308 nm光作用下α-Fe2O3表面HNO3的光解

采用紫外可见光谱(UV-Vis)、傅立叶变换红外光谱(FTIR)及离子色谱(IC)技术对HNO3在α-Fe2O3表面暗反应和308nm下光解反应进行了研究.考察了时间、HNO3浓度、相对湿度(RH)等条件对反应的影响.结果表明,随着HNO3浓度、光照时间的增加,HNO3在气相与α-Fe2O3表面光解产物浓度均呈指数增加;HNO3在α-Fe2O3表面光解产生的NO2、NO分别为气相产生的3.27及3.87倍,而无论气相还是表面光解的NO2浓度均约为NO的2倍.随着RH的增加,HNO3光解产生的HONO的浓度随之呈指数增大,其产率从RH 20%时的0.023增加到90%时的0.087.α-Fe2O3的表面效应在HNO3的表面光解反应中起主导作用.     

地膜覆盖对菜地生态系统N2O排放的影响

为了探讨地膜覆盖对菜地N_2O的排放通量、土壤剖面N_2O浓度以及土壤温度和湿度的影响,选取西南地区常见菜地(辣椒-萝卜轮作)为研究对象,采用静态暗箱/气相色谱法,进行了为期1 a的野外观测实验.结果表明,在辣椒季,常规处理(不覆膜)N_2O的平均排放通量为1000.0μg·(m~2·h)~(-1),覆膜处理为400.6μg·(m~2·h)~(-1),覆膜显著低于常规处理(P0.05);而在萝卜季,N_2O的平均排放通量则表现为覆膜处理[128.1μg·(m~2·h)~(-1)]高于常规处理[107.8μg·(m~2·h)~(-1)],但两者差异未达到显著水平(P0.05).覆膜和常规菜地土壤中N_2O含量均基本随土层深度的增加而增加,表现为:30 cm20cm10 cm,相同处理各层次土壤N_2O含量间均呈显著相关,不同处理相同深度处的土壤N_2O含量间也存在显著的正相关关系.对不同土层中的N_2O含量与地表N_2O排放通量的相关性分析可得出,常规处理各土层处的N_2O含量与地表N_2O排放通量呈显著正相关关系.覆膜处理的N_2O排放通量仅与30 cm深土壤中的N_2O含量存在显著正相关关系.通过对土壤湿度和温度的观测可以得出,地膜覆盖对土壤的增温效应在夏季更加明显,对土壤的保水作用在秋冬季更加突出.相关性分析和主成分分析结果表明,土壤中氮素形态是决定农田N_2O排放最重要的因素,其中常规菜地N_2O排放主要受土壤中总氮含量的影响,而覆膜菜地N_2O的排放对土壤中无机态氮含量的变化更加敏感.     

Application of CGP-cross route process for microstructure refinement and mechanical properties improvement in steel sheets

A modified method of severe plastic deformation (SPD) entitled constrained groove pressing-cross route (CGP-CR) was introduced for imposing a high magnitude of equivalent strain of about 2.32 per pass on the sheet form samples. The major benefit of this improved route compared to previous common route was the more homogeneity of strain in the rolling (RD) and transverse (TD) directions of sheets. In this study, low carbon steel samples were used for examination of evolutions in microstructure and mechanical properties during SPD via CGP-CR process. Mechanical properties improvement were measured by tensile and macro hardness tests. The results indicate that CGP-CR process can effectively improve tensile strength; and also, yield stress and hardness of as-received low carbon steel samples were improved up to about 100% after two deformation passes. Also, high magnitude of inhomogeneity can be observed in hardness distribution through first pass of the process which diminishes in the subsequent passes. Microstructural evolutions during process were monitored by optical microscopy observations and X-ray diffraction analysis. The results demonstrate that initial ferritic microstructure with grain size of about 30 μm was refined to a 225 nm cell structure after two passes of CGP-CR process.     

