Carrousel氧化沟的三维流场模拟与分析

利用CFD的Fluent软件,采用标准的三维K—ε紊流模型,对桂林市七里店污水处理厂1#氧化沟的流场进行了数值模拟,对导流墙和推进器附近的流速进行了计算分析。结果表明,氧化沟下层流速较低,局部区域流速低于0．2m／s。为了防止污泥沉降,应进一步降低推进器位置。能量损失分析表明,卡罗塞氧化沟能量损失主要来源于沿程摩擦损失和局部损失。可通过增加墙体光滑度、降低入口高度以及增加导流墙的曲率半径等措施减少能量损失,改善现有氧化沟的水力特征。     

微波诱导鳞片石墨-H2O2催化氧化处理甲基紫废水

研究微波诱导鳞片石墨-H2O2催化氧化处理甲基紫废水工艺,探讨各种因素的协同作用及对废水脱色效果的影响,并采用SEM、EDX、XRD和FTIR对新鲜及使用6次后的鳞片石墨进行表征。结果表明,微波诱导鳞片石墨-H2O2能高效快速降解废水中的甲基紫;在50mL初始pH为3,质量浓度为10mg／L的甲基紫废水中,H2O2用量1mL／L,鳞片石墨3g／L,微波输出功率259W,微波辐射时间9min的最佳处理工艺条件下,甲基紫脱色率达到了98．80％;微波、鳞片石墨、H2O2体系对甲基紫废水降解效果明显,产生协同效应。紫外-可见光谱分析表明,废水中甲基紫结构被破坏,但仍含有少量苯环等小分子。动力学研究表明,脱色反应符合一级反应动力学规律,反应速率常数^为0．42613min^-1,反应半衰期t。为1．626min。     

紫外催化湿式双氧水氧化处理化学镀铜废液

利用化学镀铜废液自身含有的铜作为催化剂,应用紫外催化湿式双氧水氧化工艺处理化学镀铜废液取得了良好效果。通过单因素实验确定的推荐工艺条件为：pH=2.0（保持原始值不变）;不额外投加铜催化剂;H₂O₂用量为2倍理论量。在此条件下处理化学镀铜废液180 min,COD去除率可达到96.6%;之后采用沉淀法回收铜,调节处理后废水pH到9.5,铜的回收率可达到99.8%。     

亚铁离子生物氧化-还原法连续脱除硫化氢

为了降低工业废气中的硫化氢去除工艺成本和运行费用,对三价铁盐吸收与氧化亚铁硫杆菌对Fe²⁺的生物氧化联合作用脱除H₂S进行了研究。通过生物氧化塔中的固定化氧化亚铁硫杆菌细胞再生的Fe³⁺溶液,在H₂S还原吸收塔中脱除H₂S。通过单因素实验分别优化了生物氧化塔和H₂S吸收塔的运行参数,在生物氧化塔曝气量为150 L/h,停留时间为11 h,吸收液中Fe³⁺浓度为0.121~0.143 mol/L,吸收液流量为0.3 L/h,进气量为100 L/h条件下,进气中H₂S浓度分别为2.28和9.11 mg/L,系统连续运行至200 min时趋于相对稳定,当系统连续运行稳定时,H₂S的脱除率可分别达到95%和91%,脱除效果显著。     

Mn的氧化价态对Mn/γ-Al2O3催化剂催化臭氧氧化气相低浓度甲苯的影响

采用共沉淀法,以Al₂O₃为载体制备Mn/γ-Al₂O₃和Mn-Ce/γ-Al₂O₃催化剂,并分别在N₂气氛和O₂气氛下焙烧。采用固定床连续流动反应器,研究所制备催化剂在室温条件下催化臭氧氧化甲苯的性能。通过XRD、XPS和FTIR等手段对催化剂的结构和组成进行表征。结果表明,Mn/γ-Al₂O₃催化剂具有良好的催化臭氧氧化甲苯和催化臭氧自身分解的性能,共沉淀法制备催化剂的最佳Mn负载量为20%。O₂气氛焙烧和Ce的加入,可以有效提高催化剂的活性和寿命。原因是O₂气氛焙烧和Ce的加入可以提高Mn的氧化价态。催化剂失活的主要原因是有机副产物在催化剂表面吸附堆积,失活催化剂在550℃、空气气氛下焙烧可恢复催化性能。     

Characterization of CANON reactor performance and microbial community shifts with elevated COD/N ratios under a continuous aeration mode

