克雷伯氏菌NY1产絮凝剂的阳离子修饰研究

为简化微生物絮凝剂投加步骤,消除由于助凝剂添加而引起的环境二次污染问题,以3-氯-2-羟丙基三甲基氯化铵(CTA)修饰荷负电的微生物絮凝剂(~-54mV),从而获得荷正电的改性絮凝剂.实验结果显示,CTA与NaOH的摩尔比值是影响阳离子修饰效果的主要因素;阳离子修饰的的最佳条件为:10g微生物絮凝剂, 0.015mol CTA,20%含水率,CTA与NaOH的摩尔比为0.95,80℃反应2h后.在最佳条件下所得阳离子化微生物絮凝剂的Zeta电位可达+16mV,其对高岭土的絮凝率也由阳离子化前的60.5%上升至91%.由阳离子化絮凝剂的结构表征可知,阳离子修饰过程并未改变微生物絮凝剂的根本结构,只是在原微生物絮凝剂基础上引入阳离子基团,从而增加了絮凝剂整体分子量;同时,由于阳离子基团的大量引入,絮凝剂的结晶度增加,从而使其溶解度增加.将阳离子化前后微生物絮凝剂应用于去除铜绿微囊藻,当阳离子化后微生物絮凝剂添加量为40mg/L时,其对藻类的去除率超过98%;而未阳离子修饰的微生物絮凝剂对该藻几乎没有去除效果.     

利用蚀刻废液生产碱式氯化铜过程中二英类污染物的去除

针对蚀刻废液及其回收后生产的碱式氯化铜产品中二英(PCDD/Fs)和二英类多氯联苯(dl-PCBs)进行了分析研究,并比较了采用去除工艺前后两类污染物含量水平的变化特征.利用高分辨气相色谱/高分辨质谱对样品中PCDD/Fs和dl-PCBs进行分析,结果表明,氯化铜废液中PCDD/Fs和dl-PCBs的平均总浓度分别为264、139 pg·mL-1,而铜氨液中浓度分别为0.09、0.50 pg·mL-1;碱式氯化铜产品中浓度分别为106 pg·g-1(2.79 pg WHO-TEQ2005·g-1)和27.8 pg·g-1(0.69 pg WHO-TEQ2005·g-1);而经过吸附和过滤等去除工艺后,产品中PCDD/Fs和dl-PCBs的TEQ浓度水平分别降低至0.10—0.25 pg WHO-TEQ2005·g-1和0.05—0.72 pg WHO-TEQ2005·g-1,满足欧盟对于矿物源性饲料添加剂中PCDD/Fs和dl-PCBs的限量标准要求.研究表明该工艺能够有效去除利用蚀刻废液生产碱式氯化铜过程中的二英类污染物.     

Comparative study on the efficiency and environmental impact of two methods of utilizing polyvinyl chloride waste based on life cycle assessments

Two processes of utilizing polyvinyl chloride （PVC） waste, an incineration process and a vacuum pyrolysis process, for energy conversion were compared to determine their efficiency and environmental perfor- mance. We carried out a life cycle assessment with each of the two processes to evaluate their environmental impact and defined the goals and limits of our remit. As well, we established an inventory of PVC waste from incineration and vacuum pyrolysis based on process analysis, data collection and calculations. The results show that electrical power output per unit mass of PVC waste in the incineration process was twice as high as that of the vacuum pyrolysis process. Incineration had a larger total environmental impact potential than vacuum pyrolysis. The total environmental impact potential of PVC waste from incineration was three times higher than that from vacuum pyrolysis. Incineration of PVC disposed 300 ng. 100 kgI of dioxins and vacuum pyrolysis 98.19 ng- 100 kgI of dioxins. As well, we analyzed the data for their uncertainty with results quantified in terms of three uncertainties： basic uncertainty, additional uncertainty, and computational uncertainty. The coefficients of variation of the data were less than 25% and the quality of the inventory data was acceptable with low uncertainty. Both PVC waste disposal processes were of similar quality and their results comparable. The results of our life cycle impact assessment （LCIA） showed considerable reliability of our methodology. Overall, the vacuum pyrolysis process has a number advantages and greater potential for development of PVC disposal than the incineration process.     

Cu(NO3)2在亚甲蓝湿式氧化处理中的应用

用CWAO技术处理COD为2 000 mg/L的亚甲蓝水溶液.以Cu(NO3)2为催化剂,考察了催化剂投加量、反应温度、压力及进水pH值对亚甲蓝水样COD去除率、脱色率、出水pH值的影响.实验表明,亚甲蓝的氧化效率随催化剂投加量的增加,反应温度及压力的升高而升高.然而,综合考虑亚甲蓝的氧化效率、试剂费用、设备成本及能量消耗,实验确定Cu(NO3)2的投加量以Cu2 计为150 mg/L,反应温度及压力分别为200℃和2.0 MPa.在酸性进水条件下,COD去除率随进水pH值的降低而升高;而在碱性进水条件下,COD去除率随进水pH值的升高而升高.pH值按COD去除率由高到低的排列顺序是:3.87、11.23、5.50、7.25、9.47,实验确定最佳进水pH值是3.87.在以上最佳的操作条件下,反应150 min,水样COD去除率达97.4%,脱色率达99.97%,出水pH值3.63.     

