污染物特征,结合正交试验对混凝处理效果及混凝工艺中各主要影响因素的影响情况进行研究。结果表明,废水中颗粒物主要以粗分散胶体和悬浮态物质为主,PAC／PAM联用对钢铁废水具有较好的处理效果,可有效降低主要影响废水回用的铁锰类污染物,还去除了大部分的有机物及磷类等污染物,各项出水水质指标均达到《城市污水再生利用工业用水水质》（GB／T19923—2005）所规定的循环冷却水回用水质标准。     

高含水油泥调质脱稳用剂

高含水油泥主要来自于页岩气田、油气田和炼厂的污水处理场（站）,含水率一般高达90%以上,成分复杂、乳化严重,是性质稳定的多相体系。破胶脱稳是高含水油泥处理处置与利用的前提,也是减量化的瓶颈,其核心是调质脱稳用剂的优选。介绍了高含水油泥的性质及调质脱稳的原理和方法,阐述了高含水油泥调质脱稳用剂的研究及应用现状,总结了助滤剂、氧化剂、电解质、破乳剂、絮凝剂和微乳化剂等常用药剂的调质机理、适应范围、研究实例和优缺点,并提出了调质脱稳用剂未来的发展方向。     

原水性质对新型含Ca2+复合混凝剂混凝过程的影响

为了提高水处理效率,保证出水水质,需要开发新型高效混凝剂.本实验采用经过Ca2+改性的混凝剂针对不同水样进行混凝实验,考察了浊度、有机物去除、余铝和形成絮体性质.结果表明在纯颗粒物体系中,PACl(聚合氯化铝)和Al Cl3中加入的Ca2+对于浊度去除率无明显影响,在低投加量下能够有效降低沉后水中余铝浓度,Al Cl3做混凝剂,投加量0.10mmol·L~(-1)时,沉后水余铝浓度从0.15 mg·L~(-1)降低到0.10 mg·L~(-1).在腐殖酸体系中,混凝剂中的钙离子可明显降低腐殖酸分子的负电荷,降低沉后水余铝浓度以及增大絮体粒径.对于腐殖酸与蛋白质体系,当投加量为0.16 mmol·L~(-1)时,使用含有Ca2+的PACl做混凝剂时,钙离子的存在使得平衡时絮体粒径增加了大约50μm,可明显改善絮体的沉降性.碱性条件(pH=8.5)下改性混凝剂沉后水中DOC浓度降低0.2~0.6 mg·L~(-1),余铝降低0.4~0.7 mg·L~(-1).酸性条件(pH=5.5)下改性混凝剂沉后水DOC、余铝浓度无明显变化.     

Evaluation of reusing alum sludge for the coagulation of industrial wastewater containing mixed anionic surfactants

A coagulation-flocculation process is typically employed to treat the industrial wastewater generated by the consumer products industry manufacturing detergents, soaps, and others. The expenditure of chemicals including coagulants and chemicals for pH adjustment is costly for treating this wastewater. The objective of this study was to evaluate the feasibility of reusing the aluminum sulfate (alum) sludge as a coagulant or as a coagulation aid so that the fresh alum dosage can be minimized or the removal e ciency can be enhanced. The experiments were conducted in a jar-test apparatus simulating the coagulation-flocculation process for simultaneous removals of organic matters, anionic surfactants, suspended solids, and turbidity. At the optimum initial pH value of 10 and the fresh alum concentration of 400 mg/L, the total suspended solids (TSS), total chemical oxygen demand (TCOD), total anionic surfactants, and turbidity removal e ciencies were 71.5%, 76.4%, 95.4%, and 98.2%, respectively. The addition of alum sludge as a coagulant alone without any fresh alum addition could significantly remove the turbidity, TCOD, and anionic surfactants. The TSS was left in the supernatants after the settling period, but would subsequently be removed by adding the fresh alum. The TSS, TCOD, and turbidity removal e ciencies were also enhanced when both the alum sludge and the fresh alum were employed. The TCOD removal e ciency over 80% has been accomplished, which has never fulfilled by using the fresh alum alone. It is concluded that the alum sludge could be reused for the treatment of industrial wastewater generated by the consumer products industry.     

混凝-超滤处理径流雨水效果——以华南地区为例

采用超滤膜(UF)为核心,以混凝作为预处理措施,对混凝-超滤工艺处理径流雨水的特性和膜通量变化与污染现象进行了研究,并对聚合硫酸铁(PFS)单独混凝、UF、PFS-UF组合工艺进行了对比;在优化混凝基础上,考察了混凝-UF对常规水质指标及总磷、生物可同化有机碳(AOC)、可生物降解溶解性有机碳(BDOC)等生物稳定性指标的去除效果.结果表明,混凝可有效去除TOC、UV254和总磷,混凝剂投加量与污染物去除近似呈线性关系.各混凝剂除浊效能均良好.综合考虑混凝处理效率与经济性,实验采用混凝方案为10 mg·L-1的PFS.PFS、UF、PFS-UF工艺除浊率均在95%以上,PFS和UF对TOC和UV254的去除较为接近,采用PFS-UF可提高去除率13%—15%;PFS-UF处理后雨水的AOC、BDOC分别降低至61.8μg·L-1、0.19 mg·L-1,残余总磷可降至3.8μg·L-1,雨水生物稳定性明显提高.PFS、UF和PFS-UF对颗粒物的去除率分别达80.5%、99.6%和99.9%.膜通量的变化和SEM图分析表明,混凝在一定程度上减轻了UF膜污染;形成的凝胶层具有一定整体强度,水力清洗时易于清除,膜通量恢复较好;但同时凝胶层的产生也增大了透膜阻力,PFS-UF工艺的周期内膜通量衰减有增加的趋势.     

聚合铝的凝聚絮凝特征及作用机理

采用不同碱化度B(OH/Al)值的聚合铝和AlCl_3对高岭土悬浊液进行凝聚絮凝实验,同时测定电泳度及表面吸附特征,结合不同铝盐的化学形态分布,探讨聚合铝的高效凝聚作用原理.并求得表面吸附覆盖率,电位变化与形态分布间的定量关系,绘出聚合铝的凝聚区域图,对阐明聚合铝的作用机理提供了实验依据.     

臭氧对有机物混凝的影响

采用PDA(Photometric Disperse Analysis)和有机物表观分子量分级、有机物化学极性分级技术从絮体形成过程、絮体表现、有机物分子水平变化等方面研究了臭氧预氧化对混凝过程的影响;并对比了不同混凝剂在预臭氧条件下的混凝过程和效率.结果表明:臭氧预氧化对混凝过程有复杂的影响,其剂量和水体有机物特征决定了其对混凝的整体影响效果.有机物分级显示,臭氧化对有机物结构有重要影响,导致有机物极性、亲水性组分含量大幅提高(36.7%),小分子量组分(<10×10³)大幅增高(100%左右);但总的DOC去除率不高(3.28%).对PACl而言,在中、低剂量(O₃/TOC<0.7)下,臭氧对絮体形成过程影响较小,但对絮体沉降性和浊度去除已经有阻碍作用.在中、高剂量下(O₃/TOC>0.7),对絮体形成有显著滞后,浊度、有机物去除效率下降.AlCl₃对臭氧化作用反应敏感,臭氧化在试验剂量条件下,对絮体形成和浊度、有机物去除都有明显的阻碍作用.