鄂尔多斯气田泥浆池防渗层对有害物质的阻滞作用评价

随着天然气勘探开发速度的加快,鄂尔多斯气田井场废泥浆产生量越来越大,固化处理后将其填埋于有防渗层的泥浆池中是目前该区域最常用的方法,但国内外就气田井场泥浆池防渗层对池内污染物实际阻滞效果的研究报道较少。为研究上述处理方法的实际环境效应,以2010年盆地内正在开发气井井场泥浆池内预固化处理沉淀物的分析结果为参照,选择其中污染程度较为严重的石油类、COD、硫化物和砷、钡、镍、铅、铜4种为重点污染物,选择2005—2009年分别投入使用的5个气田井场废弃泥浆池为考察对象,分析研究了防渗层投运时间对不同污染物阻滞作用的影响。结果表明,投运1年的防渗层可阻留污染物90%以上,投运2年以上的防渗层对污染物的阻滞作用有不同程度下降,投运5年的防渗层对所监测污染物的阻滞作用最好的是钡(40.14%)、最差的为硫化物(10.89%),结合不同时间防渗层破损状况和其对污染物的阻滞效率的变化情况,说明机械刺穿和不均匀降是导致防渗层在研究区域的环境下阻滞功能退化较快的主要原因。     

聚乙烯聚丙烯树脂及废料的热解

研究了聚乙烯聚丙烯树脂及废料的热解过程中,裂解温度对气相产物的收率及组成,液相产物的收率及汽油馏分、柴油馏分、重油馏分的分布,热解残碳收率的影响,将树脂与废料的热解产物及收率进行对比,结果显示：同一热解温度下,树脂与废料热解的液相产物组成及收率基本相同;树脂在４００℃～５００℃热解,液相产物的收率在９０％～９４％之间,无显著区别。     

Sorption kinetics of parent and substituted PAHs for low-density polyethylene (LDPE): Determining their partition coefficients between LDPE and water (KLDPE) for passive sampling

Low-density polyethylene (LDPE) has been widely used as a sorbent for passive sampling of hydrophobic organic contaminants (HOCs) in aquatic environments. However, it has seen only limited application in passive sampling for measurement of freely dissolved concentrations of parent and substituted PAHs (SPAHs), which are known to be toxic, mutagenic and carcinogenic. Here, the 16 priority PAHs and some typical PAHs were selected as target compounds and were simultaneously determined by gas chromatography–mass spectrometer (GC–MS). Some batch experiments were conducted in the laboratory to explore the adsorption kinetics of the target compounds in LDPE membranes. The results showed that both PAHs and SPAHs could reach equilibrium status within 19–38?days in sorption kinetic experiments. The coefficients of partitioning between LDPE film (50?μm thickness) and water (K_LDPE) for the 16 priority PAHs were in good agreement with previously reported values, and the values of K_LDPE for the 9 SPAHs are reported in this study for the first time. Significant linear relationships were observed, i.e., log K_LDPE?=?0.705?×?log K_OW?+?1.534 for PAHs (R²?=?0.8361, p?<?0.001) and log K_LDPE?=?0.458?×?log K_OW?+?3.092 for SPAHs (R²?=?0.5609, p?=?0.0077). The selected LDPE film was also proven to meet the condition of “zero sink” for the selected target compounds. These results could provide basic support for the configuration and in situ application of passive samplers.     

淀粉聚乙燃膜在受控条件下的好氧生物降物

采用土埋、真菌生长和ＣＯ２释放试验分别测定了几咱淀粉聚乙烯膜的生物降解性。试验结果表明，膜的生物降解性与膜中的淀粉含量正相关，并受膜比面积大小的影响。在受控条件下，含淀粉６％～３０％的经２８ｄ降解后，降解质量变化率在０．６％～１２．４％范围内，其ＣＯ２释放量为０．０２～０．１５ｍｇ／ｍｇ膜，中的聚乙烯组分不仅本身难被生物降解，而且还抑制微生物对其淀粉组分的降解。ＣＯ２是淀粉聚乙烯膜好氧生物降解的降     

