纳米级铁粉脱氯降解四氯化碳

四氯化碳的生产和使用,给人类带来了较大危害.为此,采用纳米铁粉这一新方法对其进行脱氯处理.试验以纳米级铁粉对四氯化碳的脱氯率为考察指标,选用L25(56)正交试验方案,考察了降解介质的初始pH值、纳米铁粉的质量、降解温度、摇床转速和脱氯时间5个影响因素.结果表明,pH值这一因素有极显著影响;在得出的纳米铁粉对四氯化碳脱氯的最佳工艺条件下,获得了99.5%的脱氯率,为有机氯化物脱氯开辟了一条新途径.     

A novel, simple and sensitive resonance scattering spectral method for the determination of chlorite in water by means of rhodamine B

A new resonance scattering method was proposed for the determination of chlorite, basing on the resonance scattering effect of rhodamine dye. In HCl-sodium acetate buffer solution, chlorite oxidizes 1- into 12 and the reaction of 12 and excess 1- results in If. It is respectively combined with rhodaminc dyes, including rhodamine B （RhB）, butyl rhodamine B （b-RhB）, rhodamine G （RhG） and rhodamine S （RhS）, to form association complex particles, which exhibit stronger resonance scattering （RS） effect at 400 nm. The chlorite concentration of ClO2 in the range of 0.00726-0.218 μg/ml, 0.0102-0.292 μg/ml, 0.00726-0.145 μg/ml and 0.0290- 0.174 μg/ml is respectively linear to the RS intensity of association complex particle systems at 400 nm for the RhB, b-RhB, RhG and RhS. The detection limits of the four systems were respectively 0.00436, 0.00652, 0.00580 and 0.01450μg/ml ClO2^-. In the four systems, the RhB system possesses good stability and high sensitivity. It has been applied to the analysis of chlorite in wastewater with satisfactory results.     

联网激光雷达的观测性能综合平行比对

激光雷达以其高精度的探测能力在大气污染研究中得到了广泛应用。由于生产厂家和反演算法等的差异,激光雷达观测数据的质量参差不齐。笔者利用2013年11月和2014年3月2种不同型号激光雷达(高频激光雷达和微脉冲激光雷达) 532 nm波段的气溶胶消光系数和气溶胶自动观测网(AERONET)光学厚度数据,对2部雷达在不同空气质量下的观测性能进行综合对比。结果表明:2部雷达在不同空气质量条件下探测效果不同,空气质量为优和良时,2部雷达的消光系数比较一致,偏差主要在1 km以下;随着污染加剧,2部雷达在1 km以下的偏差先减小后增大,1 km以上的偏差随高度增大。与AERONET的光学厚度相比,高频激光雷达在轻度污染和严重污染时相对误差较小(3. 23%和26. 75%);微脉冲激光雷达在良和轻度污染时相对误差较小(40. 00%和25. 81%)。2部雷达设备的差异和重污染时不利的气象条件是影响雷达表现的重要原因。该研究作为全国激光雷达联网的前期工作,为全国激光雷达数据的综合应用提供了参考。     

What matters for work engagement? A diary study on resources and the benefits of selective optimization with compensation for state work engagement

This diary study addresses the benefits of employees' daily use of selective optimization with compensation (SOC) for state work engagement. We hypothesized that day‐level SOC not only directly fosters work engagement but that SOC also reveals its beneficial effects for work engagement in interaction with both external and internal resources. Specifically, we proposed SOC substitutes for job control, role clarity, and state of being recovered, thus helping employees manage low daily levels of these resources. We tested our hypotheses with a sample of 138 employees who completed two daily surveys over a total of 545 workdays. Results of multilevel analyses revealed that SOC benefits work engagement in both proposed ways. First, day‐level SOC was positively related to state work engagement. Additionally, day‐level role clarity and state of being recovered predicted state work engagement, but day‐level job control did not. Second, SOC benefitted state work engagement by offsetting low levels of role clarity and being recovered, and by boosting job control in their respective relationships with work engagement. The results suggest that by using SOC at work, employees can actively enhance their own work engagement on a given workday. This knowledge provides promising starting points for the development of interventions.     