COD/N at low ratios (0–0.82) improved N removals of CANON. CANON performance decreased after COD/N up to 0.82. The relative abundance of AOB decreased continuously with increasing COD/N. AOB outcompeted at a high COD load led to CANON failure. The relative abundance of AnAOB decreased and increased with increasing COD/N. The effects of increasing COD/N on nitrogen removal performance and microbial structure were investigated in a SBR adopting a completely autotrophic nitrogen removal over nitrite process with a continuous aeration mode (DO at approximately 0.15–0.2 mg/L). As the COD/N increased from 0.1 to≤0.59, the nitrogen removal efficiency (NRE) increased from 88.7% to 95.5%; while at COD/N ratios of 0.59–0.82, the NRE remained at 90.7%–95.5%. As the COD/N increased from 0.82 to 1.07, the NRE decreased continuously until reaching 60.1%. Nitrosomonas sp. (AOB) and Candidatus Jettenia (anammox bacteria) were the main functional genera in the SBR. As the COD/N increased from 0.10 to 1.07, the relative abundance of Nitrosomonas decreased from 13.4% to 2.0%, while that of Candidatus Jettenia decreased from 35% to 9.9% with COD/N<0.82 then increased to 45.4% at a COD/N of 1.07. Aerobic heterotrophic bacteria outcompeted AOB at high COD loadings (650 mg/L) because of oxygen competition, which ultimately led to deteriorated nitrogen removal performance.     

Elimination of antibiotic resistance genes and control of horizontal transfer risk by UV-based treatment of drinking water: A mini review

Antibiotic-resistant bacteria and antibiotic resistance genes are in water bodies. UV/chlorination method is better to remove ARGs than UV or chlorination alone. Research on UV/hydrogen peroxide to eliminate ARGs is forthcoming. UV-based photocatalytic processes are effective to degrade ARGs. Antibiotic-resistant bacteria (ARB) and antibiotic resistance genes (ARGs) have been recognized as one of the biggest public health issues of the 21st century. Both ARB and ARGs have been determined in water after treatment with conventional disinfectants. Ultraviolet (UV) technology has been seen growth in application to disinfect the water. However, UV method alone is not adequate to degrade ARGs in water. Researchers are investigating the combination of UV with other oxidants (chlorine, hydrogen peroxide (H₂O₂), peroxymonosulfate (PMS), and photocatalysts) to harness the high reactivity of produced reactive species (Clž·, ClOž·ž, Clž₂·ž⁻, žž·OH, and SOž₄ž·⁻€) in such processes with constituents of cell (e.g., deoxyribonucleic acid (DNA) and its components) in order to increase the degradation efficiency of ARGs. This paper briefly reviews the current status of different UV-based treatments (UV/chlorination, UV/H₂O₂, UV/PMS, and UV-photocatalysis) to degrade ARGs and to control horizontal gene transfer (HGT) in water. The review also provides discussion on the mechanism of degradation of ARGs and application of q-PCR and gel electrophoresis to obtain insights of the fate of ARGs during UV-based treatment processes.     

臭氧氧化法处理苯酚废水的影响因素分析

将含臭氧的气体通入模拟苯酚废水,其反应过程受到很多因素的控制,比如各种反应物的投加量、投加方式、以及溶液的环境因素,如溶液pH、温度和影响反应（加速或促进）的物质存在等。文中通过实验评估各影响因素对其影响的程度,可为苯酚废水处理的实际应用提供指导和参考。     

硫化物矿山尾矿生物氧化作用的抑制研究

硫化物矿山尾矿的风化、氧化会对周围环境产生危害,研究表明,以氧化亚铁硫杆菌为代表的嗜酸氧化菌起了非常重要的作用。本研究以从广东韶关大宝山尾矿分离得到的一株氧化亚铁硫杆菌作为实验菌株,添加不同剂量的杀菌剂,分析了杀菌剂对溶液pH、Eh值的影响,及杀菌剂的Fe2+氧化抑制率和最佳使用浓度。结果显示:实验用杀菌剂SDS和CTAB能有效地抑制金属硫化物尾矿的生物氧化和酸化:ρ(SDS)为30 mg/L时Fe2+的氧化抑制率达到82.83%;ρ(CTAB)为5 mg/L时Fe2+的氧化抑制率达到80.84%,添加了杀菌剂的溶液pH、Eh基本保持初始值不变,表明杀菌剂的使用可以控制金属硫化物尾矿的酸化污染。     

组合方法去除新型采油污水中有机污染物的研究

含聚丙烯酰胺采油污水的有效处理是近年来困扰油田三次采油生产的一个难题。研究采用移动床生物膜技术与O3/UV/H2O2高级氧化技术的组合方法来处理含聚丙烯酰胺采油污水。实验结果表明,移动床生物膜技术可以有效去除污水中的石油类有机物,但对聚丙烯酰胺几乎无效果。O3/UV/H2O2高级氧化技术可以降解污水中的聚丙烯酰胺。组合方法处理后的含聚丙烯酰胺采油污水水质可以达到污水综合排放标准中的一级要求。