Characterisation of PM10, PM2.5 and Benzene Soluble Organic Fraction of Particulate Matter in an Urban Area of Kolkata, India

In this study, the relationship between inhalable particulate (PM₁₀), fine particulate (PM_2.5), coarse particles (PM_{2.5 – 10}) and meteorological parameters such as temperature, relative humidity, solar radiation, wind speed were statistically analyzed and modelled for urban area of Kolkata during winter months of 2003–2004. Ambient air quality was monitored with a sampling frequency of twenty-four hours at three monitoring sites located near traffic intersections and in an industrial area. The monitoring sites were located 3–5 m above ground near highly trafficked and congested areas. The 24 h average PM₁₀ and PM_2.5 samples were collected using Thermo-Andersen high volume samplers and exposed filter papers were extracted and analysed for benzene soluble organic fraction. The ratios between PM_2.5 and PM₁₀ were found to be in the range of 0.6 to 0.92 and the highest ratio was found in the most polluted urban site. Statistical analysis has shown a strong positive correlation between PM₁₀ and PM_2.5 and inverse correlation was observed between particulate matter (PM₁₀ and PM_2.5) and wind speed. Statistical analysis of air quality data shows that PM₁₀ and PM_2.5 are showing poor correlation with temperature, relative humidity and solar radiation. Regression equations for PM₁₀ and PM_2.5 and meteorological parameters were developed. The organic fraction of particulate matter soluble in benzene is an indication of poly aromatic hydrocarbon (PAH) concentration present in particulate matter. The relationship between the benzene soluble organic fraction (BSOF) of inhalable particulate (PM₁₀) and fine particulate (PM_2.5) were analysed for urban area of Kolkata. Significant positive correlation was observed between benzene soluble organic fraction of PM₁₀ (BSM10) and benzene soluble organic fraction of PM_2.5 (BSM2.5). Regression equations for BSM10 and BSM2.5 were developed.     

新型聚硅氯化铁铝絮凝剂的制备及性能

以二甲基二氯硅烷为硅源,与氯化铁、氯化铝聚合制得新型的聚硅氯化铁铝（PSFAC）絮凝剂,考察了制备条件及PSFAC对含油废水和药厂废水的絮凝效果。制备PSFAC的最佳条件：nFc：nAl为0．4,nSi：n（Al＋Fe）为0．1,碱化度为2．0,C（Al,Fe）、为0．1mol／L,熟化时间为1-2d。当PSFAC加入量为10mg／L时,对含油废水、药厂废水的浊度去除率分别为84％和86％。PSFAC具有加入量少、沉降速度快、适用的pH范围较宽等优点。     

含有机物铁泥的超临界水氧化法资源化

氨基染料生产过程中产生大量含有机物的铁泥,对环境造成严重污染并造成资源的极大浪费.利用超临界水氧化法对含有机物铁泥进行资源化处理研究,并对产物进行了X射线衍射分析(XRD)、色差实验与电子探针分析.研究结果显示,用超临界水氧化法处理铁泥可以将铁泥中所含的有机物完全氧化,真正实现环境友好;超临界水首先将铁泥氧化成α-Fe2O3与γ-Fe2O3,再经过800℃煅烧后可以作为氧化铁红颜料使用;超临界反应压力对样品的晶型与颜色影响不大.     

Fe(Ⅱ)/K2S2O8对水体中As(Ⅲ)的氧化研究

研究了Fe(Ⅱ)/K2S2O8对水体中As(Ⅲ)的氧化作用,以及pH值、Fe(Ⅱ)初始浓度等因素对氧化As(Ⅲ)的影响,并且采用分子探针法的竞争性实验鉴定了体系中产生的活性中间体,探讨了K2S2O8在Fe(Ⅱ)存在的条件下对As(Ⅲ)的氧化机理。     

Effects of seed aerosols on the growth of secondary organic aerosols from the photooxidation of toluene

Hydroxyl radical （.OH）-initiated photooxidation reaction of toluene was carried out in a self-made smog chamber. Four individual seed aerosols such as ammonium sulfate, ammonium nitrate, sodium silicate and calcium chloride, were introduced into the chamber to assess their influence on the growth of secondary organic aerosols （SOA）. It was found that the low concentration of seed aerosols might lead to high concentration of SOA particles. Seed aerosols would promote rates of SOA formation at the start of the reaction and inhibit its formation rate with prolonging the reaction time. In the case of ca. 9000 pt/cm^3 seed aerosol load, the addition of sodium silicate induced a same effect on the SOA formation as ammonium nitrate. The influence of the four individual seed aerosols on the generation of SOA decreased in the order of calcium chloride〉sodium silicate and ammonium nitrate〉ammonium sulfate.     

