甲醇柴油双燃料燃烧结合DOC/POC耦合大幅度减少发动机微粒排放的研究

对一台四缸增压中冷柴油机采用甲醇柴油双燃料模式,研究了甲醇替代率和柴油机氧化催化转化器耦合微粒催化转化器(DOC+POC)后处理装置对该发动机烟度和微粒数量、质量浓度的粒径分布特性的影响.试验结果表明,随甲醇替代率的增加,发动机烟度和微粒数浓度、质量浓度均有不同程度的降低,核态微粒浓度显著降低,聚集态微粒浓度基本保持不变.相比于DOC+POC对纯柴油发动机排气烟度25%左右的净化效率,在甲醇柴油双燃料模式下DOC+POC对排气烟度的平均净化效率在60%以上,最大达到96%,显示了该后处理技术在甲醇柴油双燃料模式下清洁排放的良好应用前景.     

Characteristics of secondary inorganic aerosol and sulfate species in size-fractionated aerosol particles in Shanghai

Sulfate, nitrate and ammonium(SNA) are the dominant species in secondary inorganic aerosol, and are considered an important factor in regional haze formation. Size-fractionated aerosol particles for a whole year were collected to study the size distribution of SNA as well as their chemical species in Shanghai. SNA mainly accumulated in fine particles and the highest average ratio of SNA to particulate matter(PM) was observed to be 47% in the fine size fraction(0.49–0.95 μm). Higher sulfur oxidation ratio and nitrogen oxidation ratio values were observed in PM of fine size less than 0.95 μm. Ion balance calculations indicated that more secondary sulfate and nitrate would be generated in PM of fine size(0.49–0.95 μm). Sulfur K-edge X-ray absorption near-edge structure(XANES) spectra of typical samples were analyzed. Results revealed that sulfur mainly existed as sulfate with a proportion(atomic basis) more than 73% in all size of PM and even higher at 90% in fine particles. Sulfate mainly existed as(NH4)2SO4 and gypsum in PM of Shanghai. Compared to non-haze days, a dramatic increase of(NH4)2SO4 content was found in fine particles on haze days only, which suggested the promoting impact of(NH4)2SO4 on haze formation. According to the result of air mass backward trajectory analysis, more(NH4)2SO4 would be generated during the periods of air mass stagnation. Based on XANES, analysis of sulfate species in size-fractionated aerosol particles can be an effective way to evaluate the impact of sulfate aerosols on regional haze formation.     

隧道工人的PM10职业暴露特征调查分析及其健康风险评价

针对隧道工人职业健康风险缺乏定量评价方法的现状,借鉴公共环境健康领域暴露评价模型对隧道施工PM10职业暴露的健康风险进行定量评价.设计职业暴露问卷对湖北麻竹高速公路某标段施工中的250名隧道工人进行了调查,并对现场PM10浓度水平进行了监测.结果表明,隧道工人的PM10暴露浓度水平相当高,开挖工、爆破工、支护工、出渣工、二衬工的PM10暴露浓度分别为限值的83倍、18倍、8倍、9倍和9倍;5个工种比较,二衬工日均暴露时间最长,达11.48 h·d-1,能量代谢率最高,达1 067.43 k J·(m2·h)-1,呼吸速率的计算结果显示除二衬工属于重度活动以外,其他4个工种均为中度活动;评价结果显示5个工种均存在健康风险,其中,PM10暴露浓度高是开挖工和爆破工危险系数高的主要原因,而二衬工危险系数高的原因则在于高劳动强度所致的较高的呼吸速率以及较高的日均暴露时间.降低隧道工人PM10健康风险可行的途径是通过配备合适劳动作业的呼吸防护用品从而降低PM10暴露浓度,另外可通过制定相应的职业规范设置合理的劳动年限从而减少持续暴露时间.     

Investigation of trace element atmospheric pollution by nuclear analytical techniques at a global scale: harmonized approaches supported by the IAEA

In the framework of the IAEA programmes, Member States involved in air pollution studies using nuclear analytical techniques have harmonized their methodologies. Participants characterising chemical composition of size fractionated airborne particulate matter based their methodology on a common type of air sampler, centralised data collection and evaluation, and the same kind of data processing. Institutions involved in biomonitoring air pollution identified appropriate organisms to be applied at a regional scale, and harmonized procedures for sample preparation and analysis, as well as data processing and presentation. Both metrology approaches have been validated and disseminated in many Member States.     

ADSORPTION OF PHOSPHATE BY RIVER PARTICULATE MATTER1

ABSTRACT: The adsorption of phosphate on particulate matter from the Illinois and Spoon Rivers was investigated. Adsoprtion reached equilibrium after 5 to 6 days and adsorption isotherms were linear for both constant and varying amounts of particulate matter. Adsorption was maximum at pH 8.3 – 8.4 and minimum at 6.0. Rates of adsorption were influenced by the equilibrium concentration of phosphate-P and were essentially the same for the Illinois and Spoon Rivers. However, the quantity of phosphate-P adsorbed per unit weight of particulate matter differed for the two streams with that in the Illinois River exhibiting an adsorption capacity 7 times that of the Spoon River.     

