焦化废水中有害物质的回收及破坏处理

对焦化厂废水的综合治理进行了讨论，介绍了当前几种先进有效的治理技术。生化处理法需对焦化废水中高浓度的酚、氰、氨先回收利用，之后与其它有害物含量较低的废水汇合进行破坏性处理；催化湿式氧化法净化效率高，流程简单；烟道气治理焦化废水可实现以废治废的目的。     

我国污水资源化存在问题及其对策

我国是缺水国家,水资源短缺严重制约着发展前景,水污染问题又使缺水状况更加突出.实施污水资源化战略可提高水的利用率,缓解部分水资源紧张问题.     

接触氧化-电解工艺处理印染废水

主要介绍了采用生物接触氧化 电解工艺处理印染废水的设计及运行情况。处理系统运行结果表明 :当进水CODCr、BOD5和色度分别为 764 5mg L、2 63 7mg L和 42 0倍时 ,系统出水CODCr、BOD5和色度分别为 160 5mg L、48 9mg L和 12倍 ,去除率分别为 79%、81 5 %和 97 1%。该工艺运行稳定 ,操作控制方便     

MAP法处理氨氮废水最佳条件的研究

MAP法是一种比较新颖有效的处理氨氮的方法，该方法是通过化学沉淀的方式使废水中的氨氢浓度降到很低。而且沉淀反应不受温度、水中毒素的限制。由单项试验以及正交实验的方法对MAP法处理氨氮废水的工艺进行优化研究，结果表明，在pH=8.5，反应时间为3h,Mg:N:P=1:3:1.0:1.1时为较佳反应条件；氨氮的去除率随着反应时间的增加而增加，随着Mg:N比值的增加而增加。     

内电解法处理糠醛废水的工程应用研究

糠醛废水COD浓度高,色度高,其中含有大量的醋酸,pH值在2～3左右,直接生化难度很大。利用内电解处理可以有效地提高废水的可生化性。试验结果表明,进水ρ(CODCr)为12000mg·L-1的糠醛废水,经内电解法预处理后,CODCr去除率也可达到30%左右,可生化性大大提高,为后续的生化处理奠定了基础。     

微型反应柱在含铬废水处理试验研究中的应用

针对镀铬车间废水,采用活性炭吸附处理法对Cr6 和Cr3 的去除效果进行了系统的试验.通过微型反应柱集成装置对穿透时间、吸附容量及活性炭再生方法进行了研究,动态试验表明该装置能有效地处理含铬废水.     

稀土吸附剂对废水深度除磷研究

通过浸渍——干燥——焙烧法制备预载镧氧化物稀土吸附剂，探讨了该吸附剂对水中磷的吸附性能。研究表明在镧离子浓度为0．025mol／1、pH为10-11的溶液中浸渍，于500℃温度下焙烧制得的稀土吸附剂，其除磷效果可达95％。     

Detection of Escherichia coli in wastewater based on enzyme immunoassay

This research describes a fast detection method on the basis of enzyme-linked immunosorbent assay (ELISA) for Escherichia coli in drainage of wastewater treatment plants. Optimized conditions such as the reaction format (sandwich or direct), the concentrations of diluted horseradish peroxidase (HRP)-E. coli conjugate, and anti-HPR antibody and pretreatment of E. coli were studied. Those results showed that the linear range of detection for E. coli was 10 cfu/mL-6 × 10⁴ cfu/mL. Compared with conventional methods, it is a convenient and sensitive detection method with low cost. Translated from Environmental Science, 2005, 26(5): 128–131 [译自: 环境科学]     

高效菌活性污泥法处理分散染料废水实验研究

针对复合微生物的筛选和分离进行了研究 ,分离出处理分散染料废水起高效降解作用的 2株菌种。结果表明 ,2株高效菌对分散染料废水降解能力很强 ,与普通菌结果对比CODCr去除率提高 17% ,并且高效菌对废水浓度的耐受性也明显提高     

Determination and discussion hydraulic retention time in membrane bioreactor system

Based on the microorganism kinetic model, the formula for computing hydraulic retention time in a membrane bioreactor system (MBR) is derived. With considering HRT as an evaluation index a combinational approach was used to discuss factors which have an effect on MBR. As a result, the influencing factors were listed in order from strength to weakness as: maximum specific removal rate K, saturation constant Ks, maintenance coefficient m, maximum specific growth rate ,ua and observed yield coefficient Yobs. Moreover, the formula was simplified, whose parameters were experimentally determined in petrochemical wastewater treatment. The simplified formula is θ= 1.1( 1/β -1)(Kｓ S)/KXo , for oetroehemical wastewater treatment K and Ko eaualed 0.185 and 154.2, resoectively.