聚环氧琥珀酸萃取锰泥残渣中铬的研究

聚环氧琥珀酸(PESA)是一种具有无磷及非氮结构、环境友好型水溶性聚合物,且具有螯合多价金属阳离子的性能和可生物降解性的特征,选取其作为锰泥残渣中铬的螯合萃取剂,研究了不同pH、螯合萃取剂剂量、搅拌时间下PESA对铬的萃取率。结果表明:(1)最佳萃取条件为pH=4、PESA剂量30mg/g、搅拌时间60min;在最佳萃取条件下,铬的萃取率可达95%。(2)从结构上看,PESA是由醚基和羧基基团组成的高分子聚合物,羧基基团是与金属离子作用的主要官能团,它对Ca2+、Mg2+、Zn2+、Cr(Ⅲ)、Cr(Ⅵ)和Pb2+等有较强的螯合能力;从溶液的配位角度看,PESA与金属有较强的结合能力。因此,PESA对锰泥残渣中的铬有萃取作用。     

废LCD面板有机材料水热资源化产乙酸

LCD面板主要由附着偏光片及液晶等有机材料的玻璃面板构成。有机材料的去除及资源化利用是废LCD面板处理的第一步。在水热条件下对废LCD面板进行了降解产酸研究。研究考察了反应温度、反应时间、氧化剂用量、水用量及pH值等对水热产乙酸产率及选择性的影响。通过正交实验确定了水热产乙酸的最佳操作条件：反应温度325℃,反应时间5min,氧化剂（30％H2O2）0．6mL,用水量2mL,近中性环境（pH6-6．5去离子水）。此条件下,乙酸产率及选择性分别为68．83％及70．56％。结果表明,以废LCD面板有机材料为原料,采用水热技术进行产乙酸反应,可实现其资源化再利用。     

Fe(Ⅱ)EDTA络合吸收-铁粉还原再生脱除NO性能

利用Fe(Ⅱ)EDTA络合吸收-铁粉间歇还原再生脱除NO并回收氨资源的方法,实验研究了铁粉还原再生Fe(Ⅱ)(NO)EDTA的过程及其影响因素。结果表明,以0.015 mol/L的Fe(Ⅱ)EDTA做吸收剂,在起始pH 5.5、温度323K条件下吸收400×10-6~500×10-6的NO,脱除率95%以上;铁粉还原再生Fe(Ⅱ)(NO)EDTA过程可用缩芯模型阐释;铁粉添加量与搅拌强度直接决定了铁粉质点数量,是影响反应的重要因素;实验中Fe(Ⅱ)(NO)EDTA络合液150 mL,氧气含量为5%时,搅拌速度900 r/min、粒径为0.12 mm的铁粉浓度5.3 g/L、温度353 K、pH=6为最适宜再生条件。     

氧化铁改性砂联合生物预处理对氨氮的吸附特性

对含氨氮(NH3-N)的微污染原水,采用自制氧化铁改性石英砂(iron oxide coated sand,IOCS)滤料强化过滤与生物预处理技术联合,进行强化处理与吸附效果研究.结果表明,采用强化挂膜法,生物预处理反应器的生物膜成熟期约为7 d,其对氨氮的去除率为60%~70%,但反应器中存在亚硝酸盐氮积累的现象.IOCS与生物预处理技术联合,对NH3-N的平均去除率为84.67%,出水NH3-N浓度均低于0.5 mg/L,NO2--N含量趋于0;而普通石英砂(RQS)在同等条件下,对氨氮的去除效果不稳定,平均去除率为74.31%,出水NH3-N平均浓度未达标,对NO2--N平均去除率仅有33.29%.在4 m/h滤速工况下,与生物预处理技术联合,IOCS和RQS对NH3-N最高去除率分别为94.3%和82.72%.IOCS与RQS的表面形态结构存在明显差异:前者的表面结构更加复杂多孔,比表面积大,有利于生物牢固附着;后者表面较光滑,比表面积小,挂膜后生物易脱落.     

A detailed field-based evaluation of naphthenic acid mobility in groundwater

An anaerobic plume of process-affected groundwater was characterized in a shallow sand aquifer adjacent to an oil sands tailings impoundment. Based on biological oxygen demand measurements, the reductive capacity of the plume is considered minimal. Major dissolved components associated with the plume include HCO₃, Na, Cl, SO₄, and naphthenic acids (NAs). Quantitative and qualitative NA analyses were performed on groundwater samples to investigate NA fate and transport in the subsurface. Despite subsurface residence times exceeding 20 years, significant attenuation of NAs by biodegradation was not observed based on screening techniques developed at the time of the investigation. Relative to conservative tracers (i.e., Cl), overall NA attenuation in the subsurface is limited, which is consistent with batch sorption and microcosm studies performed by other authors. Insignificant biological oxygen demand and low concentrations of dissolved As (< 10 µg L^− 1) in the plume suggest that the potential for secondary trace metal release, specifically As, via reductive dissolution reactions driven by ingress of process-affected water is minimal. It is also possible that readily leachable As is not present in significant quantities within the sediments of the study area. Thus, for similar plumes of process-affected groundwater in shallow sand aquifers which may occur as oil sands mining expands, a reasonable expectation is for NA persistence, but minimal trace metal mobilization.     

