Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

Degradation of polyacrylamide (PAM) and methane production by mesophilic and thermophilic anaerobic digestion: Effect of temperature and concentration

• PAM degradation in thermophilic AD in comparison with mesophilic AD. • PAM degradation and its impact on thermophilic and mesophilic AD. • Enhanced methane yield in presence of PAM during thermophilic and mesophilic AD. • PAM degradation and microbial community analysis in thermophilic and mesophilic AD. Polyacrylamide (PAM) is generally employed in wastewater treatment processes such as sludge dewatering and therefore exists in the sludge. Furthermore, it degrades slowly and can deteriorate methane yield during anaerobic digestion (AD). The impact or fate of PAM in AD under thermophilic conditions is still unclear. This study mainly focuses on PAM degradation and enhanced methane production from PAM-added sludge during 15 days of thermophilic (55°C) AD compared to mesophilic (35°C) AD. Sludge and PAM dose from 10 to 50 g/kg TSS were used. The results showed that PAM degraded by 76% to 78% with acrylamide (AM) content of 0.2 to 3.3 mg/L in thermophilic AD. However, it degraded only 27% to 30% with AM content of 0.5 to 7.2 mg/L in mesophilic AD. The methane yield was almost 230 to 238.4 mL/g VSS on the 8th day in thermophilic AD but was 115.2 to 128.6 mL/g VSS in mesophilic AD. Mechanism investigation revealed that thermophilic AD with continuous stirring not only enhanced PAM degradation but also boosted the organics release from the sludge with added PAM and gave higher methane yield than mesophilic AD.     

An Analysis of Secondary Pollutants in Buenos Aires City

Air pollutant concentrations from a monitoring campaign in Buenos Aires City, Argentina, are used to investigate the relationships between ambient levels of ozone (O₃), nitric oxide (NO) and nitrogen dioxide (NO₂) as a function of NO _x (=NO + NO₂). This campaign undertaken by the electricity sector was aimed at elucidating the apportionment of thermal power plants to air quality deterioration. Concentrations of carbon monoxide (CO) and sulphur dioxide (SO₂) were also registered. Photo stationary state (PSS) of the NO, NO₂, O₃ and peroxy radicals species has been analysed. The ‘oxidant’ level concept has been introduced, OX (=O₃ + NO₂), which varies with the level of NO _x . It is shown that this level is made up of NO _x -independent and NO _x -dependent contributions. The former is a regional contribution that equates the background O₃ level, whereas the latter is a local contribution that correlates with the level of primary pollution. Furthermore, the anticorrelation between NO₂ and O₃ levels, which is a characteristic of the atmospheric photo stationary cycle has been verified.The analysis of the concentration of the primary pollutants CO and NO strongly suggests that the vehicle traffic is the principal source of them. Levels of continuous measurements of SO₂ for Buenos Aires City are reported in this work as a complement of previously published results.     

新疆番茄酱企业生产废水处理利用方式探析

近年来,新疆番茄酱加工业得到了迅速发展,目前番茄酱的产销量已占全国的90%以上。与此同时,新疆番茄酱生产企业的废水排放量也大幅增加,大量未经处理的废水直接排放,已对当地的水环境构成严重的污染隐患。本文分析了新疆番茄酱企业生产废水的排放特征与目前排放出路的可行性,并结合新疆的自然地理条件及番茄酱企业的分布情况,着重探讨了土地处理这一适合新疆的废水利用方式,以期有利于新疆的环境保护和废水资源的循环利用。     

受污染原水中有机物去除中试集成系统的工艺对比研究

在中试集成系统水平上对比研究了常规工艺、预臭氧化工艺、粒状活性炭吸附工艺、臭氧-生物活性炭工艺对受污染源水中的有机物及消毒副产物前体的去除效果.结果表明,前2种工艺对有机物的去除效能大致在50%～60%,后2种则能达到75%～90%.与前2种相比,后2种为更有效地去除受污染原水中有机物的方法.建议采用Ⅱ类及更优水体为水源的水厂考虑使用常规处理或季节性水质变化时采用预氧化工艺;而对于那些以Ⅲ类或更差水体为主水源的水厂则应考虑增设GAC或BAC设备,以满足饮用水水质新标准要求.     

操作条件对超滤膜运行经济稳定性能的影响

采用正交实验的方法对棕榈油生产废水二级处理出水的超滤工艺条件进行考察和优化,并用膜通量衰减系数、平均跨膜压差及产水量各自加权相加所得综合指标来表征不同超滤操作条件下膜运行的经济稳定性能。正交试验结果表明,减小膜表面流速和产水率,提高处理废水温度均有利于系统经济稳定地运行;各运行参数对综合指标影响的大小顺序为:膜表面平均流速>产水率>温度;在保证出水质量的前提下,最佳组合操作条件为膜表面平均流速0.7m/s,产水率80%,废水温度30℃。     

生物膜填料塔SO2废气净化性能研究

采用生物膜填料塔净化SO2废气,研究结果表明:当气体流量从100L/h增加到300L/h时,SO2净化效率由86.4%下降到73.2%;生化去除量随着入口SO2气体浓度的升高而增大;随着温度的升高,SO2净化效率和生化去除量都随之提高,且20℃以上时,净化效率可达90.9%以上,生化去除量可达75 mg/L·h以上,更利于微生物降解SO2.     

改良倒置A2/O工艺设计

在目前广泛采用的AO、A2O、倒置A2O等工艺的基础上,为提高脱氮除磷效率,提出改良倒置A2O工艺。并对其工艺的特点、设计和脱氮除磷效率进行了详细的研究和分析。     

喷淋环栅式除尘脱硫反应器的数学模拟

研制了一种由内外圈构成的喷淋环栅式除尘脱硫反应装置,气、液两相在内外圈之间通向运动,紊流冲激环栅时接触传质。基于溶质渗透理论,提出了以内塔穿孔速率V,液气比L/G,吸收浆液pH值为参数的脱硫效率模型。对比某电厂工况条件下测得的一系列实验数据,显示出该模型与实际情况具有良好的一致性,表明该模型可以用来作为工程设计、最优化技术和推测工业数据的理论参考工具。     

The Interactive Effects of Fire and Diversity on Short-Term Responses of Ecosystem Processes in Experimental Mediterranean Grasslands

We conducted a field experiment using constructed communities to test whether species richness contributed to the maintenance of ecosystem processes under fire disturbance. We studied the effects of diversity components (i.e., species richness and species composition) upon productivity, structural traits of vegetation, decomposition rates, and soil nutrients between burnt and unburnt experimental Mediterranean grassland communities. Our results demonstrated that fire and species richness had interactive effects on aboveground biomass production and canopy structure components. Fire increased biomass production of the highest-richness communities. The effects of fire on aboveground biomass production at different levels of species richness were derived from changes in both vertical and horizontal canopy structure of the communities. The most species-rich communities appeared to be more resistant to fire in relation to species-poor ones, due to both compositional and richness effects. Interactive effects of fire and species richness were not important for belowground processes. Decomposition rates increased with species richness, related in part to increased levels of canopy structure traits. Fire increased soil nutrients and long-term decomposition rate. Our results provide evidence that composition within richness levels had often larger effects on the stability of aboveground ecosystem processes in the face of fire disturbance than species richness per se.