晶硅切割废砂浆回收企业废水处理工程实例

晶硅切割砂浆中含有聚乙二醇(PEG)和碳化硅,可回收资源。回收过程中产生的废水中仍然含有PEG和碳化硅,以致废水中悬浮物浓度较高、可生化性差。工程设计采用"预沉淀+混凝沉淀+气浮+催化氧化+A/O生化"处理工艺,经过5个月的调试运行,出水COD、SS可达GB 8978—1996《污水综合排放标准》三级标准。     

两种悬浮填料在ASBBR厌氧氨氧化系统中的性能比较与微生物解析

选取聚乙烯（T1）和聚氨酯（T2）两种悬浮填料投入到两套相同厌氧序批式生物膜反应器（ASBBR）R1和R2中,以城市生活污水为配水基质,考察了两种填料在ASBBR中的性能及菌群结构特征,选出更适宜厌氧氨氧化（ANAMMOX）菌生长的填料.结果表明：R1和R2反应器分别在第93 d和73 d成功启动厌氧氨氧化,并实现稳定运行.稳定运行阶段,R1、R2系统总无机氮（TIN）平均去除率分别达88.34%、87.97%.此外,运行第150 d时,测得单个T1、T2填料的ANAMMOX菌活性分别为5.70和3.70 mg·g^-1·h^-1.同时,扫描电子显微镜（SEM）表征结果证明,球状菌在T1填料上的数量比同倍数下T2填料上多,且杂菌较少.高通量测序结果显示,T1、T2填料上Candidatus anammoxoglobus菌属相对丰度分别为75.29%和38.23%.本研究表明,相比于聚氨酯（T2）填料,聚乙烯（T1）填料更适宜ANAMMOX菌的富集.     

20万t/a聚乙烯装置危险性分析及对策

本文针对20万t聚乙烯气相流化床工艺的装置，从生产工艺、设备、职业危害、检修等过程进行了全面危险性分析，并提出了相关的对策。     

Degradation of Polyethylene Designed for Agricultural Purposes

For many years now, scientific articles have been published on the potential biodegradability of polyethylene. Polyethylene (PE) with peroxidant additives, in the form of agricultural films, is sold by various suppliers as biodegradable mulch. Even though, the photo-chemical and thermal degradation of these products under artificial laboratory conditions is highlighted, several extrapolation on the biodegradation and, moreover, on the neutral environmental impact of PE are made. In this study, three different commercial mulch films have been submitted to standardised biodegradation tests and the results are discussed. The first conclusions are that a very low degree of biodegradation of the commercial PE films is achieved from these tests and that crosslinked PE micro-fragments are found in soil after a very long period of time.     

包埋厌氧氨氧化的脱氮特性及其微生物群落结构

采用聚乙二醇二丙烯酸酯作为载体,分别以N,N,N,‘N’-四甲基乙二胺（TEMED）,过硫酸钾（KPS）作为促进剂和引发剂,对厌氧氨氧化菌进行包埋固定化.采用正交试验优化包埋条件,得到的最佳条件为：10% PEGDA单体,0.25% KPS,0.5% TEMED,最佳的操作条件为：聚合温度20℃,聚合时间控制在5min左右,菌胶比选取1：1.包埋颗粒的连续流实验表明,颗粒经过短暂的活性恢复后,脱氮效果不断提升,并且对水力负荷的提高有一定的抗冲击能力.扫描电镜（SEM）表明本实验包埋材料具有很好的生物相容性,且具有良好的传质性能.高通量测序显示,稳定运行一段时间后,颗粒内微生物多样性略有减小,厌氧氨氧化功能菌Candidatus Kuenenia占整个微生物体系比例由6.58%上升至9.8%,微生物种群的变化说明了包埋后厌氧氨氧化性能能够得到更大的提升.     

可光－生降解聚乙烯薄膜的降解性能试验

用自然光照法、模拟光照法和堆肥法进行了可光一生降解聚乙烯薄顺和普通聚乙烯薄膜的光降解和微生物降解对比试验。结果表明，前者的光降解和微生物降解性能都明显优于后者。