以TEOS为硅源的聚硅氯化铝中铝及硅形态分布

以正硅酸乙酯 (TEOS)为硅源 ,合成了新型的聚硅氯化铝 (PASC) ,利用Al Ferron逐时络合比色法和Si Mo逐时络合比色法分别研究了其Al形态及Si形态分布 ,并与常规方法 (以硅酸钠为硅源 )合成的聚硅氯化铝做了比较 .实验结果表明 ,新方法合成的PASC具有铝硅分布均匀 ,分子量较大 ,产品重现性好的优点 .两种方法合成的PASC具有相同的Al形态分布规律 ,即高分子量Al形态含量随B值 (碱化度 )和Si Al摩尔比的增大而增加 ,Al形态随Si Al摩尔比的变化程度随B值的增大而增大 .另外通过新方法发现 ,Si形态分布也具有规律性并和Al形态具有相似的分布特征 ,但Si形态随Si Al摩尔比的变化程度随B值的增大而减小 .     

吹扫捕集气质联用法同时测定水中氯乙烯、乙醛、丙烯醛、丙烯腈、吡啶和松节油

建立了一种采用吹扫捕集气质联用法同时测定水中氯乙烯、乙醛、丙烯醛、丙烯腈、吡啶和松节油的分析方法,研究并优化了吹扫捕集前处理条件参数。结果表明,吹扫时间、吹扫温度和脱附时间是影响目标物的吹扫捕集效率的关键因素;优化后方法线性良好,相关系数均大于0.999,检出限范围为0.20~1.48μg/L,加标回收率范围为86.9%~105%,相对标准偏差为1.1%~9.8%。建立的吹扫捕集GC-MS联用法简便、快速、灵敏度高、定性定量准确可靠,可同时满足对自来水、地表水、地下水等水样中痕量氯乙烯、乙醛、丙烯醛、丙烯腈、吡啶和松节油监测的要求。     

一种钢渣中氯离子的测定方法

利用蒸馏装置蒸出钢渣中的氯离子,使用硝酸汞滴定方法进行滴定,选用两种钢渣,在不同实验室分别进行了分析测定的比较和验证。结果表明:该方法简便易操作,重现性和准确性都比较高,作为钢渣中氯离子的测定是可行的。     

聚硅氯化铝（PASC）的形态分布及转化规律：Ⅰ.Al—Ferron逐时络合比色？…

采用Ａｌ－Ｆｅｒｒｏｎ逐时络合比色法比较研究了ＰＡＳＣ与ＰＡＣ中铝的形态分布及转化规律。实际结果表明,在ＰＡＳＣ中,由于聚硅酸与铝水解聚合产物的相互作用,使得铝的水解聚合形态分布及转化情况发生了变化。     

High efficiency chlorine removal from polyvinyl chloride (PVC) pyrolysis with a gas–liquid fluidized bed reactor

In this research a gas–liquid fluidized bed reactor was developed for removing chlorine (Cl) from polyvinyl chloride (PVC) to favor its pyrolysis treatment. In order to efficiently remove Cl within a limited time before extensive generation of hydrocarbon products, the gas–liquid fluidized bed reactor was running at 280–320 °C, where hot N₂ was used as fluidizing gas to fluidize the molten polymer, letting the molten polymer contact well with N₂ to release Cl in form of HCl. Experimental results showed that dechlorination efficiency is mainly temperature dependent and 300 °C is a proper reaction temperature for efficient dechlorination within a limited time duration and for prevention of extensive pyrolysis; under this temperature 99.5% of Cl removal efficiency can be obtained within reaction time around 1 min after melting is completed as the flow rate of N₂ gas was set around 0.47–0.85 Nm³ kg^?1 for the molten PVC. Larger N₂ flow rate and additives in PVC would enhance HCl release but did not change the final dechlorination efficiency; and excessive N₂ flow rate should be avoided for prevention of polymer entrainment. HCl is emitted from PVC granules or scraps at the mean time they started to melt and the melting stage should be taken into consideration when design the gas–liquid fluidized bed reactor for dechlorination.     

