RuO2/La2O3/TiO2悬浮体系中直接耐晒黑G的光催化降解

钛酸丁酯为前驱体,采用溶胶-凝胶-浸渍法制备RuO2/La2O3/TiO2复合光催化剂,以紫外灯为光源,研究了催化剂组成、煅烧温度、溶液pH值等因素对直接耐晒黑G(DFBG)光催化降解的影响.结果表明掺杂量w(La2O3)1.39%、w(RuO2)0.12%、煅烧温度500℃(2 h)、溶液pH值7.3时,光催化活性最佳.当通气量为200 mL/min,催化剂投加量为150mg时,50 mg/L的DFBG溶液经60 min降解,其降解率近100%.DFBG的光催化降解服从Langmuir-Hinshelwood动力学模型,测得相应的动力学参数k=7.42×10-3mmol/L·min,K=19.54 L/mmol.     

An assessment of how distance and diesel oxidation catalyst will impact thermal decomposition behaviors of particles

Decomposition mass loss and pyrolysis products analyses of particles sampled at various locations along the tailpipe of a Euro-IV diesel engine were performed using a thermogravimetry in conjunction with Fourier transformation infrared spectrometry-mass spectrum. Diesel particles were collected at the same location with and without diesel oxidation catalyst (DOC) mounted on the test engine separately. The three poles in thermal gravity-differential thermal gravity images suggested that the decomposition process of diesel particles could be divided into three stages which correspond to the decompositions of lower boiling substances, higher boiling substances and soot respectively. It is noticed that no matter whether DOC was mounted or not, the further the particles were sampled away from the engine block, the lower the peak temperatures and the heavier the mass losses within the first two stages, which indicated that the soluble organic fraction in the particle samples increased and therefore lowering the activation energy of thermal decomposition. Hydroxyl, ammonia, C_xH_y fragments, benzene, toluene, and phenol were found to be the primary products of particle decomposition, which didn't change with the location of particle sample point. The employment of DOC increased the activation energy for particle oxidation and resulted in a higher peak temperature and lower mass loss within the first-stage. Moreover, the CO stretching bands of aldehyde and ketone at 1771 cm^?1 was only detected without a DOC, while the NO₂ peak at 1634 cm^?1 was solely noticed with the presence of DOC. Compared to the first-stage pyrolysis products, more polycyclic aromatic hydrocarbons and less C_xH_y fragments were seen in the second-stage.     

复合催化膜生物反应器处理一氧化氮废气研究

采用溶胶-凝胶法以聚砜(PSF)中空纤维膜为载体制备了Fe-Ti O_2/PSF复合催化膜,以此构建新型复合催化膜生物反应器(HCMBR),实现膜催化与硝化反硝化耦合烟气脱硝,进一步提高NO去除能力.采用Fe-Ti O_2/PSF复合催化膜生物反应器(HCMBR)处理一氧化氮废气,实现了180 d长时间高效稳定运行,NO去除效率可达93.2%,去除能力可达167.1g·(m~3·h)~(-1).适宜运行条件为:气体停留时间9 s、自然光光照强度670 lx,p H为6.8~7.2,n C/n N=3.7.Fe-Ti O_2/PSF复合催化膜加入,复合催化膜生物反应器去除NO的效率比膜生物反应器提高了1.4%~13%,在Fe-Ti O_2/PSF复合催化膜附着稳定的生物膜后,复合催化膜生物反应器去除NO的效率比湿式膜催化反应器提高了59.5%~66%.     

Photocatalytic degradation of dye effluent by titanium dioxide pillar pellets in aqueous solution

Photocatalytic oxidation (PCO) process is an effective way to deal with organic pollutants in wastewater which could be difficult to be degraded by conventional biological treatment methods. Normally the TiO2 powder in nanometre size range was directly used as photocatalyst for dye degradation in wastewater. However the titanium dioxide powder was arduous to be recovered from the solution after treatment. In this application, a new form of TiO2(i. e. pillar pellets ranging from 2.5 to 5.3 mm long and with a diameter of 3.7 mm) was used and investigated for photocatalytic degradation of textile dye effluent. A test system was built with a flat plate reactor(FPR) and UV light source(blacklight and solar simulator as light source respectively) for investigating the effectiveness of the new form of TiO2. It was found that the photocatalytic process under this configuration could efficiently remove colours from textile dyeing effluent. Comparing with the TiO2 powder, the pellet was very easy to recovered from the treated solution and can be reused in multiple times without the significant change on the photocatalytic property. The results also showed that to achieve the same photocatalytic performance, the FPR area by pellets was about 91% smaller than required by TiO2 powder. At least TiO2 pellet could be used as an alternative form of photocatalyst in applications for textile effluent treatment process, also other wastewater treatment processes.     

