Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Environmental benchmarks vs. ecological benchmarks for assessment and monitoring in Canada: Is there a difference?

Environmental benchmarks are widely used in Canadian environmental assessment as a standard against which to monitor air or water quality in response to human activities in the environment. Recent work in Canada has developed the concept of ecological benchmarks as a complement to environmental benchmarks. However, implementation of ecological benchmarks may be challenging. This paper presents an analogy between ecological benchmarks and the more commonly used environmental benchmarks, as an attempt to increase understanding and use of ecological benchmarks in resource management, assessment, and monitoring. Ecological benchmarks, and their corresponding indicators, will be challenging to identify and use. However, through the use of the principles of adaptive management, effective ecological indicators and benchmarks can be established. Although it is essential that ecological benchmarks are site-specific, the analogy and general principles outlined here are applicable to assessment and monitoring in any part of the world.     

Can health feasibly be considered as part of the planning process in Scotland?

The planning system is significant because of its capacity to determine the quality of the built environment as well as the health, well-being and quality of life of the individuals and communities therein. Development planning is especially important because of the long-term impact of the decisions. This paper was developed in response to increasing recognition amongst HIA practitioners in Scotland of the importance of planning for health. It focuses on the relationship between the planning system in Scotland, specifically the Development Planning element of it, and population health and considers how the health impact assessment (HIA) approach can facilitate and support joint working with planners. In particular, consideration is given to the potential impact of the introduction of Strategic Environmental Assessment (SEA) on the linkages between health, HIA and planning.     

Prediction of Leachate Level in Kimpo Metropolitan Landfill Site by Total Water Balance

Kimpo metropolitan landfill has received various kinds of wastessince January 1992. The leachate level was measured to be 10.3 m in May 1995 and the level increased to 12.2 m in August 1996. Therefore, to prove the reason for the increasing leachate level, we calibrated hydraulic conductivity of each waste andintermediate layer using the HELP (Hydrologic Evaluation ofLandfill Performance) model. The leachate generation data measured from February 1993 to October 1995 was used in the model calibration. As a result of a model calibration, we obtained anaverage infiltration ratio and used this in analysis of the total water balance to predict elevation of leachate level. Main causes of the elevation of the leachate level were the high water content of the waste and the degradation of the leachate-drainage system caused by the subsidence of a naturalbarrier layer.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

A Watershed-based Cumulative Risk Impact Analysis: Environmental Vulnerability and Impact Criteria

Swine Concentrated Animal Feeding Operations (CAFOs) have received much attention in recent years. As a result, a watershed-based screening tool, the Cumulative Risk Index Analysis (CRIA), was developed to assess the cumulative impacts of multiple CAFO facilities in a watershedsubunit. The CRIA formula calculates an index number based on: 1) the area of one or more facilities compared to the area of the watershed subunit, 2) the average of the environmental vulnerability criteria, and 3) the average of the industry-specific impact criteria. Each vulnerability or impact criterion is ranked on a 1 to 5 scale, with a low rank indicating low environmental vulnerability or impact and a high rank indicating high environmental vulnerability or impact. The individual criterion ranks, as well as the total CRIA score, can be used to focus the environmental analysis and facilitate discussions with industry, public, and other stakeholders in the Agency decision-making process.     

用工业废水排放量预测地面水CODMn灰色方法研究

ＧＰＭ（１）灰色生长曲线常被用于等距时序环境系统的分析建模、非等距摆动空间序列方面的应用尚未报道。本文研究提出了将非等距摆动空间序列经过等距化处理的ＧＰＭ（１）线性回归优化建模方法采用该方法所建的非等距ＧＰＭ（１）模型用于工业废水量预测地面水ＣＯＤＭｎ的实例表明，该方法简捷，方便、精度高于回归分析，有较大实用价值。     

环境污染纠纷调处与环境行政处罚之区别浅析——兼与章锦华同志商榷

指出了环境污染纠纷调处与环境行政处罚的性质，程序，结果等均不相同，在理论上不能将两者混一谈，实践中应区别对待。     

对修改《征收排污费暂行办法》的一些建议

分析了《征收排污费暂行办法》在新形势下存在的问题，并从排污费的征收，管理和使用等方面提出了修改建议。     

博斯腾湖富营养化状态水平调查

通过水质特征和生物学特征的一个水文年规范化实地调查,采用Scirgesew参数分类标准和相关加权综合营养状态指数,对博斯腾湖水体富营养化状态水平进行了调查和评价。