Enhanced production of poly(3-hydroxybutyrate) by filamentation-suppressed recombinantEscherichia coli in a defined medium

Fed-batch cultures of recombinantEscherichia coli strains were carried out for the production of poly(3-hydroxybutyric acid) (PHB) in a chemically defined medium. TheE. coli strains used were XL1-Blue, harboring pSYL105, a stable high-copy number plasmid containing theAlcaligenes eutrophus polyhydroxyalkanoate (PHA) genes, and XL1-Blue, harboring pSYL107, which is pSYL105 containing theE. coli ftsZ gene to suppress filamentation. With XL1-Blue(pSYL105) the final cell mass and PHB concentration obtained in 62 h were 102 and 22.5 g/L, respectively. Fed-batch culture of XL1-Blue(pSYL107) under identical conditions resulted in a final cell mass and PHB concentration of 127.5 and 48.2 g/L, respectively. The PHB contents obtained with XL1-Blue(pSYL105) and XL1-Blue(pSYL107) were 22.1 and 37.8%, respectively. Therefore, PHB was more efficiently produced in a defined medium by employing filamentation-suppressed recombinantE. coli.     

絮凝剂对钻井污水ξ电势的影响

钻井污水是一种棕黑色的多组分复杂体系，含有大量粘土粒子、电解质、少量浮油和油田处理剂，基本上属于胶体体系。ξ电势是胶体的一个重要性质，试验中研究测试了几种常用无机絮凝剂处理钻井污水时ξ电势的变化，根据ξ电势的大小及等电点时絮凝剂的用量对其进行了筛选。     

ClO2处理含铁,锰及细菌饮用水的应用研究

为了除去水中高含量的铁，锰及细菌，采用ＣｌＯ２氧化Ｆｅ＾２＋，Ｍｎ＾２＋和灭菌的方法。研究结果表明，处理后水平铁，锰都末检出，细菌指标符合国家饮用水标准。此法具有工艺简单，操作方便，反应速度快，去除率极高，不产生致癌物质ＴＨＭ、且能很好地除水中的异味及色度等优点。此法适用于各种生活给水系统。     

太阳能光催化降解法去除水中罗丹明染料的研究

在太阳光的紫外线辐射下，应用载有ＴｉＯ２薄层的平板式光催化反应器，进行了光催化降解法去除水中罗丹明染料的试验，结果表明，当紫外线辐射强度平均为３３Ｗ／ｍ＾２，反应时间为１８ｍｉｎ时，水中罗丹明染料浓度由１０ｍｇ／Ｌ降至０．０１ｍｇ／Ｌ，在室国家排放标准，探讨了太阳能光催化反应系统的改进方向及工业化应用的有关问题。     

喷射溶气回流浮选工艺处理含油废水

采用喷射溶气回流浮选工艺处理含油废水，替代原来的全加压溶气浮选工艺，提高了浮选过程的处理效果，增强了系统的抗负荷冲击能力，浮选出水油含量由原来的〈４０ｍｇ／Ｌ降至〈２０ｍｇ／Ｌ，ＣＯＤ由原来的〈１５０ｍｇ／Ｌ降至〈１１０ｍｇ／Ｌ。     

Thermal and mechanical properties of poly(lactic Acid) and poly(ethylene/butylene Succinate) blends

In this study, blends of poly (lactic acid) (PLA) with poly(ethylene/butylene succinate) (Bionolle) have been investigated for their thermal and mechanical properties as a function of the concentration of Bionolle. Differential scanning calorimetry (DSC), dynamic mechanical analysis (DMA), and tensile tests were used to characterize the blends. From the results of the DMA and DSC, it was found that this blend system was not miscible within the compositions studied. DSC results showed that adding Bionolle aids in crystallization of PLA. It was observed that increasing the Bionolle concentration led to a slight increase in the strain-at-break of the blends but a decrease in the Young’s modulus and ultimate tensile strength. Biaxially oriented films showed an increase in tensile strength, modulus, and strain-at-break.     

用好氧-厌氧反复耦合固定床生物反应器处理肌苷生产废水

利用由多孔微生物载体构建的好氧-厌氧反复耦合固定床生物反应器进行了高浓度肌苷生产废水处理中试研究。连续84d的运行结果表明，当进水COD为1500-2700mg／L、水力停留时间为22．1h时，出水COD可维持在150mg／L左右，COD去除率达90％～95％。装置运行稳定后，未经沉淀的出水中的固体悬浮物质量浓度小于50mg／L，表明该反应器可避免剩余污泥的产生。中试结果验证了该反应器处理高浓度肌苷废水的可行性和优势，同时为装置放大提供了理论依据。     

日本污水处理及回收再利用实例分析

概述了日本污水处理度再利用的特点和经验；介绍了东京和福冈两个地区的回用实例；探讨了污水回用对回收水水质的关键要求。     

二级处理后的城市污水用作电厂冷却水若干问题的探讨

介绍了二级处理后的城市污水（TSE）用作电厂开式循环冷却水时，由于城市污水中氨氮、微生物及菌类含量较高，可能给循环水系统带来的危害，并探讨了危害产生的原因及控制措施。