硫酸盐生物还原的限制性生态因子的影响研究

利用厌氧颗粒污泥对烟气中SO2吸收生成的硫酸盐或亚硫酸盐废水进行处理,考察起始SO4^2-质量浓度、初始COD／SO4^2-、初始pH、接种污泥质量、亚铁离子等限制性生态因子对硫酸盐还原的影响。结果表明：在起始SO4^2-质量浓度800mg／L,初始COD／SO4^2-为3．0,pH值为7．0,接种污泥质量为31．10gVSS／L,添加亚铁离子的条件下,进行半连续试验,硫酸根去除率可迭70％。表明在COD／SO4^2-较低的条件下,各生态因子综合作用下,硫酸盐还原可得较好效果。     

气相色谱/负离子化学电离质谱法测定地表水中硫丹及其代谢物

采用气相色谱/负离子化学电离质谱法测定地表水中的硫丹及其代谢物,用正己烷提取,外标法定量。α-硫丹、β-硫丹及硫丹硫酸酯在0.200μg/L～10.0μg/L范围内线性良好,方法检出限分别为0.010μg/L、0.008μg/L及0.010μg/L,空白加标平行测定的RSD为3.9%～4.8%,地表水样品加标回收率为85.5%～93.8%。     

Effects of moisture and particle size distribution on flame propagation of L-lysine sulfate powder

Lysine is an essential amino acid for human body, and lysine sulfates are at risk of fire and explosion during the production and processing. However, there is no public report on the lysine sulfate powder explosion hazard research. In this paper, the effects of moisture, mass concentration and particle size on the flame propagation behaviors of L-lysine sulfate powder were studied in a vertical pipe. The results showed that the flame propagation could be divided into 3 stages: free propagation, acceleration and attenuation, in which the acceleration was owed to the positive feedback of combustion reaction, gas expansion and turbulence. Moisture content could promote the flame propagation of L-lysine sulfate powder to a certain extent, but it had a strong inhibitory effect on the explosion when the moisture content was too large. The flame propagation velocity increased with the decrease of the average particle size of powder,.With the increase of the particle concentration, the flame propagation velocity of powder explosion increased first and then decreased, that was, there was an optimal concentration of powder explosion, and the powder was more sensitive to the change of concentration in the range of low concentration.     

湿法烟气脱硫石膏制备硫酸铵

采用湿法烟气脱硫石膏为原料,与( NH4)2CO3反应,制备(NH4)2SO4.通过X射线衍射仪表征可知:脱硫石膏的主要成分为CaSO4,反应后CaSO4中的Ca2+大部分以CaCO3形式存在于固体沉淀物中,CaCO3粉末平均粒径为80 nm;而原先CaSO4中的不溶性SO2-4则与NH+4结合生成(NH4)2SO4,...     

可再生湿法烟气脱硫过程有机胺吸收液中硫酸根的测定

为了快速准确测定可再生湿法烟气脱硫过程有机胺吸收液中的p(SO2-4),建立了以茜素红为指示剂,用BaCl2直接滴定测定有机胺吸收液中p(SO2-4)的方法.实验结果表明:当试样pH为4.0 ～4.5时,方法的相对误差为0.28％-0.62％,加标回收率均在97％以上;SO2-3的存在会使p(SO2-4)的测定结果偏大...     

不同形态铁盐的除磷效果

研究不同铁盐存在形态的铁盐类混凝剂,即三氯化铁(离子态铁)、聚合氯化铁(聚合态铁)和氢氧化铁(凝胶态铁),在混凝除磷性能方面的差异。以城市污水厂的二级出水为实验水样,进行混凝除磷性能研究。结果表明,二级出水总磷为1.74 mg/L,离子态铁投加量为40 mg/L时,对总磷的去除率为90%,混凝处理后上清液总磷可达《城镇污水处理厂污染物排放标准》(GB18918-2002)中的一级A标准,聚合态铁对总磷的去除率为62%,凝胶态氢氧化铁的总磷去除率为59%,混凝处理后上清液总磷均不能满足GB18918-2002中的一级A标准。离子态氯化铁对污水厂二级出水的除磷效果优于聚合态,即铁离子的聚合形态会影响其除磷效果。     

