基于颗粒物浓度的沙尘天气分级标准研究

沙尘天气在近年对我国城市空气质量造成明显影响。目前我国沙尘天气分级仍然按照气象标准 ,主要是以水平能见度进行分级。文章参考国外的有关标准 ,通过统计近年来我国沙尘天气过程中的颗粒物浓度 ,结合我国沙尘天气的发生情况和特点 ,提出了基于沙尘浓度的沙尘天气分级标准     

大气颗粒物中元素碳的直接测定

对原来用元素分析仪测定大气颗粒物样品中有机碳、元素碳的方法[1 ] 进行改进 ,将差减法间接测定元素碳改为一步直接测定元素碳。有机碳、元素碳的测量标准偏差的平均值分别为 0 35 %、0 34% ,提高了元素碳的测量精度 ,同时避免了误差传递 ,解决了差减法测定元素碳时出现负值的情况。     

南水北调东平湖水质变化趋势分析研究

采用了季节性肯达尔法水质趋势分析方法,分析了1984～2000年东平湖水质的变化情况,目前东平湖水质一般为Ⅴ类、Ⅵ类,个别年份为超Ⅴ类,氨氮平均值历年变化不大,一般均符合Ⅰ Ⅲ类水质,挥发酚和砷含量甚小,各年均符合Ⅰ类水。     

固相萃取富集高效液相色谱法测定环境水样中的重金属元素

研究了用固相萃取富集高效液相色谱法测定环境水样中痕量重金属镍、铜、银、铅、镉和汞的方法。环境水样中的镍、铜、银、铅、镉和汞用四 -(对二甲氨基苯基 ) -卟啉 (T4 -DMAPP)柱前衍生 ,用C18固相萃取小柱萃取富集镍、铜、银、铅、镉和汞的T4 -DMAPP络合物 ,富集倍数为 1 0 0倍 ,然后用甲醇和四氢呋喃梯度洗脱为流动相 ,WatersXter raTMRP18( 3 9mm× 1 5 0mm)色谱柱为固定相分离 ,用二极管矩阵检测器检测。镍、铜、银、铅、镉和汞的检测限分别为3、2、4、3、1 5ng/L和 3ng/L。方法相对标准偏差为 1 8%— 3 2 % ,标准回收率为 92 %— 1 0 7%。该方法用于测定环境水样中的痕量重金属 ,结果令人满意     

Cu、Pb、Zn火焰原子吸收多谱线分析在环境监测中的应用

对铜的 3条谱线 (2 49.2 nm、2 61 .4nm,3 2 4.8nm ) ,铅的 2条谱线 (2 83 .3 nm、2 1 7.0 1 nm )以及锌的 2条谱线(3 0 7.6nm、2 1 3 .9nm ) ,共 7条谱线的灵敏度、检测限、线性范围进行了归纳性总结 ,并对多种共存元素可能存在的干扰情况进行了研究 ,认为利用元素不同分析谱线的分析灵敏度差异 ,根据被测元素在样品消解液中含量 ,选择合适的谱线进行分析 ,既降低工作强度 ,又能获得满意结果     

固相萃取-气相色谱法测定水中硝基苯类有机污染物的方法研究

建立了固相萃取、毛细柱气相色谱-电子捕获检测器定量分析水中硝基苯类化合物的分析方法。通过对固相萃取柱的选择、固相萃取条件(样品溶液的pH值、上样速度、上样体积、洗脱液选择及配比)的优化,得出了最佳实验条件。穿透体积可达1.5L,回收率在80%~105%,最小检出浓度在0.00037~0.072μg/L之间,均大大低于GB13194-91的规定。相对标准偏差在0.7%~5.3%之间。该方法准确、简单,重现性好、回收率高,污染小。     

活性炭法测量室内空气中氡浓度的影响因素研究

探讨了各种因素对活性炭法测量室内空气中氡浓度的影响,并提出既能保证检测质量,又能符合工程检测需要、提高检测效率的检测条件范围。     

Prediction of Leachate Level in Kimpo Metropolitan Landfill Site by Total Water Balance

Kimpo metropolitan landfill has received various kinds of wastessince January 1992. The leachate level was measured to be 10.3 m in May 1995 and the level increased to 12.2 m in August 1996. Therefore, to prove the reason for the increasing leachate level, we calibrated hydraulic conductivity of each waste andintermediate layer using the HELP (Hydrologic Evaluation ofLandfill Performance) model. The leachate generation data measured from February 1993 to October 1995 was used in the model calibration. As a result of a model calibration, we obtained anaverage infiltration ratio and used this in analysis of the total water balance to predict elevation of leachate level. Main causes of the elevation of the leachate level were the high water content of the waste and the degradation of the leachate-drainage system caused by the subsidence of a naturalbarrier layer.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

An integrated assessment model for cross-country pipelines

The cross-country petroleum pipelines are environmentally sensitive because they traverse through varied terrain covering crop fields, forests, rivers, populated areas, desert, hills and offshore. Any malfunction of these pipelines may cause devastating effect on the environment. Hence, the pipeline operators plan and design pipelines projects with sufficient consideration of environment and social aspects along with the technological alternatives. Traditionally, in project appraisal, optimum technical alternative is selected using financial analysis. Impact assessments (IA) are then carried out to justify the selection and subsequent statutory approval. However, the IAs often suggest alternative sites and/or alternate technology and implementation methodology, resulting in revision of entire technical and financial analysis. This study addresses the above issues by developing an integrated framework for project feasibility analysis with the application of analytic hierarchy process (AHP), a multiple attribute decision-making technique. The model considers technical analysis (TA), socioeconomic IA (SEIA) and environmental IA (EIA) in an integrated framework to select the best project from a few alternative feasible projects. Subsequent financial analysis then justifies the selection. The entire methodology has been explained here through a case application on cross-country petroleum pipeline project in India.