成都市春季大气飘尘目标变换因子分析

对成都市大气飘尘（ＳＭＰ〈１０μｍ）用目标变换因子分析（ＴＴＦＡ）作源解析。结果表明，主要排放源及其贡献为，道路交通尘（１６．８％），冶金尘（１９．２％），垃圾与草木焚烧烟尘（２４．８％），燃煤飞灰（５４．３％），大气尘污染以煤烟为主。     

Characterizing and Controlling Industrial Dust: A Case Study in Small Particle Measurement

Instrumentation used to measure characteristics of fine particles entrained in gas or suspended in aerosols provides information needed to develop valid regulations for emission sources and to support the design of control technologies. This case study offers a brief history of micromeritics, a term used by early researchers to describe the science of small particles, and the related invention of laboratory instruments for characterizing very fine particles. The historical view provides insights into the role that Progressive Era government agencies played in advancing esoteric science and applying this knowledge to the regulation of workplace air pollution. Micromeritics instrumentation developed in conjunction with federal research now has many commercial applications worldwide, with characterizing airborne pollutants only a minor one. However, the continuing advances in the micromeritics field provide important laboratory measurement capabilities to environmental research organizations, such as the National Institute for Occupational Safety and Health (NIOSH).     

Validation of two air quality models for Indian mining conditions

All major mining activity particularly opencast mining contributes to the problem of suspended particulate matter (SPM)directly or indirectly. Therefore, assessment and prediction are required to prevent and minimize the deterioration of SPM due tovarious opencast mining operations. Determination of emission rate of SPM for these activities and validation of air quality models are the first and foremost concern. In view of the above, the study was taken up for determination of emission rate for SPMto calculate emission rate of various opencast mining activitiesand validation of commonly used two air quality models for Indianmining conditions. To achieve the objectives, eight coal and three iron ore mining sites were selected to generate site specific emission data by considering type of mining, method of working, geographical location, accessibility and above all resource availability. The study covers various mining activitiesand locations including drilling, overburden loading and unloading, coal/mineral loading and unloading, coal handling orscreening plant, exposed overburden dump, stock yard, workshop, exposed pit surface, transport road and haul road. Validation of the study was carried out through Fugitive Dust Model (FDM) and Point, Area and Line sources model (PAL2) by assigning the measured emission rate for each mining activity, meteorologicaldata and other details of the respective mine as an input to the models. Both the models were run separately for the same set ofinput data for each mine to get the predicted SPM concentrationat three receptor locations for each mine. The receptor locationswere selected such a way that at the same places the actual filedmeasurement were carried out for SPM concentration. Statisticalanalysis was carried out to assess the performance of the modelsbased on a set measured and predicted SPM concentration data. The value of coefficient of correlation for PAL2 and FDM was calculated to be 0.990-0.994 and 0.966-0.997, respectively, which shows a fairly good agreement between measured and predicted values of SPM concentration. The average index of agreement values for PAL2 and FDM was found to be 0.665 and0.752, respectively, which represents that the prediction by PAL2 and FDM models are accurate by 66.5 and 75.2%, respectively. These indicate that FDM model is more suited for Indian mining conditions.     

Particulate emission inventory and trends in ambient particulate matter concentrations in the Czech Republic between 1993 and 1999

Trends in total suspended particulates (TSP) emissioninventories were compared with ambient TSP concentrationsduring the period of 1993-1999 in the Czech Republic. TheTSP annual emission decreased within the period of observationfrom 441 300 to 67 000 of metric tonnes (by 85%). During thesame period a less pronounced downward trend from80.3 g m^-3 to 31.5g m^-3 (decrease by 61%)was noted also for the ambient TSP annual average. Differencebetween the two air quality indicators seems to indicate thatchanges in TSP emission inventories from year to year arebeing to some extent overestimated. Monthly ambientparticulate concentrations did not respond to overall drop inemissions proportionately but were closely associated withmonthly mean temperatures. While in the winter the correlationbetween ambient TSP and temperature was negative, in summerthe correlation between the two variables was positive. Inspring and autumn there was no clear correlation betweentemperature and ambient particulate pollution. The improvementof air quality in the Czech Republic since the economical andpolitical transformation in 1990s is substantial whendemonstrated by emission figures, however, true state ofparticulate pollution expressed by ambient levels requiresfurther attention.     

Deposition of Inorganic Particulate Aerosols to Vegetation - A New Method of Estimating

A new, direct method was developed for quantifying inorganic particulate aerosols trapped by the forest canopy, and for determining the resulting input of elements to a forest ecosystem. The method is based on direct measurements of only six parameters. Using this method, it is possible to determine the load of aerosols trapped by the forest canopy and deposited to leaves, as well as the load of aerosols falling to the forest floor by impaction on plants. It is also possible to estimate the aerosol input of soluble and insoluble elements to an ecosystem. With this new method it has been found that the load of aerosols trapped by the canopy of a mixed forest located in the Rybnik Coal Basin averaged 189.0 kg x ha-1 x growing season-1, or 39.3% of the total inorganic particles reaching the ecosystem. The trapped aerosols provided 13.4 kg x ha-1 of soluble nitrogen and 0.91 kg x ha-1 of insoluble nitrogen over the growing season. At the same time, the input of soluble nitrogen from the atmosphere with rainfall to an open area averaged 13.9 kg x ha-1, and the input of insoluble nitrogen with inorganic dusts averaged 1.4 kg x ha-1.