超声清洗MBR生物膜--臭氧化技术在中水回用中的应用

超声清洗MBR生物膜-臭氧化技术,是在传统的二级生化污水处理技术的基础上,采用膜生物技术、臭氧化工艺和现代超声波清洗膜元件技术,进行生活污水回用处理的新兴技术.膜生物(MBR)技术具有出水水质好,一次性投资低,占地面积小,运行费用低等优点;利用现代超声波技术清洗膜元件,既可以彻底清除粘附在膜内、外壁上的污染物,又可以避免化学清洗对膜造成的危害,及清洗剂对环境的污染;采用臭氧化工艺,利用臭氧的强氧化性,可以彻底消除细菌、臭味、色度等可能对回用人群造成的危害,使处理后的水成为真正安全的回用水.     

几种螯合剂对污染土壤的重金属提取效率的研究

在Cd,Pb污染的土壤上,采用批提取实验(batchexperiment),研究了几种螯合剂和不同的水土比对重金属提取效率的影响。结果表明:螯合剂对Cd的提取效率随着各淋洗剂浓度的提高而逐渐提高,相同浓度下各淋洗剂的提取效率大小顺序依次为EDTA>DTPA>NTA>PA>CA>CD>HCl。随水土比提高,相应的提取效率也提高。几种淋洗剂中只有EDTA对Pb和Cd都能达到理想的淋洗效果。     

Laboratory scale studies on removal of chromium from industrial wastes

Chromium being one of the major toxic pollutants is discharged from electroplating and chrome tanning processes and is also found in the effluents of dyes,paint pigments,manufacturing units etc.Chromium exists in aqueous systems in both trivalent(Cr^3 )and hexavalent (Cr^6 )forms.The hexavalent form is carcinogenic and toxic to aquatic life,whereas Cr^3 is however comparatively less toxic.This study was undertaken to investigate the total chromium removal from industial effluents by chemical means in order to achieve the Pakistan NEQS level of 1 mg/L by the methods of reduction and precipitation.The study was conducted in four phase Ⅰ,the optimum pH and cost effective reducing agent among the four popular commercial chemicals was selected.As a result,pH of 2 was found to be most suitable and sodium meta bisulfate was found to be the most cost effective reducing agent respectively.Phase Ⅱ showed that lower dose of sodium meta hisulfate was sufficient to obtain 100% efficiency in reducing Cr^6 to Cr^3 ,and it was noted that reaction time had no significance in the whole process.A design curve for reduction process was established which can act as a tool for treatment of industrial effluents.Phase Ⅲ studies indicated the best pH was 8.5 for precipitation of Cr^3 to chromium hydroxide by using lime.An efficiency of 100% was achievable and a settling time of 30 minutes produced clear effluent.Finally in Phase Ⅳ actual waste samples from chrome tanning and electroplating industries,when precipitated at pH of 12 gave 100% efficiency at a settling time of 30 minutes and confirmed that chemical means of reduction and precipitation is a feasible and viable solution for treating chromium wastes from industries.     

Effects of temperature and discharge parameters on ozone concentration of negative corona discharge

The relationship of the ozone generation and the heating power, corona wire surface temperature, discharge electrode and netting electrode was studied during the negative corona discharge. The experimental results showed that the ozone concentration reduced with applied voltage decrease. With heating power increase, the ozone concentration of unit current decreased at exponential rate and it almost change no longer over 0.40 W. Under given temperature, the lower the applied voltage was, the smaller the ozone concentration was; while under given applied voltages, only over 11 kV could decrease with the surface temperature increase. The ozone concentration decreased with the lengthening of corona wire, and could reduced to 10 ppb under experimental condition of 14.2 kV; it also decreased with the shortening of wire diarmeter,and could decrease 67% at best in the given condition. Moreover, it decreased with the increasing size of netting electrode mesh. At the anion current of 1.65 μA, the ozone concentration of 5.0 x 5.0 cm^2 is only 41% of that of 3.3 x 3.3 cm^2 .     

制糖工业废水CODcr和BOD_5相关性探讨

在制糖工业废水的监测中 ,CODcr和BOD5均与水体的有机物有密切联系 ,且它们之间还存在一定的比例关系。通过对多组数据的相关性分析 ,确定以甘蔗为原料的制糖废水 ,CODcr和BOD5之间存在一定的相关性 ,可以通过CODcr值估算BOD5的值     

多管旋风除尘器热态除尘效率的影响因素

根据对多管旋风除法器热态除尘效率大量测试实践，讨论了影响多管风除尘器除尘效率的制造质量，整体安装要求、运行管理及锅炉运行等因素，建议在应用推广中应予以重视。     

离心脉冲静电除尘模型的除尘性能实验研究

介绍了一种直筒式离心脉冲静电除尘器，研究了其除尘效率与入口风速，直流基础电压，入口粉尘浓度等操作因素的关系；测定了在不同入口风速，不同供电情况下除尘器的分级效率，结果表明，离心脉冲静电除尘器具有结构简单，阻力损失低，除尘效率高等优点；脉冲供电能显著提高除尘器的分级效率。对粒径小于2μm的粉尘的捕集，入口风速为6.97m/s至12.79m/s时，脉并非中供电与直流供电相比，其分级效率提高10%-23%；与旋风相比，其分级效率提高37%-66%。     

硫酸盐对高浓度黑液二相厌氧处理的影响

用二相ＵＡＳＢ反应器处理碱法草浆黑液，酸化相为８．８７Ｌ的普通升流式反应器，甲烷相为２８．７５Ｌ的ＵＡＳＢ反应器，系统温度３５±１℃。结果表明：当酸化相进水ＣＯＤ５５１３￣９５５ｍｇ／Ｌ，ＳＯ４＾２－８３７０￣１０４１ｍｇ／Ｌ，ｐＨ值为５．５时，二相系统ＣＯＤ去除率为７６．１８％。     

环境资源约束下中国工业绿色全要素水资源效率研究

通过构建RAM-SFA-RAM三阶段工业绿色全要素水资源效率测度模型，对其不同层面的效率值进行多维测度与比较分析，并利用空间Tobit模型对工业绿色全要素水资源效率的驱动机制进行实证检验.效率测度结果表明，环境因素与统计噪音是效率值计算中不可忽视的重要影响因素；全国样本的效率值在2000~2017年期间总体变化趋势是以持续上升为主，但距离理想发展状态还存在较大差距，具体阶段上可划分为“稳增期”、“振落期”和“提速期”；区域层面的检验中，东部效率具有较为显著的领先优势，而中部和东北部效率差异性相对较小，其变化曲线存在明显的“交互性”现象，西部则整体效率偏低；主要经济带的检验中，京津冀地区的工业绿色全要素水资源效率整体上要高于泛珠三角和泛长三角地区.驱动机制检验表明，基于全国样本维度的水资源禀赋、企业技术创新、用水结构和环境规制对工业绿色全要素水资源效率具有正向促进作用，而产业结构、城镇化率表现为负向抑制效应；在区域样本检验中，各影响要素在不同区域之间所呈现出的作用效果存在一定差异性，但产业结构调整、城镇化水平等应引起重视，不同区域需要依据其实际特点采取针对性的改进措施.     

应用工业生态学解决污染与发展问题

面对日益尖锐的污染与发展之间的矛盾，在清洁生产基础上兴起的工业生态学是一门新的边缘学科，其概念和原理来源于生物生态学。讲述了工业生态学的概念、核心要旨和研究方法。对其在工业体系中的应用进行了初步的探讨，并提出了一些新的思路。