序批式工艺制备生物聚合硫酸铁混凝剂

本实验研究了序批式工艺(SBR)制备生物聚合铁混凝剂过程中主要影响因素(接种微生物浓度、起始亚铁离子浓度)对亚铁离子氧化速率的影响。研究结果显示,在受试实验条件内,较高的接种微生物浓度和较低的起始Fe2+浓度有利于Fe2+氧化,Fe2+浓度变化与反应时间呈线性关系;当起始Fe2+浓度为20 g/L,接种细菌浓度约为8×108个/mL时,Fe2+氧化速率最大,最大值可达到0.375 g/(L.h)。在反应过程中生成了少量黄色沉淀,经傅里叶变换红外光谱分析后确定其主要成分为黄钾铁矾。合成的生物聚合硫酸铁经过干化后各项指标均符合《水处理剂聚合硫酸铁》(GB 14591-2006)之规定。对比实验表明,自制生物聚合硫酸铁海水混凝时性能优于实验所选品牌的商业产品。     

循环流化床灰制备聚合氯化铝铁絮凝剂

以煤矸石电厂循环流化床灰(CFB灰)为原料,采用酸浸、水解、聚合和熟化等工艺过程,制备聚合氯化铝铁(PAFC)絮凝剂产品。重点对制备PAFC絮凝剂的酸浸工艺参数进行研究,其最佳工艺条件为:盐酸浓度为20.2%、酸浸温度为110℃、酸浸时间为2 h、液固比为4∶1;Fe2O3浸出率为90.6%,Al2O3的浸出率为48.5%。同时采用实验得出的最优工艺参数进行了产品制备,并对产品进行了絮凝性能实验。结果表明,在相同条件下PAFC的絮凝效果明显好于聚合氯化铝(PAC),用CFB灰制备PAFC絮凝剂产品是可行的。     

钟市油田井下管柱腐蚀断裂机理与防治

针对钟市油田井下管柱腐蚀现状,通过分析注入水、环空水水化学成分及pH值、细菌等水质指标,结合断裂管柱腐蚀产物成分,研究管柱腐蚀断裂机理。结果表明,钟市油田注入水SO2-4质量浓度高达4 398.2 mg/L,利于硫酸盐还原菌(SRB)繁殖生长,SRB代谢产生H2S导致腐蚀加剧是注水井井下管柱断裂的主要原因。环空注入杀灭环空菌是解决管柱过早腐蚀断裂的有效方法,文章应用的环空保护液杀菌率100%、腐蚀速率0.058 mm/a,现场试验结果达到国家标准要求。     

Effect of competing solutes on arsenic(V) adsorption using iron and aluminum oxides

The study focused on the effect of several typical competing solutes on removal of arsenic with Fe2O3 and Al2O3. The test results indicate that chloride, nitrate and sulfate did not have detectable effects, and that selenium(IV) (Se(IV)) and vanadium(V) (V(V)) show slight effects on the adsorption of As(V) with Fe2O3. The results also showed that adsorption of As(V) on Al2O3 was not affected by chloride and nitrate anions, but slightly by Se(IV) and V(V) ions. Unlike the adsorption of As(V) with Fe2O3, that with Fe2O3 was affected by the presence of sulfate in water solutions. Both phosphate and silica have significant adverse effects on the adsorption of As(V) adsorption with Fe2O3 and Al2O3. Compared to the other tested anions, phosphate anion was found to be the most prominent solute affecting the As(V) adsorption with Fe2O3 and Al2O3. In general, Fe2O3 has a better performance than Al2O3 in removal of As(V) within a water environment where multi competing solutes are present.