晋牛矿1303综放面采空区注氮方案研究及数值模拟

为了合理设计采空区注氮防灭火方案,以晋牛煤矿1303综放工作面为研究对象,通过在采空区进、回风侧布置束管监测系统,连续测定采空区气体浓度变化,划分采空区自燃“三带”分布区域,并基于采空区自燃“三带”划分标准和数值模拟的方法,利用流体力学COMSOL计算软件,研究不同注氮量、注氮位置下采空区氧化自燃带的分布规律。研究结果表明:注氮量和注氮位置参数的变化,对氧化自燃带上界限的影响并不显著,而对氧化自燃带的下界限影响比较显著;最合适的注氮位置应该在距离切顶线30 m左右,运用Origin软件得出注氮量与氧化自燃带宽度呈指数关系,由拟合式计算出最优注氮量为386 m3/h,此时氧化自燃带的宽度为31.5 m。     

固定化包埋亚硝酸菌短程脱氮与同步除磷工艺研究

为实现常温下低碳源城市生活污水的低能耗脱氮除磷,采用固定化技术和厌氧/好氧/缺氧(AOA)工艺耦合与游离组进行了对比实验研究。在温度为25±1℃、pH为8.0±1、DO为1±0.5 mg/L和HRT为9 h的条件下,两组运行结果表明,固定组具有较高的硝化效率和较强的适应能力,亚硝氮的积累率可以稳定维持在70%以上,对NH4+-N、COD和TP的去除率分别为92.2%、87.2%和81.3%,明显优于游离组。     

厌氧氨氧化ASBR中亚硝氮和氨氮降解规律研究

采用生物膜ASBR反应器,研究了厌氧氨氧化反应过程中亚硝氮与氨氮降解速度的变化规律。结果表明,降解过程主要分为2个阶段:速度上升期(0~30 min)和速度下降期(30~150 min)。一阶指数衰减模型的模拟结果表明,20 min以后亚硝氮、氨氮降解速度逐渐减少,亚硝氮降解速度始终高于氨氮降解速度,但是两者差值随时间逐渐减少。     

Potential effects of particulate matter from combustion during services on human health and on works of art in medieval churches in Cyprus

Indoor and outdoor particulate matter (PM_0.3-10) number concentrations were established in two medieval churches in Cyprus. In both churches incense was burnt occasionally during Mass. The highest indoor PM_0.5-1 concentrations compared with outdoors (10.7 times higher) were observed in the church that burning of candles indoors was allowed. Peak indoor black carbon concentration was 6.8 μg m⁻³ in the instances that incense was burning and 13.4 μg m⁻³ in the instances that the candles were burning (outdoor levels ranged between 0.6 and 1.3 μg m⁻³). From the water soluble inorganic components determined in PM₁₀, calcium prevailed in all samples indoors or outdoors, whilst high potassium concentration indoors were a clear marker of combustion. Indoor sources of PM were clearly identified and their emission strengths were estimated via modeling of the results. Indoor estimated PM_0.3-10 mass concentrations exceeded air quality standards for human health protection and for the preservation of works of art.     

Appraisal of measurement methods, chemical composition and sources of fine atmospheric particles over six different areas of Northern Belgium

Daily and seasonal variation in the total elemental, organic carbon (OC) and elemental carbon (EC) content and mass of PM_2.5 were studied at industrial, urban, suburban and agricultural/rural areas. Continuous (optical Dustscan, standard tapered element oscillating micro-balance (TEOM), TEOM with filter dynamics measurement system), semi-continuous (Partisol filter-sampling) and non-continuous (Dekati-impactor sampling and gravimetry) methods of PM_2.5 mass monitoring were critically evaluated. The average elemental fraction accounted for 2-6% of the PM_2.5 mass measured by gravimetry. Metals, like K, Mn, Fe, Cu, Zn and Pb were strongly inter-correlated, also frequently with non-metallic elements (P, S, Cl and/or Br) and EC/OC. A high OC/EC ratio (2-9) was generally observed. The total carbon content of PM_2.5 ranged between 3 and 77% (averages: 12-32%), peaking near industrial/heavy trafficked sites. Principal component analysis identified heavy oil burning, ferrous/non-ferrous industry and vehicular emissions as the main sources of metal pollution.     

臭氧联用技术深度处理腈纶废水的效果对比

将臭氧分别与超声波、H2O2、紫外光等联用,深度处理干法腈纶生产厂生化池出水,对各种联用技术的处理效果进行了研究。实验结果表明：在进水流量2 L/min、反应时间30 min、臭氧加入量3.5 g/（L?h）的条件下,当超声功率为300 W时,臭氧-超声联用技术的COD去除率为30.0%;当H2O2加入量为0.4 mL/L时,臭氧-H2O2联用技术的COD去除率为50.7%;当紫外灯功率为40 W时,臭氧-紫外光联用技术的COD去除率为49.9%;在各种联用技术中,臭氧-H2O2联用技术的运行成本最低（为7.5 元/t）,且处理后出水COD为143 mg/L,达到《<污水综合排放标准>（GB8978—1996）中石化工业COD标准值修改单》中的一级排放标准。综合考虑,臭氧-H2O2联用技术是深度处理干法腈纶废水的最优工艺。