粉煤灰提取液的絮凝效应

为了回收利用粉煤灰,采用盐酸浸提法制备粉煤灰提取液（CFAL）用作絮凝剂。通过单因素实验优化CFAL的制备条件,并在高岭土模拟体系内研究CFAL的絮凝效应。研究在不同CFAL投加量下浊度的去除率,确定最佳的投加剂量及在此剂量下絮体的大小与沉降性能。对原浊度为100 NTU的高岭土悬浊液,当CFAL为0.44 mg·L-1（以Al的含量计）时,浊度去除率达到90%以上。在同等剂量下,聚合氯化铝（PAC）和氯化铝（AlCl3）的浊度去除率均低于CFAL,分别为78.7%和79.2%。CFAL的絮体大小约为400 μm,沉降较快,在20 min后,去除率达到90%以上;PAC和AlCl3的絮体分别为260和330 μm,分别沉降60和40 min后,去除率稳定在80%左右。在实验剂量范围内,CFAL絮凝后对高岭土悬浊液的pH不会造成明显影响,且余铝满足《生活饮用水卫生标准》（GB 5749-2006）,CFAL是一种廉价、高效、安全的混凝剂。     

Improving the sludge conditioning potential of moringa seed

In the search for a cheaper material to effectively condition sludge, oil-free moringa seed was prepared and tested. A Soxhlet apparatus was used to extract the oil from moringa seed (Moringa oleifera). The oil-free seed (marc) has been found to have higher conditioning potential than the ordinary moringa seed. However, the traditional ferric chloride is still a better sludge conditioner than moringa seed marc. For the digested domestic sludge used, optimum conditioning dosages were found to be 0.6, 0.80, and 1.10% of the total solids for ferric chloride, marc of the moringa seed, and ordinary moringa seed, respectively. Since little or no operational material is lost in the extraction process, the moringa seed marc is a promising conditioner in place of the ordinary seed.     

Color removal from dye-containing wastewater by magnesium chloride

Color removal by MgCl(2) when treating synthetic waste containing pure dyes was studied. The color removal efficiency of MgCl(2)/Ca(OH)(2) was compared with that of Al(2)(SO(4))(3), polyaluminum chloride (PAC) and FeSO(4)/Ca(OH)(2). The mechanism of color removal by MgCl(2) was also investigated. The experimental results show that the color removal efficiency of MgCl(2) is related to the type of dye and depends on the pH of the waste and the dosage of the coagulants used. Treatment of waste containing reactive dye or dispersed dye with MgCl(2) yielded an optimum color removal ratio when the pH of the solution was equal to or above 12.0. For both the reactive and dispersed dye waste, MgCl(2)/Ca(OH)(2) was shown to be superior to MgCl(2)/NaOH, Al(2)(SO(4))(3), PAC and FeSO(4)/Ca(OH)(2) for color removal. A magnesium hydroxide precipitate formed at pH values greater than 12.0, which provided a large adsorptive surface area and a positive electrostatic surface charge, enabling it to remove the dyes through charge neutralization and an adsorptive coagulating mechanism. So, the MgCl(2)/Ca(OH)(2) system is a viable alternative to some of the more conventional forms of chemical treatment, especially for treating actual textile waste with high natural pH.     

Removal of phenol from aqueous solution by adsorption onto OTMAC-modified attapulgite

The potential of octodecyl trimethyl ammonium chloride (OTMAC)-modified attapulgite (AT) for phenol adsorption from aqueous solutions was studied. The comparison of natural AT and modified AT showed that it is possible to utilize the sonication-modified OTMAC-AT in the treatment of phenol-contaminated wastewaters. Batch sorption studies were carried out to evaluate the effect of contact time, shaking frequency, temperature and the amount of AT. The results showed that in a lab-scale reactor, at room temperature, with an amount of the modified AT added (2.5 g), and a shaking frequency of 140 rev/min, the adsorption rate of phenol could be 60.4% for a duration of 60 min. The sorption kinetics were described by a pseudo-second-order model, and the values of k and q(e) were 1.367 mg/ig min and 0.7901 ig/mg, respectively. The analysis of equilibrium data showed that the Freundlich isotherms were found to be applicable for the adsorption equilibrium data. K and 1/n were estimated to be 14.53 and 0.8438, respectively.     

钯/铁双金属对六氯乙烷的催化还原脱氯

用钯／铁双金属对水溶液中的六氯乙烷（HCE）进行催化还原脱氯,考察了各种因素对脱氯效果的影响。实验结果表明,在厌氧环境、饱和HCE溶液体积80mL、钯与铁质量比0．03％、钯／铁双金属质量3g、反应时间130min的条件下,脱氯率可达98．8％。采用气相色谱-质谱联用仪对HCE及其脱氯产物进行分析,结果表明,HCE的脱氯中间产物主要是四氯乙烯,四氯乙烯进一步脱氯的中间产物未检出。