汞(Ⅱ)和砷(Ⅲ)在草炭土胡敏酸上的吸附

为研究汞和砷在胡敏酸上的吸附特性,从辽宁彰武采集了草炭土并用稀碱法提取胡敏酸。研究胡敏酸对Hg（Ⅱ）和As（Ⅲ）吸附作用,探讨温度（15、25、35、45℃）、pH（3,5,7,9）和离子强度（Ca2+,H2PO4-）对该吸附的影响,并计算吸附活化能。结果表明：温度与胡敏酸对Hg（Ⅱ）的吸附呈显著正相关,而对胡敏酸吸附As（Ⅲ）的影响较小;pH对胡敏酸吸附Hg（Ⅱ）也呈正相关,而胡敏酸对As（Ⅲ）的吸附以中性最好,酸性、碱性下吸附量均降低;Ca2+对Hg（Ⅱ）的吸附有明显的抑制作用,H2PO4-对As（Ⅲ）的吸附影响很小。对等温吸附实验结果拟合证明,胡敏酸对Hg（Ⅱ）和As（Ⅲ）等温吸附更符合Freundlich模型。对动力学吸附实验结果拟合证明,准二级动力学方程能很好地描述胡敏酸对Hg（Ⅱ）和As（Ⅲ）的吸附。Hg和As（Ⅲ）在胡敏酸的吸附活化能分别为23.06 kJ·mol-1和2.65 kJ·mol-1,表明Hg（Ⅱ）在胡敏酸上的吸附以化学吸附为主,As（Ⅲ）在胡敏酸上的吸附以物理吸附为主。     

CTL-12型化学需氧量速测仪与标准法测定CODCr之比较

使用CTL—12型化学需氧量速测仪分析废水化学需氧量，简便、快速，且方法可行，完全能满足环境监测技术要求。     

离子色谱法测定丙烯酸丁酯生产废水中丙烯酸和对甲基苯磺酸

建立了用离子色谱法测定丙烯酸丁酯生产废水中丙烯酸和对甲基苯磺酸的新方法。采用IonPac AS11-HC阴离子色谱柱,淋洗液为30mmol/L的NaOH淋洗液,流速1ml/min,抑制电流75mA。丙烯酸根的检测下限为0.44mg/L(峰面积)、0.46mg/L(峰高),保留时间、峰高、峰面积的变异系数分别为0.03%、0.50%、0.50%,峰高、峰面积的线性回归系数R分别为0.9929、0.9954。对甲基苯磺酸根的检测下限为0.49mg/L(峰面积)、0.48mg/L(峰高),保留时间、峰高、峰面积的变异系数分别为0.02%、0.48%、0.47%,峰高、峰面积的线性回归系数R分别为0.9990、0.9998。常规无机阴离子对丙烯酸、对甲基苯磺酸的测定没有干扰。对实际废水样品进行分析,丙烯酸、对甲基苯磺酸的回收率分别为101.6%～104.4%、95.4%～96.8%。方法简便、灵敏、可靠。     

南京市典型地区大气多环芳烃污染特征及健康风险评价

采用气相色谱-质谱法,于2016年9月和12月对南京市2个典型地区大气中16种多环芳烃(PAHs)的质量浓度进行分析,并开展了PAHs组成特征、来源解析及人体健康风险评价研究。结果表明,工业区(六合区)和生活区(江宁区)大气(气态和可吸入颗粒态)中16种PAHs的质量浓度分别为914.82和712.27 ng/m~3,苯并[a]芘毒性等效浓度分别为274.1和309.84 ng/m~3,且呈现冬季高、秋季低的特征。比值法源解析结果表明,燃煤污染是六合区PAHs污染主要来源,而江宁区主要表现为交通污染。人体健康风险评价结果表明,六合区和江宁区人群通过大气吸入PAHs的超额致癌风险分别为5.17×10~(-5)和5.85×10~(-5),均略高于可接受水平10~(-6)。     

Application of CFD Methods for Modelling in Air Pollution Problems: Possibilities and Gaps

Different urban air pollution problems deal with complex structure of air flows and turbulence. For such problems the Computer Fluid Dynamics (CFD) methods become widely used. However, this approach despite a number of advantages has some problems. Experience of use of CFD tools for development of models and suggestions of their applications for a local scale air pollution over a complex terrain and stable stratification are discussed in this paper, including: Topography and complex geometry: choose of the co-ordinate system and computer grid; Turbulence closure for air pollution modelling: modified k- model for stable stratified ABL; Boundary conditions for vertical profiles of velocity for stable-stratified atmosphere; Effects of the radiation and thermal budget of inclined surfaces to dispersion of pollutants; Artificial sources of air dynamics and circulation.Some examples of CFD applications for air pollution modelling for a flat terrain, mountainous area, mining open cast and indoor ventilation are discussed. Modified k- model for stably-stratified ABL is suggested. Due to the isotropic character of the k- model a combination of it in vertical with the sub-grid turbulence closure in horizontal can be more suitable for ABL. An effective scheme of boundary conditions for velocity profiles, based on the developed similarity theory for stable-stratified ABL, is suggested. Alongside with the common studies of atmospheric dispersion, the CFD methods have also demonstrated a good potential for studying anthropogenic and artificial-ventilation sources of air dynamic and circulation in local-scale processes of air pollution.