十六烷基三甲基氯化铵与荧蒽对小球藻的联合毒性及其作用机制

以普通小球藻(Chlorella vulgaris)为受试生物,采用批量培养方法研究了阳离子表面活性剂十六烷基三甲基氯化铵(CTAC)与多环芳烃荧蒽(Flu)的联合毒性及其作用机制.结果表明,当CTAC初始浓度固定为100μg/L时,随Flu浓度的升高(0~100.84μg/L), CTAC与Flu的联合毒性由协同效应(0~22.50μg/L)转为拮抗效应(22.50~100.84μg/L).当Flu浓度为1.13μg/L时,协同效应达到最大(RI＝2.01),与对照组相比,生物量抑制率从37.5%增加至80.9%;对氮和铁单位吸收量分别从0.27mg和9.18μg降至0.09mg和2.14μg;藻细胞Zeta电位从-10.0mV提高至-8.3mV;叶绿素a和可溶性蛋白质含量分别从5.00mg/L和80.65μg/mg降为2.57mg/L和50.36μg/mg.根据实验结果分析, CTAC与Flu复合污染体系提高了藻细胞Zeta电位,抑制了小球藻对氮和铁的吸收,降低了藻细胞体内叶绿素和蛋白质的含量.     

Thermodynamic investigation of the effect of oxygen and hydrogen chloride potential upon generation and decomposition behavior of dioxins

The thermodynamic equilibrium of the C‐H‐O‐Cl system has been calculated to elucidate the generation and decomposition behavior of dioxins, and is discussed from the viewpoint of the oxygen and hydrogen chloride potential. The dioxins behavior is greatly dependent on the oxygen potential, i.e. higher temperature and oxygen potential lead to the complete decomposition of dioxins, while low hydrogen chloride potential under insufficient oxygen condition leads to an increase of multi‐chlorine displacement of dioxins.     

城市环境铂族金属分布特性及生态健康风险研究进展

随着铂族金属铂（Pt）、钯（Pd）、铑（Rh）被广泛应用于汽车尾气催化净化器中,这三种金属在自然界中的含量逐渐升高。越来越多的研究表明,这几种曾被认为对环境影响较小的金属的确会带来潜在的生态健康风险。本文概括了国内外城市各种环境介质的含量分布,重点分析了铂族金属的源解析方法、粒径分布特性、影响其排放的因素和其潜在的生态健康风险。就全世界的城市来看,灰尘、空气、土壤、沉积物等各种环境介质中铂族金属的含量均有显著提高,主要来源于汽车三元催化净化器。这三种金属倾向于富集在细颗粒中,行车模式是影响其排放量的重要因素,自然界的共存物质可增强它们的溶解性和迁移性,从而使它们的生物可利用性大大提高。生物体吸收这类金属后,可与体内的物质发生反应,形态发生变化,毒性增强。在以后的研究中,除了持续跟踪调查这三种金属在环境中的含量水平以外,还应加强研究这三种金属在环境中的颗粒分布、迁移转化、形态变换、生物可利用性以及生物毒性等,使我们能够更好地评估其生态健康风险,并为与之相关的应用研发、防范措施、政策制订提供引导和支持。     

负载型纳米Fe-Pd降解水溶性偶氮染料

采用阳离子交换树脂表面为载体,合成了负载型纳米Fe-Pd二元复合金属材料,采用扫描电子显微镜(SEM)和能谱分析对该材料进行表征,研究了其对一些水溶性偶氮染料的降解效果.实验表明,该材料对0.05 g.L-1甲基橙、日落黄、酸性橙8、金橙G和活性红2等偶氮染料有较好的降解效果,纳米双金属中Pd含量的增加有利于染料的降解;反应体系初始pH值对染料的降解率影响较大,本研究中,pH 4酸性条件下降解效果最佳;制备的材料在第10次活化后,仍有较好的降解效果;为环境中偶氮染料的降解提供了一种有效的方法.     

氯化蒸馏废酸还原回收锗

以锗烟尘氯化蒸馏后的废盐酸为原料,以废铁为还原剂,使废酸中的有价金属锗以还原态沉淀富集在渣中,强化氧化氯化蒸馏回收四氯化锗,锗的综合回收率达94．10％。同时生产净水剂用液体氯化铁产品。     

Optimization of the recovery of plastics for recycling by density media separation cyclones

Material recovery processes are presented as the optimum option for recycling plastic wastes as a means of recovering hydrocarbon resources. There exist a large variety of automated material recovery processes for recycling of such wastes but each with significant limitations. Of these, the separation based on differences in densities is advocated as the optimum process either for producing recycled products or preparing wastes for subsequent recovery processing.Density separation processes based on cyclone type density media separation (DMS) is presented as an important, potential method for increasing plastics recycling process capacities. It is demonstrated to have the capacity to separate a significantly larger range of particle sizes than those presently processed industrially. The mathematical relationship for the prediction of quality of typical LARCODEMS type density media separations by particle size and density as expressed by the Ecart Probable is presented.A proposed device configuration is presented for density media separation to optimize the recovery and purity of both density fractions produced. It is also suggested that to be economically viable, a large scale of operation is required for industrial plastics recycling operations recovering and producing a number of different plastics with a purity to be used as a substitute for virgin material.