Petrophysical analysis to investigate the effects of carbon dioxide storage in a subsurface saline aquifer at Ketzin, Germany (CO2SINK)

To test the injection behaviour of CO₂ into brine-saturated rock and to evaluate the dependence of geophysical properties on CO₂ injection, flow and exposure experiments with brine and CO₂ were performed on sandstone samples of the Stuttgart Formation representing potential reservoir rocks for CO₂ storage. The sandstone samples studied are generally fine-grained with porosities between 17 and 32% and permeabilities between 1 and 100 mD.Additional batch experiments were performed to predict the long-term behaviour of geological CO₂ storage. Reservoir rock samples were exposed over a period of several months to CO₂-saturated reservoir fluid in high-pressure vessels under in situ temperature and pressure conditions. Petrophysical parameters, porosity and the pore radius distribution were investigated before and after the experiments by NMR (Nuclear Magnetic Resonance) relaxation and mercury injection. Most of the NMR measurements of the tested samples showed a slight increase of porosity and a higher proportion of large pores.     

超高效气溶胶净化系统有效性现场检验研究

各类超高效气溶胶净化系统普遍存在的较为突出的问题是:缺乏系统工作有效性现场检测手段,难以判断系统防护是否失效。根据超高效滤料过滤特性和测试原理,并在分析了大气气溶胶对过滤效率测试影响的基础上,提出大气气溶胶背景下,基于粒数浓度测量和使用发生的高浓度单分散气溶胶作为实验气溶胶的净化系统防护有效性现场检验测试技术及系统组成,并进行了验证。     

脱硫石膏粒径分布与脱水性能实验研究

脱硫石膏粒径分布是影响脱硫石膏浆液脱水性能的重要因素之一,以干法、湿法筛分和研磨破碎获得不同粒径分布的脱硫石膏,在相同的过滤条件下,对不同粒径分布脱硫石膏浆液脱水性能进行了研究,实验结果表明,当脱硫石膏粒径d50大于50μm且（d90-d10）小于100μm,真空过滤最大真空度不低于0．098MPa,过滤时间不少于2．5min,滤饼厚度不超过20mm时,石膏滤饼含水率可以降低到12％以下（最低可达10％）;d50在17μm为脱硫石膏在相同的过滤条件下能够实现真空脱水干燥的转折点;d50和（d90-d10）共同影响石膏脱水性能,d50小于20μm时,仅表现为d50的影响。     

机械清洗法对MBR膜泥饼层的影响

膜污染是制约MBR发展的瓶颈。考察投加ABS颗粒对MBR膜组件上膜泥饼层的影响,并设对照实验。结果表明,对照MBR膜通量下降速度快,膜污染严重,膜表面上累积厚厚的泥饼层,而在ABS MBR中膜通量下降速度则缓慢的多,且膜上泥饼层积累量则明显少于对照MBR;曝气量越大,颗粒运行的速度也越快,泥饼层被撞落量也越多;颗粒以碰撞角度为45°冲刷膜的情况下,泥饼层掉落效果明显增加;泥饼层包裹的膜丝根数越多,泥饼层的静摩擦力和保持泥饼层不被破坏的力也越大,泥饼层就越难被冲刷掉。SEM照片显示,ABS MBR的膜孔堵塞要严重于对照MBR,表面的褶皱要较对照MBR多。     

不同粒径泥沙理化特性对磷吸附过程的影响

以北京大兴南海子湖表层沉积物为研究对象,测试分析了0.147～0.246 mm(细砂)、0.074～0.147 mm(极细砂)、0.0385～0.0740 mm(粉粒)和<0.0385 mm(粉粒粘粒混合物)4种粒径泥沙对磷的吸附行为,并采用相关分析及逐步回归分析探讨不同粒径沉积物中有机质(OM)、Fe、Al、Ca、Mn和TP含量对磷吸附过程的影响。结果表明,二级动力学方程和Langmuir模型能较好地描述南海子不同粒径泥沙的吸附动力学及等温吸附过程(R2>0.90)。粒径对单位质量泥沙吸附磷量具有明显影响,粉粒粘粒混合物>粉粒>细砂>极细砂。总体上,泥沙有机质(OM)、TP、Fe、Al、Ca和Mn含量随粒径的减小而增大,且粘粒对其影响较大。不同粒径泥沙(OM)、Fe、Al、Ca和Mn含量之间存在极显著正相关关系(P<0.01),且均对单位质量泥沙最大吸附量(Xm)和饱和吸附量(Cse)具有正效应,其中Al含量对该参数的影响更为显著。这说明泥沙对磷的吸附行为可能受到粒径和化学成分的共同影响。     

