光化技术在苎麻脱胶废水处理中的运用

介绍在生化方法的基础上 ,引用光化技术 ,解决苎麻脱胶废水处理这一难题。     

Decomposition of CF3CI by corona discharge

In this paper pulsed corona discharge is shown to be effective for the decomposition of CF₃Cl(Freon-13).The pressure of CF₃Cl was 2.67×10³Pa,after discharged for 2 min,39.5% of CF₃Cl was decomposed.The products were mainly CF₄,Cl₂ and CF₂Cl₂.The yield increased by adding O₂ or air.Under the same conditions,more than 94% decomposition yield was obtained if 5.32×10³Pa O₂ or air was added.The composition of products became CF₂O,Cl₂ and CF₄.While the partial pressure of O₂ or air reached 1 arm,the decomposition yield decreased to 54.5% and 48. 5% respectively.     

Catalysts for decomposing ozone tail gas

The preparation of immobilizing-catalysts for decomposing ozone by using dipping method was studied. XRD, XPS and TEM were used to characterize the catalysts. The three kinds of catalysts were selected preferentially, and their catalytic activities were investigated. The results showed that the catalyst with activated carbon dipping acetate( active components are Mn:Cu = 3:2, active component proportion in catalyst is 15%, calcination temperature is 200℃ ) has the best catalytic activity for ozone decomposing. One gram of catalyst can decompose 17.6g ozone at initial ozone concentration of 2.5g/m^3 and the residence time in reactor of 0.1s. The experimental results also indicated that humidity of reaction system had negative effect on catalytic activity.     

Heterojunctioned CuO/Cu2O catalyst for highly efficient ozone removal

In recent years, near surface ozone pollution, has attracted more and more attention, which necessitates the development of high efficient and low cost catalysts. In this work, CuO/Cu₂O heterojunctioned catalyst is fabricated by heating Cu₂O at high temperature, and is adopted as ozone decomposition catalyst. The results show that after Cu₂O is heated at 180°C conversion of ozone increases from 75.2% to 89.3% at mass space velocity 1,920,000 cm³/(g·hr) in dry air with 1000 ppmV ozone, which indicates that this heterojunction catalyst is one of the most efficient catalysts reported at present. Catalysts are characterized by electron paramagnetic resonance spectroscopy and ultraviolet photoelectron spectroscopy, which confirmed that the heterojunction promotes the electron transfer in the catalytic process and creates more defects and oxygen vacancies in the CuO/Cu₂O interfaces. This procedure of manufacturing heterostructures would also be applicable to other metal oxide catalysts, and it is expected to be more widely applied to the synthesis of high-efficiency heterostructured catalysts in the future.     

超声波处理石化厂剩余活性污泥

采用超声波处理石化污水处理厂的剩余活性污泥。介绍了超声波对污泥的作用机理，初步研究了超声波处理污泥的影响因素。大功率超声波可以降解生物污泥，释放出其中的有机物。小功率超声波能够改善污泥的膨胀特性、提高污泥沉淀特性和脱水能力、降低污泥的含水率，达到减量的目的。经超声波处理并简单过滤的污泥滤液，COD达到4200mg／L左右，污泥含水率由94％降至85％左右。     

贫燃条件下汽车尾气中NOx催化净化研究进展

汽车尾气排放的NOx(主要是NO)是城市大气的主要污染源之一。本综述了近l0年来贫燃条件下NOx催化转化为N2的催化剂研究进展。这些方法包括HC-SCR、NO直接催化分解、NOx吸附-还原等。讨论了不同催化剂的性能影响因素。新的负载材料MFI、MCM-41、SAPO-34的应用增强了催化剂的性能。双功能催化剂由于两种活性位的协同作用表现出较高的活性和选择性。新的纳米结构概念催化剂NOx吸附还原中发现有广泛应用。介绍了上述催化脱除NOx的各种机理并指出了今后研究的方向。     

西江年最高水位的神经网络预报模型

对西江洪水发生的特征进行分析表明，洪水发生频率高，具有明显阶段性特征，并与流域面雨量密切相关。利用前期环流场、海表温度（SST）场及环流特征量资料选择初选预报因子，然后对初选预报因子作EOF分解构造综合预报因子，结合人工神经网络方法建立了西江年最高水位预报模型，并对预报模型进行独立样本试验。结果表明，该预报模型对历史样本拟合精度高，试报效果明显好于传统的逐步回归模型，可在汛期预测业务中应用。     

二甲亚砜热稳定性的实验研究

采用先进的绝热加速量热仪为手段,对二甲亚砜的热稳定性进行了系统研究,其内容涉及纯二甲亚砜的热稳定性、加酸碱和硫化物等杂质后二甲亚砜的热稳定性,包括初始放热温度、温升速率、温度-压力等;通过修正试验数据,消除了热惰性因子的影响;得到了二甲亚砜的热稳定性特性。研究表明,在酸、碱存在时,二甲亚砜在室温下即可发生强烈的放热反应,导致二甲亚砜的分解温度提前。该实验研究结果,对二甲亚砜的安全生产工艺过程控制具有重要参考价值。     

北京市郊区夏季臭氧重污染特征及生成效率

为研究北京郊区夏季O₃(臭氧)重污染过程特征及O₃生成的光化学敏感性,基于2016年夏季在北京郊区开展的针对O₃及其相关污染物的强化观测试验(7月23日—8月31日,共计40 d),分析了观测期间O₃浓度[以φ(O₃)计]变化特征、O₃重污染过程主控因素与O₃敏感性化学特征.结果表明:观测期间φ(O₃)超标时有发生,最大小时φ(O₃)为151.1×10-9,其中有15 d的φ(O₃)最大8 h滑动平均值(O₃-max-8h)超过了GB 3095—2012《环境空气质量标准》二级标准限值,占观测天数的37.5%;不同O₃重污染过程成因有所不同,城市烟羽传输的污染物对郊区O₃重污染过程影响显著(观测期间臭氧重污染过程:过程1,7月27—29日;过程3,8月9—11日;过程4,8月16日;过程5,8月21—24日),区域光化学污染对郊区O₃重污染过程也有贡献(观测期间O₃重污染过程2:8月4—6日);结合后向气流轨迹进一步辅助说明了不同重污染过程中O₃的来源不同.研究还发现,观测区域存在反“周末效应”现象,说明观测区域周末受人为影响较为明显;基于观测数据计算的OPE(O₃生成效率)分析了O₃光化学敏感性表明,在有OPE值的22 d内NO_x控制区和VOCs控制区出现的概率(41%)相等,即观测区域O₃对NO_x和VOCs均敏感;此外还发现,在O₃重污染过程中光化学敏感性会随其反应进程发生改变,由NO_x控制区逐渐转变为VOCs控制区.      

固体云爆剂热分解性能研究

目的研究固体云爆剂的热分解特性。方法利用差示扫描量热(DSC)和热重分析(TG)测定该固体云爆剂的热分解过程。分别得到固体云爆剂在不同温度下的DSC和TG曲线,以及同一温度下云爆剂不同组分的DSC和TG曲线。结合线性回归分析的方法,利用Ozawa法、Starink法以及Kissinger法计算了反应活化能。结果其表观活化能为208 k J/mol左右。结论该固体云爆剂的热分解是一个连续的过程,具有良好的安定性。