紫色水稻土颗粒有机质对重金属的富集特征

在重庆合川区和铜梁区随机采集了20个紫色水稻土,将其分成颗粒有机质(0.053~2 mm,POM)、砂粒(0.053~2mm)和细土(0.053 mm)这3个组分,通过比较不同组分的有机碳及重金属(Cu、Zn、Pb、Cd)含量和分布状况,研究了紫色水稻土中POM对重金属的富集特征及其与土壤理化性质如pH、CEC、黏粒和土壤有机碳(SOC)等的关系.结果表明,采样区紫色水稻土的POM含量范围为7.31~44.76 g·kg~(-1),平均值为19.20 g·kg~(-1),有机碳含量为96.61~263.17 g·kg~(-1),平均值为151.34 g·kg~(-1),显著高于原土及其他组分,对土壤有机碳的贡献率为8.63%~48.62%,代表了一大部分土壤有机碳库.POM中的Cu、Zn、Pb和Cd平均富集系数分别为3.35、1.14、2.88和2.14,显著高于其他组分,表现出一定的富集作用,对上述重金属的贡献率分别为6.02%、2.22%、5.24%和3.21%,POM对Cu、Pb的富集能力和贡献率均显著大于Zn和Cd.相关分析结果表明,POM含量与SOC、pH、CEC、黏粒(0.002 mm)呈显著或极显著正相关,SOC是主要因素.POM-C含量与总量分别与黏粒含量、SOC呈显著相关.POM中重金属总量与SOC、pH、POM-C总量呈显著或极显著正相关,SOC是最关键因子;与其他重金属相比,Zn在POM中的总量与土壤性质的回归系数最高,关系最为密切.     

应用WRF/Chem模拟河南冬季大气颗粒物的区域输送特征

基于WRF/Chem模式,设置多组区域排放源的情景实验定量估算河南、京津冀、山东、山西、安徽和江苏、湖北6个区域人为源排放对河南省2015年12月PM_(2.5)和PM_(10)浓度贡献率,并结合气象资料研究3个代表性城市的污染输送特征.结果表明:河南省冬季PM_(2.5)和PM_(10)主要来源为本省排放,平均贡献率分别为54.83%、61.32%.区域污染输送对河南颗粒物的贡献也占有很大比例,京津冀、安徽和江苏、山东、山西以及湖北对PM_(2.5)平均贡献率分别为11.95%、11.69%、7.95%、7.40%、4.30%,对PM_(10)平均贡献率分别为10.42%、10.03%、7.00%、6.89%、3.80%.PM_(2.5)外来输送率比PM_(10)要高,表明细颗粒物比粗颗粒物更易跨区域长距离输送.冬季长持续时间的污染过程大多受静风或小风控制,省内污染贡献最大,过程结束时伴随着大风,周边区域的污染贡献有所增加.不同城市的颗粒物来源与其地理位置、风速、风向等气象条件密切相关.区域污染来源具有复杂性,改善河南省空气质量是需要整个区域共同面对和解决的问题.     

喷射时刻对柴油甲醇组合燃烧发动机颗粒物排放的影响

为了进一步减少甲醇掺烧后的柴油机颗粒物排放,在一台由增压中冷的高压共轨柴油机改造成的柴油甲醇组合燃烧(DMCC—diesel/methanol compound combustion)发动机上详细研究了柴油喷射时刻对两种燃料共燃时的颗粒物生成及其排放的影响.试验工况选择重型柴油机常用的A50工况.试验结果表明,当柴油在上止点后喷射时,颗粒物排放的数量浓度随着甲醇替代率的增加而减少,当上止点前喷射时,颗粒物的数量浓度先减少后增加.随着喷射时刻的提前,颗粒中超细颗粒所占比例增大.随着喷射时刻的推迟,甲醇替代率降低颗粒物质量浓度的作用增强,同时甲醇替代率降低颗粒物几何平均直径的作用减弱.     

The Characterisation of Settled Dust by Scanning Electron Microscopy and Energy Dispersive X-ray Analysis

Settled dust has been collected inside the main foyers ofthree University buildings in Wolverhampton City Centre,U.K. Two of the three buildings are located in a streetcanyon used almost exclusively by heavy duty dieselvehicles. The dust was collected on adhesive carbonspectro-tabs to be in a form suitable for analysis byscanning electron microscope and energy dispersive X-rayanalysis. Using these analytical techniques, individualparticle analysis was undertaken for morphology andchemistry. Seasonal variations and variations due tolocation were observed in both the morphologicalmeasurements and chemical analysis. Many of the differencesappear attributable to the influence of road traffic, inparticular, the heavy duty diesel vehicles, travellingalong the street canyon.     