利用逆向轨迹反演模式估算北京地区甲烷源强

利用连续监测的大气甲烷浓度数据和拉格朗日逆向轨迹反演模式估算出北京甲烷源排放强度，并与根据最新调查数据建立的北京地区甲烷源排放清单进行了比较。排放清单结果表明，北京地区甲烷排放总量为296．4Gg/a，其中，最主要的甲烷排放源为城市垃圾和化石燃料，反映了北京作为一特大城市甲烷排放以人为源为主的特点。利用2000年6月至12月连续观测的有湿合层代表性的北京大气甲烷浓度，通过奇异值分解法（Singular Value Decomposition，SVD）反演出模拟区域的甲烷排放源强度和分布。模式计算与排放清单在甲烷源定性分布上对应较好，定量结果也是合理的。但由于可输入的气象数据有限，轨迹在整个模拟区域内覆盖不均匀，反演出的源块位置有偏差，其中偏差最大的为煤矿的甲烷排放。     

N掺杂TiO_2光催化还原地下水中硝酸盐

以硫酸钛为前驱体,采用水热沉淀法制备TiO2光催化剂,采用扫描电子显微镜(SEM)、X-射线能谱(EDS)、X-射线衍射(XRD)、傅立叶红外光谱仪(FTIR)和光电子能谱仪(XPS)进行表征和分析,考察了硫酸钛浓度、焙烧温度对光催化还原水中硝酸盐活性的影响.结果表明,制备的催化剂为掺杂N的锐钛矿型TiO2.硫酸钛浓度为0.5mol.L-1、焙烧温度为400℃时制备的催化剂活性最佳,反应120min后,硝酸盐转化率为95.8%,中间产物NO--N浓度为0.17mg·mL-1,副产物NH+-N浓度为1.52mg·mL-1.     

沉水植物黑藻腐解过程中营养盐释放过程

为探究沉水植物衰亡过程中营养盐的释放规律,采用黑藻(Hydrilla verticillata Royle)作为研究用沉水植物,在实验室内模拟了黑藻在初春温度下腐解过程中的主要营养盐碳、氮、磷的释放过程.结果表明:黑藻在试验初期迅速腐解,该过程中向水体释放大量碳(81.31%)、氮(81.62%)、磷(85.94%).但随着时间的推移,黑藻向水体释放的磷大部分沉积进入底泥,而氮有部分沉积进入底泥,同时有部分以气体形式移出水体.黑藻腐烂分解产生的厌氧条件以及高TOC供给促进水体反硝化作用加快氮素移出水体.但是较大生物残留量会引起水体缺氧,植物残体分解加剧,导致水质严重恶化,因此需要适时收割水生植物来控制水体残留生物量.     

BiOBr/Bi2MoO6异质结的构筑及对甲基橙的吸附/光催化性能的协同作用机制

采用简单的沉积-沉淀法合成了BiOBr/Bi_2MoO_6(BOB/BMO)异质结,采用XRD、XPS、TEM、SEM、EDS、FT-IR、UV-Vis-DRS、PL、PC和EIS等测试技术对光催化剂的物相组成、形貌、光吸收特性和光电化学性能等进行系统表征,并以模型污染物甲基橙(MO)的吸附和光催化降解作为探针来评价BiOBr/Bi_2MoO_6异质结的吸附性能与光催化活性增强机制.SEM和TEM分析结果表明,所得Bi_2MoO_6微球由大量厚度约为20~50 nm的纳米片组成;沉淀-沉积法所得样品的形貌分析显示,尺寸约为10 nm的BiOBr量子点均匀沉积在Bi_2MoO_6微球表面,形成的新颖的BOB/BMO异质结.N2吸附/脱附结果表明,Bi_2MoO_6和BiOBr形成异质结具有大的比表面积(64.94 m2·g-1),且表面孔结构丰富.吸附/光催化降解实验结果表明,与纯Bi_2MoO_6或者BiOBr相比,BOB/BMO异质结表现出更好的吸附性能和光催化活性.吸附/光催化协同作用机理分析表明,BOB/BMO异质结具有大的比表面积和丰富的孔结构是其吸附性能增强的主要原因.此外,光致发光(PL)谱、光电流(PC)和交流阻抗(EIS)分析进一步揭示了BOB/BMO异质结有利于光生载流子的分离与转移,导致光催化活性增强,二者的协同作用使其对MO具有优越的去除性能.此外,BOB/BMO异质结较稳定,重复使用性能良好,有望用于MO废水的实际处理.     

Ni2+改性的Cu-ZSM-5催化分解NO的性能

研究 Ni²⁺改性的 Cu^- ZSM-5催化剂在无氧和有氧气氛下的 NO分解反应性能 ,考察 Ni²⁺的加入量及加入方式对 Cu-ZSM-5催化剂 NO分解活性的影响 .结果表明 ,先交换适量 Ni²⁺再交换 Cu²⁺的 Ni-Cu-ZSM-5催化剂较单组分 Cu-ZSM-5催化剂有较高的高温 (500℃～600℃) NO分解活性 .在含 5.5% O₂ 的反应气氛中 ,Ni-Cu-ZSM-5在 500℃下的 NO分解率较之 Cu-ZSM-5高出约 20% ,Ni²⁺的引入显著提高了催化剂的抗氧活性 .就 Ni²⁺对 Cu-ZSM-5催化剂的可能改性机制进行了讨论 .     

江苏省工业污染排放特征及其成因分析

采用环境库兹涅茨曲线模型模拟江苏省1991年以来经济增长和工业污染之间的动态演进关系,应用分解分析法对2001～2004年间部分污染物排放变化的成因进行了定量分析.结果表明,江苏省工业污染排放量和人均GDP之间的关系类型有U型、倒U型、U型+倒U型以及N型4种,目前大部分污染物呈增长态势.将污染物排放变化的成因分为规模效应、结构效应和广义技术效应3类,结果显示,规模效应促进污染物排放量增加,结构效应和广义技术效应的作用方向不确定,但广义技术效应对污染物控制有决定性作用,强力的环境政策和管理措施能够有效地控制污染物排放.