V_2O_5-TiO_2离子存储电极薄膜的溶胶-凝胶法制备与性能研究

利用无机溶胶-凝胶技术制备了V2O5-（TiO2）x离子存储电极薄膜。采用X射线衍射（XRD）、原子力显微镜（AFM）、Raman光谱、循环伏安法（CV）和紫外-可见光透射光谱分别研究了复合薄膜的微观结构、化学计量、锂离子注入性能以及光学性能。结果表明复合薄膜具有V2O5的层状结构,其c轴方向的结构取向性有所降低;颗粒尺寸和表面粗糙度显著减小;同时TiO2的复合导致薄膜中V2O5的化学计量发生偏移,氧空位数量增多。当x=0.2时,薄膜具有相对较高的离子存储容量及循环稳定性,并且在离子注入/脱出状态均获得相当高的可见光透过性。     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

薄膜扩散梯度技术在重金属生物有效态监测中的应用

重金属生物有效性是评估重金属元素迁移性、生物可利用性和生态影响的关键参数。薄膜扩散梯度技术(DGT)是一种原位被动采样技术,因其具有原位富集性、形态选择性,可提供被监测物质在监测时间段内的平均浓度等优点,可作为生物对重金属摄取的模拟替代物对环境介质中重金属的生物可利用度进行预测,已被广泛应用于环境介质中重金属生物有效性的测定。研究主要介绍了DGT技术的原理、组成和特点,评述了其近年来在水体、土壤、沉积物中重金属生物有效态应用方面的新进展,提出了DGT技术未来要提高抗生物污染能力及寻找可与DGT技术联用的相关技术的观点。     

Leaching of styrene and other aromatic compounds in drinking water from PS bottles

Bottled water may not be safer, or healthier, than tap water. The present studies have proved that styrene and some other aromatic compounds leach continuously from polystyrene （PS） bottles used locally for packaging. Water sapmles in contact with PS were extracted by a preconcentration technique called as ＂purge and trap＂ and analysed by gas chromatograph-mass spectrometer （GC/MS）. Eleven aromatic compounds were identified in these studies. Maximum concentration of styrene in PS bottles was 29.5 μg/L. Apart from styrene, ethyl benzene, toluene and benzene were also quantified but their concentrations were much less than WHO guide line values. All other compounds were in traces. Quality of plastic and storage time were the major factor in leaching of styrene. Concentration of styrene was increased to 69.53 μg/L after one-year storage. In Styrofoam and PS cups studies, hot water was found to be contaminated with styrene and other aromatic compounds. It was observed that temperature played a major role in the leaching of styrene monomer from Styrofoam cups. Paper cups were found to be safe for hot drinks.     

昌吉州农田地膜污染现状及治理对策

通过对昌吉州农田地膜使用现状进行调查,阐述了地膜污染的危害,并提出了适期揭膜、残膜回收、推广新型生物膜等措施与防治对策。     

船舶塑料垃圾热解特性及动力学分析

利用热重分析(TGA)研究船舶塑料垃圾在不同升温速率和不同气氛下的热解特性,并得到了热解动力学参数。结果表明,船舶塑料垃圾的热解过程主要有3个阶段,比一般塑料热解复杂;随着升温速率增大,最大热解速率和最大热解速率温度等热解特性参数也增大,反应变得更剧烈;N2/CO2比为4∶1时,热解反应进行得最完全,固体残留率最少。动力学分析表明,采用3个连续一级反应模型能很好地拟合实验数据;不同的升温速率和气氛比对反应各阶段活化能均有不同程度的影响。     

QSPR prediction of chromatographic retention times of pesticides: Partition and fractal indices

The high‐performance liquid‐chromatographic retentions of red‐wine pesticide residues are modeled by structure–property relationships. The effect of different types of features is analyzed: geometric, lipophilic, etc. The properties are fractal dimensions, partition coefficient, etc., in linear and nonlinear correlation models. Biological plastic evolution is an evolutionary perspective conjugating the effect of acquired characters and relations that emerge among the principles of evolutionary indeterminacy, morphological determination and natural selection. It is applied to design the co‐ordination index that is used to characterize pesticide retentions. The parameters used to calculate the co‐ordination index are the molar formation enthalpy, molecular weight and surface area. The morphological and co‐ordination indices barely improve the correlations. The fractal dimension averaged for non?buried atoms, partition coefficient, etc. distinguishes the pesticide molecular structures. The structural and constituent classification is based on nonplanarity, and the number of cycles, and O, S, N and Cl atoms. Different behavior depends on the number of cycles.