Effect of sulfate on the methanogenic activity of a bacterial culture from a brewery wastewater during glucose degradation

The maximum specific methanogenic activity （SMA） of a sludge originating from a brewery wastewater treatment plant on the degradation of glucose was investigated at various levels of sulfate on a specific loading basis. Batch experiments were conducted in serum bottles at pH 7 and 35℃. A comparison of the values indicates that the SMA of this mixed culture was increased and reached its highest level of 0.128 g CH4 gas COD/（g VSS.d） when biomass was in contact with sulfate at a ratio of 1：0.114 by weight.     

Removal of arsenic from wastewater using iron compound: Comparing two different types of adsorbents in the context of LCA

A study was carried out in order to compare the environmental performance of two different types of adsorbents in removing arsenic (As) from wastewater. A FeCl₃-based adsorbent and a poly-Fe-based adsorbent were first synthesized and their abilities in adsorbing As from wastewater were investigated in terms of the adsorption density and the rate of adsorption. Here, it should be noted that the main material being used in the synthesis of the poly-Fe-based adsorbent was a waste product, known as polyferric sulfate or poly-Fe in short, which exits the manufacturing process of titanium dioxide.Both adsorbents were then compared in the context of life-cycle assessment (LCA). In other words, the experimental results (i.e. the value of the adsorption density and the rate of adsorption) were input into the LCA model in order to assess the environmental performance of each adsorbent in removing arsenic. An estimate for the environmental burden of each option was finally calculated as the sum of the depletion of abiotic resources (ADP), the global warming potential (GWP), the acidification potential (AP), the photo-oxidant formation potential (POCP), the eutrophication potential (EP), and the human toxicity potential (HTP). The main finding of this study was that the adsorption of arsenic by using the poly-Fe-based adsorbent is more attractive treatment option in the environmental protection point of view than the adsorption by using the FeCl₃-based adsorbent, which generates a relatively larger environmental burden.     

聚合氯化铝铁去除微污染水体中藻类的研究

以聚合氯化铝铁(PAFC)为絮凝剂,H2O2为预氧化剂,用正交实验研究了PAFC处理微污染水体中藻类和降低浊度,得出正交实验中各因素的主次关系及对除藻和除浊度的影响,研究表明,ρPAFC是影响除藻和除浊度的重要因素.在最佳处理条件,即ρPAFC为20 mg/L,ρH2O2为6 mg/L,pH为7,搅拌时间为4 min,能使水体中藻细胞街度从9.4×107 cells/L降至3.16×106 cells/L,除藻率为96.6%,浊度降至0.70 NTU,除浊度率达93.0%.     

壳聚糖衍生物-镁盐复配去除中性兰模拟废水色度的研究

研究了有机高分子絮凝剂NCTS-M对中性兰染料的絮凝性能。通过测量絮体的Zeta电位以及对絮体进行彩色电视显微扫描初步探讨了该絮凝过程的絮凝机理。结果表明,当投加量为30 mg/L,pH=6时,絮凝效果最明显,脱色率可达93.1%。其絮凝机理主要是压缩双电层以及高分子吸附架桥作用,以压缩双电层为基础。絮凝剂中镁离子在中性条件下对絮凝过程也起到了较强的助凝作用。     

聚硅酸锌铝的制备及其性能研究

以硅酸钠、硫酸锌、硫酸铝为原料,通过共聚法制备了无机高分子絮凝剂聚硅酸锌铝（PSZAS）,研究了Na₂SiO₃的摩尔浓度、活化时间、Al/Si、Zn/Si 配比及絮凝剂的投加量对絮凝效果的影响,用X-射线衍射（XRD）和电子扫描电镜（SEM）对该絮凝剂的结构及形貌进行了表征。结果表明：当硅酸钠的浓度为0.4 mol/L,硅酸活化时间为2 h,Si∶Al∶Zn=1∶1∶1.5,絮凝剂投加量为20 mL/L废水时,絮凝剂的电中和能力和吸附架桥能力最强,絮凝剂对含H-酸染料模拟废水的絮凝效果最好。