UV/TiO_2膜深度处理垃圾渗滤液的研究

研究了以固定相TiO2为催化剂光催化降解垃圾渗滤液中有机污染物的可行性。试验了制备TiO2膜的适宜条件以及光照时间等各种因素对COD的去除率和UV335脱色率的影响。研究表明,COD为418mg/L的垃圾渗滤液经400W高压汞灯光照30min,COD的去除率和UV335脱色率分别为44.3%和75.0%。光照时间60min时,COD的去除率和UV335脱色率可提高至54%和90%。光照30min后与活性炭柱联用,COD的去除率和UV335脱色率分别提高到68.3%和84.6%。     

Effects of Ca2+ ions antagonistic to Al3+ ions poisoningin root growth , cell division and nucleolusin root tip cells of Allium cepa

The effects of different aluminium chloride concentrations together with varying calciumchloride concentrations on root growth, cell division and nucleoli in root tip cells of Allium cepa werestudied. The concentrations used for aluminium chloride were 10^-4, 10^-3 and 10^-2 mol/L ; and for calcium chloride were 10^-5 , 10^-4 , 10^-3 and 10^-2 mol/L, respectively. The results showed that after thetreatments with 10^-2 to 10^-3 mol/L Al³⁺ , root growth was severely inhibited , a large nurnber of thecells with c-mitosis were induced and the nucleolar material was extruded from the nucleus into the cytoplasm. However , the treatments with 10^-2 to 10^-3 mol/L of Al³⁺ together with 10^-2)to 10^-5 mol/LCa²⁺ suggested that Ca²⁺ gave the obviously protective effects against Al³⁺ poisoning in root growth.cell division and nucleoli of the root tip cells in A. cepa. The possible mechanism of these protective effects of Ca²⁺) is also briefly discussed.     

新型负载型纳米TiO_2光催化降解苯酚的试验研究

以岩棉为载体制备一种新型负载型纳米TiO2,对有机污染物苯酚的降解效果较好。岩棉对苯酚有一定的吸附作用。经过120min的处理,苯酚基本上被完全降解。流速对降解率的影响较大,本试验选择流速为5mL/min。初始浓度越小,苯酚的降解效果越好。通入O2和加入适量H2O2均有利于苯酚的降解,且少量的H2O2可使苯酚的降解率大大提高。苯酚在pH=4.5时降解效果最好。     

TiO2膜固载型多孔催化剂的光催化分解试验

以多孔基质为载体,用溶胶-凝胶法制备出载ＴｉＯ２薄膜的多孔型光催化剂。用Ｘ射线衍射和扫描电镜对催化剂的物相和形貌进行了表征，此催化剂能在光照下分解水溶液中四环素抗菌素。经１ｈ光照，四环素的分解率可达８５％左右。     

纳米复合GeO2/TiO2的制备及光催化性能研究

采用改进的Sol-gel方法,制备了一种新型的单分散椭球形微孔结构的纳米GeO2/TiO2复合光催化剂,并用TG-DTA、XRD、XPS、UV-vis、FT-IR、TEM、BET等手段进行了表征.以难生化降解的染料罗丹明B为目标降解物,采用HPLC测定不同光照时间下催化剂对染料降解的情况,考察了催化剂的光催化活性结果表明,改进的Sol-gel法制得的复合光催化剂具有明显的孔结构,而且比表面积大、粒径小、粒径分布窄、分散性好;与适量GeO2复合后能够有效提高TiO2纳米粒子的光催化活性;复合光催化剂的最佳制备条件为GeO2摩尔含量为0.1%,煅烧温度为400℃,所制得的GeO2/TiO2光催化活性比纯TiO2有显著提高.     

Decomposition of CF3CI by corona discharge

In this paper pulsed corona discharge is shown to be effective for the decomposition of CF₃Cl(Freon-13).The pressure of CF₃Cl was 2.67×10³Pa,after discharged for 2 min,39.5% of CF₃Cl was decomposed.The products were mainly CF₄,Cl₂ and CF₂Cl₂.The yield increased by adding O₂ or air.Under the same conditions,more than 94% decomposition yield was obtained if 5.32×10³Pa O₂ or air was added.The composition of products became CF₂O,Cl₂ and CF₄.While the partial pressure of O₂ or air reached 1 arm,the decomposition yield decreased to 54.5% and 48. 5% respectively.     

Catalysts for decomposing ozone tail gas

The preparation of immobilizing-catalysts for decomposing ozone by using dipping method was studied. XRD, XPS and TEM were used to characterize the catalysts. The three kinds of catalysts were selected preferentially, and their catalytic activities were investigated. The results showed that the catalyst with activated carbon dipping acetate( active components are Mn:Cu = 3:2, active component proportion in catalyst is 15%, calcination temperature is 200℃ ) has the best catalytic activity for ozone decomposing. One gram of catalyst can decompose 17.6g ozone at initial ozone concentration of 2.5g/m^3 and the residence time in reactor of 0.1s. The experimental results also indicated that humidity of reaction system had negative effect on catalytic activity.     

Heterojunctioned CuO/Cu2O catalyst for highly efficient ozone removal

In recent years, near surface ozone pollution, has attracted more and more attention, which necessitates the development of high efficient and low cost catalysts. In this work, CuO/Cu₂O heterojunctioned catalyst is fabricated by heating Cu₂O at high temperature, and is adopted as ozone decomposition catalyst. The results show that after Cu₂O is heated at 180°C conversion of ozone increases from 75.2% to 89.3% at mass space velocity 1,920,000 cm³/(g·hr) in dry air with 1000 ppmV ozone, which indicates that this heterojunction catalyst is one of the most efficient catalysts reported at present. Catalysts are characterized by electron paramagnetic resonance spectroscopy and ultraviolet photoelectron spectroscopy, which confirmed that the heterojunction promotes the electron transfer in the catalytic process and creates more defects and oxygen vacancies in the CuO/Cu₂O interfaces. This procedure of manufacturing heterostructures would also be applicable to other metal oxide catalysts, and it is expected to be more widely applied to the synthesis of high-efficiency heterostructured catalysts in the future.     

超声波处理石化厂剩余活性污泥

采用超声波处理石化污水处理厂的剩余活性污泥。介绍了超声波对污泥的作用机理，初步研究了超声波处理污泥的影响因素。大功率超声波可以降解生物污泥，释放出其中的有机物。小功率超声波能够改善污泥的膨胀特性、提高污泥沉淀特性和脱水能力、降低污泥的含水率，达到减量的目的。经超声波处理并简单过滤的污泥滤液，COD达到4200mg／L左右，污泥含水率由94％降至85％左右。     

贫燃条件下汽车尾气中NOx催化净化研究进展

汽车尾气排放的NOx(主要是NO)是城市大气的主要污染源之一。本综述了近l0年来贫燃条件下NOx催化转化为N2的催化剂研究进展。这些方法包括HC-SCR、NO直接催化分解、NOx吸附-还原等。讨论了不同催化剂的性能影响因素。新的负载材料MFI、MCM-41、SAPO-34的应用增强了催化剂的性能。双功能催化剂由于两种活性位的协同作用表现出较高的活性和选择性。新的纳米结构概念催化剂NOx吸附还原中发现有广泛应用。介绍了上述催化脱除NOx的各种机理并指出了今后研究的方向。