Polychlorinated dibenzo-p-dioxin and dibenzofuran in urban air of an Andean city

Particle-bound polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) in ambient air were monitored together with particulate matter less than 10 μm (PM₁₀) at three sampling sites of the Andean city of Manizales, Colombia; during September 2009 and July 2010. PCDD/Fs ambient air emissions ranged from 1 fg WHO-TEQ m⁻³ to 52 fg WHO-TEQ m⁻³ in particulate fraction. The PM₁₀ concentrations ranged from 23 μg m⁻³ to 54 μg m⁻³. Concentrations of PM₁₀ and PCDD/Fs in ambient air observed for Manizales - a medium sized city with a population of 380 000 - were comparable to concentrations in larger cities. The highest concentrations of PCDD/Fs and PM₁₀ found in this study were determined at the central zone of the city, characterized by public transportation density, where diesel as principal fuel is used. In addition, hypothetical gas fractions of PCDD/Fs were calculated from theoretical K_p data. Congener profiles of PCDD/Fs exhibited ratios associated with different combustion sources at the different sampling locations, ranging from steel recycling to gasoline and diesel engines. Taking into account particle and gas hypothetical fraction of PCDD/Fs, Manizales exhibited values of PCDD/Fs equivalent to rural and urban-industrial sites in the southeast and center of the city respectively. Poor correlation of PCDDs with PM₁₀ (r = −0.55 and r = 0.52) suggests ambient air PCDDs were derived from various combustion sources. Stronger correlation was observed of PCDFs with PM₁₀. Poor correlation between precipitation and reduced PM₁₀ concentration in ambient air (r = −0.45) suggested low PM₁₀ removal by rainfall.     

Tracing the sources of refractory dissolved organic matter in a large artificial lake using multiple analytical tools

Structural and chemical characteristics of refractory dissolved organic matter (RDOM) from seven different sources (algae, leaf litter, reed, compost, field soil, paddy water, treated sewage) were examined using multiple analytical tools, and they were compared with those of RDOM in a large artificial lake (Lake Paldang, Korea). Treated sewage, paddy water, and field soil were distinguished from the other sources investigated by their relatively low specific UV absorbance (SUVA) values and more pronounced fulvic-like versus humic-like fluorescence of the RDOM samples. Microbial derived RDOM from algae and treated sewage showed relatively low apparent molecular weight and a higher fraction of hydrophilic bases relative to the total hydrophilic fraction. For the biopolymer types, the presence of polyhydroxy aromatics with the high abundance of proteins was observed only for vascular plant-based RDOM (i.e., leaf litter and reed). Molecular weight values exhibited positive correlations with the SUVA and the hydrophobic content among the different RDOM, suggesting that hydrophobic and condensed aromatic structures may be the main components of high molecular weight RDOM. Principal component analysis revealed that approximately 77% of the variance in the RDOM characteristics might be explained by the source difference (i.e., terrestrial and microbial derived) and a tendency of further microbial transformation. Combined results demonstrated that the properties of the lake RDOM were largely affected by the upstream sources of field soil, paddy water, and treated sewage, which are characterized by low molecular weight UV-absorbing and non-aromatic structures with relatively high resistance to further degradation.     

Atmospheric particle characterization, distribution, and deposition in Xi'an, Shaanxi Province, Central China

Physical characterization and chemical analysis of settled dusts collected in Xi’an from November 2007 to December 2008 show that (1) dust deposition rates ranged from 14.6 to 350.4 g m⁻² yr⁻¹. The average deposition rate (76.7 g m⁻² yr⁻¹) ranks the 11th out of 56 dust deposition rates observed throughout the world. The coal-burning power was the major particle source; (2) on average (except site 4), ∼10% of the settled dusts having size <2.6, ∼30% having size <10.5, and >70% having size <30 μm; (3) the concentrations for 20 out of 27 elements analyzed were upto 18 times higher than their soil background values in China. With such high deposition rates of dusts that contain elevated levels of toxic elements, actions should be taken to reduce emission and studies are needed to assess the potential impacts of settled particles on surface ecosystem, water resource, and human health in the area.     

聚硅酸钛制备及其助凝特性

采用在活化硅酸制备过程中加入适量Ti Cl4的方法,试制了一种新型无机高分子助凝剂—聚硅酸钛。研究了不同[Si]/[Ti]条件下制备的聚硅酸钛在固定p H值的水中分散物的粒径和Zeta电位随着活化时间的变化趋势,并与活化硅酸作比较。结果表明,在Si/Ti=20,活化48 h的条件下能制备出较为稳定的聚硅酸钛。与活化硅酸相比,聚硅酸钛在水中的分散物具有较大的粒径和更高的Zeta电位。通过对比制备的活化硅酸和聚硅酸钛的红外图谱发现,聚硅酸钛中有TiO-Si键,证明钛离子参与了聚合反应,新生成的化学键提高了它的聚合度和稳定性。采用硫酸铝为混凝剂,聚硅酸钛为助凝剂进行混凝除浊实验。测定了絮凝体的Zeta电位和混凝沉淀后的上清液浊度,研究了硫酸铝投加量和混凝p H对聚硅酸钛助凝效果的影响。结果表明,投加适量的聚硅酸钛助凝剂,明显提高了混凝除浊效果且拓宽了有效混凝p H值的范围。     

300MW燃煤锅炉机组超细颗粒聚并器的实验研究

为了解决燃煤锅炉烟气中超细颗粒难以脱除的问题,基于流体动力学原理设计了一种超细颗粒聚并器,并在300 MW燃煤锅炉机组电除尘器的前置烟道中进行了实验研究。结果表明,聚并器内部存在超细颗粒之间以及超细颗粒与大颗粒之间的相互聚集行为,从而使超细颗粒数量显著减少。例如,对于粒径在2.65和10.48μm以下的颗粒,其体积比例在聚并器出口分别减少了56.7%和62.3%,在电除尘器出口的粉尘浓度减少了26.34 mg/Nm3,这表明,基于流体动力学原理的聚并器对超细颗粒的聚并作用明显,具有良好的应用前景。