硫酸体系退镀回收ABS电镀件的工艺

利用H2O2-H2SO4体系作为退镀液,考察硫酸浓度、双氧水浓度、液固比和反应时间等因素对丙烯腈-丁二烯-苯乙烯聚合物(ABS)电镀件退镀效果的影响。寻求使ABS塑料和金属完全分离的最优工艺条件。在硫酸质量分数为15%,双氧水质量分数7%,液固比为10,反应时间为50 min时,退镀率可达到99.45%。最后得到硫酸铜、硫酸镍和硫酸的混合溶液,经过探讨选择电积脱铜-蒸发结晶的方式得到阴极铜、海绵铜、黑铜、粗制硫酸镍、黑酸等。     

腐殖酸修饰凹凸棒对U(Ⅵ)的吸附性能及机理

采用腐殖酸(HA)修饰凹凸棒(ATP)制备得到腐殖酸/凹凸棒(HA/ATP),用于去除废水中的U(Ⅵ).通过静态吸附实验,研究了溶液初始pH、投加量、吸附时间和初始浓度对吸附的影响,并用扫描电镜(SEM),X射线能谱图(EDS),傅里叶红外光谱仪(FITR)分析吸附机理.实验结果表明,去除率随时间的增大而增大,在120 min内可以达到平衡;吸附剂投加量越大,溶液pH =6左右时越有利于U(Ⅵ)的去除;HA/ATP能多次重复使用,且经过5次吸附解吸后对U(Ⅵ)的去除率仍能达到96％.吸附过程均符合Langmuir和Frendlich等温方程.较之准一级动力学,准二级动力学模型能更好地拟合实验数据.SEM-EDS、FITR分析结果表明,U(Ⅵ)被成功地吸附到了HA/ATP的表面,吸附机理为络合作用.     

腐植酸强化苯酚厌氧发酵降解

在无外加电子受体的条件下,首次研究了腐植酸对活性污泥厌氧降解苯酚的影响。研究结果表明,腐植酸Suwannee River Humic Acid Standard(SR-HA)、Leonardite Humic Acid Standard(L-HA)和Pahokee Peat Humic Acid(PP-HA)作为氧化还原介体能够提高苯酚的厌氧发酵降解效率。其中腐植酸PP-HA对苯酚的厌氧降解表现出了最为明显的强化效果,反应进行36 h后,苯酚去除率提高了18.5%。当单独投加的PP-HA浓度在0至100 mg/L范围内,苯酚的厌氧降解效率随着腐植酸浓度增加而逐渐提高,而浓度大于100 mg/L后,腐植酸对苯酚降解效率的促进作用随着PP-HA浓度的增加逐渐减缓。除此之外,当低浓度的蒽醌-2-磺酸钠(AQS)(0.02 mM)和PP-HA(20 mg/L)在反应体系中共存时,相比于无介体存在的对照组,苯酚厌氧降解效率提高了约1.4倍。产物分析结果表明,乙酸和CH4作为苯酚发酵降解的重要产物被检测出来。最后,在氧化还原介体腐植酸的存在下,初步探讨了苯酚厌氧发酵降解的代谢途径。     

聚硅酸钛制备及其助凝特性

采用在活化硅酸制备过程中加入适量TiCl4的方法,试制了一种新型无机高分子助凝剂—聚硅酸钛。研究了不同/条件下制备的聚硅酸钛在固定pH值的水中分散物的粒径和Zeta电位随着活化时间的变化趋势,并与活化硅酸作比较。结果表明,在Si/Ti=20,活化48 h的条件下能制备出较为稳定的聚硅酸钛。与活化硅酸相比,聚硅酸钛在水中的分散物具有较大的粒径和更高的Zeta电位。通过对比制备的活化硅酸和聚硅酸钛的红外图谱发现,聚硅酸钛中有Ti-O-Si键,证明钛离子参与了聚合反应,新生成的化学键提高了它的聚合度和稳定性。采用硫酸铝为混凝剂,聚硅酸钛为助凝剂进行混凝除浊实验。测定了絮凝体的Zeta电位和混凝沉淀后的上清液浊度,研究了硫酸铝投加量和混凝pH对聚硅酸钛助凝效果的影响。结果表明,投加适量的聚硅酸钛助凝剂,明显提高了混凝除浊效果且拓宽了有效混凝pH值的范围。     

硫酸盐还原菌污泥固定化特性

采用玉米芯为碳源,聚乙烯醇(PVA)为包埋载体,饱和硼酸(H3BO3)为交联剂,研究了硫酸盐还原菌污泥(SRBS)、铁屑、麦饭石共固处理合成煤矿酸性废水的最优配比与机理,并分析了固定化过程中小球稳定性及活性的变化规律。实验结果表明,SRBS投加量是影响处理效果的最显著因子,当投加30%SRBS、2%铁屑、3%麦饭石时SO42-、Mn2+去除率分别为94.13%和84.39%,溶液pH为7.03,未检测出Fe2+;随着交联时间的延长,小球膨胀率及SO42-还原率分别呈线性与指数下降,从保持小球稳定性与活性角度考虑,可将交联时间设定为4~8 h;该法可为市政污泥的处置以及生物法处理煤矿酸性废水的工程应用提供技术参考。     