Air quality assessment along Dhanbad - Jharia road

Road ambient air pollution status along Dhanbad – Jharia road isstudied and presented in this article. The selection of this areais made considering the importance of the road in Dhanbad district and the nature of activities taking place along the road, which reflect that the portion of road upto Dhansar can be considered as having commercial areas on both sides and that from Dhansar to Jharia as having industrial areas on both sides.For the assessment of the ambient air quality along the road monitoring is done at the following five locations: Indian Schoolof Mines (ISM), main gate; Bankmore; Dhansar police check post; Dhansar opencast project agent office and a residential house beside the Rajapur opencast project. The location of ISM, maingate is specially chosen as this represents a commercial shoppingcomplexes and the situation can be compared with that at Bankmore. Monitoring of ambient air quality is done following thestandard procedure prescribed in IS: 5182. In addition the concentration of lead, zinc, copper, iron, manganese, cadmium metals in SPM is also monitored. The ambient air quality is monitored in the months of September and November 1999, respectively, to represent monsoon and winter seasons. The SPM concentration observed at all the five locations in the winterseason is more than the permissible limits for commercial andindustrial areas. However, in the monsoon season, the SPM concentration is higher than the permissible limit at the twocommercial locations, i.e., ISM gate and Bankmore, while it isless than the prescribed limit for industrial areas at the remaining three locations. At the ISM gate and Bankmore the SPM generation is mainly by vehicular traffic while at other three locations it was in addition due to mining and other activities.     

大气总悬浮颗粒中有机碳的测定

本文提出一种新的高灵敏度测定总悬浮颗粒中有机碳的方法一元素分析法。该方法是在氧化炉最佳温度为６００℃时，一步测定出样品中有机碳的含量，并成功地对齐齐哈尔市大气总悬浮颗粒中的有机碳进行了连续的监测。结果表明，总悬浮颗粒中有机碳的含量有较明显的变化规律。     

Heavy metals and their source identification in particulate matter (PM2.5) in Isfahan City, Iran

The presence of heavy metals(HMs) in particulate matters(PMs) particularly fine particles such as PM_(2.5) poses potential risk to the health of human being. The purpose of this study was to analyze the contents of HMs in PM_(2.5) in the atmospheric monitoring stations in Isfahan city,Iran, in different seasons between March 2014 and March 2015 and their source identification using principle component analysis(PCA). The samples of PM_(2.5) were taken using a high volume sampler in 7 monitoring stations located throughout the city and industrial zones since March 2014 to March 2015. The HMs content of the samples was measured using ICP-MS.The results showed that the concentrations of As, Cd and Ni were in a range of 23–36, 1–12,and 5–76 ng/m~3 at all the stations which exceeded the US-EPA standards. Furthermore,the concentrations of Cr and Cu reached to 153 and 167 ng/m~3 in some stations which were also higher than the standard levels. Depending on the potential sources of HMs, their concentration in PM_(2.5) through the various seasons was different. PCA illustrated that the different potential sources of HMs in the atmosphere, showing that the most important sources of HMs originated from fossil fuel combustion, abrasion of vehicle tires, industrial activities(e.g., iron and steel industries) and dust storms. Management and control of air pollution of industrial plants and vehicles are suggested for decreasing the risk of the HMs in the region.     

北京城6区大气颗粒物质量浓度变化规律研究

为较好地了解当前北京城6区大气颗粒物PM2.5和PM10质量浓度的污染水平及变化规律,根据2013年3月11日至2014年2月28日城6区12个空气质量实时监测点连续、实时的监测结果,构建多点位、完整时间序列的颗粒物质量浓度数据资料.应用数理统计分析手段,对当前北京城6区大气颗粒物质量浓度的频数分布、相关性和逐时变化特征进行分析,并结合全年实际气象特征,对引起大气颗粒物质量浓度变化的因素进行了初步探讨.结果表明,2013年3月至2014年2月北京城6区大气颗粒物污染较为严重,且PM2.5和PM10质量浓度具有特别显著的线性相关关系,全年相关系数达0.9,10年间无显著变化;二者年均值达91.7 μg/m3和116.9 μg/m3,分别超标162％和67％;二者质量浓度比达78.4％,10年间同比增长约20％.颗粒物质量浓度逐时变化受季节变化影响明显,总体呈现夜间最高、白天最低的趋势,变化周期为7～9h.研究表明,影响颗粒物质量浓度变化的因素包括春季的大风和生物粒子、夏季的湿热和降雨、秋季和冬季的逆温现象和降雪等气象因素及规律性的人为源因素.     

Trace elements in particulate matter of ambient air at petroleum filling stations

Size segregated suspended particulate matter (PM_2.5 and PM_10-2.5) in air at four major petroleum-filling stations in Ile-Ife, Nigeria, were monitored using double staged “Gent” stacked samplers to assess variations in mass loads and elemental concentrations of 25 elements. Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Br, Rb, Sr, Zr, Cs, Ta, W, and Pb were determined in both fractions by external ion beam proton-induced X-ray emission technique. Enrichment factors and pollution indices were calculated and results revealed that most elements were anthropogenic in both fractions with concentrations exceeding the World Health Organization guideline standards.     

表观遗传学机制与空气污染的健康效应

空气污染是一个全球性的问题,并且具有深远的环境影响。暴露于空气污染会对人体健康产生许多不同的影响,理解空气污染的健康效应又是一个复杂命题,既要考虑不同类型的污染物同时也要考虑相关疾病的复杂性。然而越来越多的研究表明,表观遗传学在空气污染相关疾病的发生、发展中发挥着重要的作用。空气污染物可引起DNA甲基化、组蛋白修饰和miRNA表达等表观遗传学改变,这种改变往往发生在疾病产生的早期,因此相关研究不仅可以了解疾病的发病机制,而且还为疾病早期诊断和预防筛选可能的标志物。本文综述了表观遗传学的几种修饰方式和空气污染物造成不良健康损伤机制的一些研究进展。