TOTAL ARSENIC ACCUMULATION IN EDIBLE PODS AND SEEDS OF PHASEOLUS VULGARIS

The main objective of this study was to evaluate whether arsenic accumulated in the edible pods and seeds of Phaseolus vulgaris, cv. Helda, above the Spanish maximum recommended concentration for food crops, 1 mg kg^?1 on a fresh weight basis. Only organic arsenicals were used because they are: a) the only arsenic species allowed for agricultural applications and b) more mobile than inorganic species. Selection of French beans, a sensitive plant to arsenic, was based on the fact that arsenic upward translocation is higher in sensitive than in tolerant plants. A 2 × 3 factorial experiment was conducted with two organic arsenic species: methylarsonic acid (MAA) or dimethylarsinic acid (DMAA) and three arsenic concentrations: 0.2, 0.5, or 1.0 mg L^?1. Arsenic phytotoxicity was primarily determined by soluble arsenic concentration. Experimental results showed that the low bean plant tolerance to arsenic is possibly due to the high arsenic upward transport to shoots, which could result in profound negative metabolic consequences. Even under extremely adverse conditions, arsenic residues in edible beans were below the maximum statutory limit set by the Spanish legislation. It can be concluded that the major danger of organic arsenical herbicides is that of decreased productivity rather than high arsenic uptake by consumers.     

Electrochemical Monitoring of Methylparathion Degradation in an Acid Aqueous Medium in Presence of Cu(II)

Abstract

A study was undertaken to determine the effect of Cu(II) in degradation of methylparathion (o,o-dimethyl o, 4-nitrophenyl phosphoriotioate) in acid medium. Initial electrochemical characterization of Cu(II) and methylparathion was done in an aqueous medium at a pH range of 2–7. Cu(II) was studied in the presence of different anions and it was observed that its electroactivity depends on pH and is independent of the anion used. Methylparathion had two reduction signals at pH ≤ 6 and only one at pH > 6. The pesticide's transformation kinetic was then studied in the presence of Cu(II) in acid buffered aqueous medium at pH values of 2, 4, and 7. Paranitrophenol appeared as the only electroactive product at all three pH values. The reaction was first order and had k values of 5.2 × 10^?3 s^?1 at pH 2, 5.5 × 10^?3 s^?1 at pH 4 and 9.0 × 10^?3 s^?1 at pH 7. It is concluded that the principal degradation pathway of methylparathion in acid medium is a Cu(II) catalyzed hydrolysis reaction.     

煤基腐殖酸对外源砷胁迫下玉米生长及生理性状的影响简

为了筛选用于砷污染土壤治理的煤基腐殖酸,采用盆栽实验研究了施用不同种类和浓度的煤基腐殖酸及EDTA对外源砷胁迫下玉米株高、株鲜重、株干重、根干重、砷积累量、叶片抗氧化酶（POD,SOD和CAT）活性和脯氨酸含量的影响。结果表明,11种供试煤基腐殖酸均促进了玉米生长,提高了叶片POD、SOD和CAT活性。其中6和10号腐殖酸可降低土壤砷活性和显著抑制玉米吸收和积累砷,而8和9号腐殖酸增加了土壤活性砷和显著促进了玉米对砷的吸收和累积,且不同程度地强于EDTA。除8和9号外,其余腐殖酸均可明显降低玉米叶片脯氨酸的含量。EDTA可显著促进玉米吸收和积累砷,且加剧了砷对玉米的危害。因此,8和9号供试煤基腐殖酸可以替代EDTA活化土壤砷,与植物配合以提高砷污染土壤的植物修复速度和效果,而6和10号供试煤基腐殖酸则可用于土壤砷钝化剂,以保证作物产品的安全。     

Electrochemical oxidation of herbicide bifenox acid in aqueous medium using diamond thin film electrode

The electrochemical oxidation of bifenox acid was studied at a boron-doped diamond thin film by cyclic voltammetry and galvanostatic electrolysis. The course of the electrolysis was monitored by measurement of chemical oxygen demand (COD) and by gas chromatography/mass spectrometry (GC / MS) analysis. It was found that exhaustive electrolysis leads to degradation and, ultimately, to mineralization of the starting herbicide. The degradation intermediates were identified showing that the oxidation process begins with the fragmentation of the molecule followed by reactions involving the hydroxyl radical, which is generated by the discharge of water. The study of the effect of current density and concentration showed that the degradation efficiency increases with decreasing current densities and increasing concentrations. The whole results were interpreted in a mechanistic scheme involving two oxidation pathways, the first is a direct oxidation at the electrode and the second uses hydroxyl radical as mediator of the oxidation. Finally, a kinetic study based on spectrophotometric measurements showed that the degradation process is pseudo first order.     

好氧颗粒污泥对酸性红B的生物吸附模型研究

考察了灭活好氧颗粒污泥吸附酸性红B的吸附等温线、吸附动力学和热力学.结果表明,Langmuir和Redlich-Peterson比Freudlich吸附等温线更符合试验数据,20 ℃时Langmuir最大单分子层吸附量为123.46 mg/g.吸附动力学符合准2级动力学模型.灭活AGS内部扩散过程用Webber-Morris模型拟合,结果表明颗粒内部扩散过程是限速步骤,但边界层扩散和动力学阻力亦不能忽略.热力学分析表明,吸附过程是吸热且自发的过程.