巢湖沉积物有效磷的原位高分辨分析研究

将两种原位被动采样技术——高分辨平衡式间隙水(HR-Peeper)与氧化锆薄膜梯度扩散技术(Zr-oxide DGT)相结合,分别对巢湖西半湖7个点位溶解态反应性磷(cPW)和有效磷(cDGT)进行原位测定分析,cPW和cDGT在大部分沉积物剖面的分布相似或局部相似,说明不同深度沉积物固相有效磷组分对间隙水SRP的缓冲能力较接近.利用界面扩散通量和cDGT/cPW比值(R)表征沉积物磷的活性,从巢湖湖心向南淝河入湖口方向,界面以下6 mm的cPW、cDGT和扩散通量的变化基本一致,均呈递增趋势,表明沉积物磷的污染水平在增加;R值变化较小,说明沉积物界面处的缓冲能力差异不明显.     

先进冷喷涂技术的应用及展望

首先介绍了冷喷涂技术的原理及特点,在此基础上,重点讨论了冷喷涂技术在不同领域的应用。最后,结合我国冷喷涂技术的发展现状,提出了冷喷涂技术的发展方向,并指出发展先进冷喷涂技术符合我国先进技术的发展需求,有助于提高我国制造业的综合水平。     

Copper complexation by tannic acid in aqueous solution

The speciation of titrated copper in a dissolved tannic acid (TA) solution with an initial concentration of 4 mmol organic carbon (OC)/l was investigated in a nine-step titration experiment (Cu/OC molar ratio = 0.0030–0.0567). We differentiated between soluble and insoluble Cu species by 0.45 μm filtration. Measurements with a copper ion selective electrode (ISE) and diffusive gradients in thin films (DGT) were conducted to quantify unbound Cu(II) cations (‘free’ Cu) and labile soluble Cu complexes. For the DGT measurements, we used an APA hydrogel and a Chelex 100 chelating resin (Na form). Insoluble organic Cu complexes (>0.45 μm) was the dominant Cu species for Cu/OC = 0.0030–0.0567 with a maximum fraction of 0.96 of total Cu. At Cu/OC > 0.0100, Cu-catalysed degradation of aggregate structures resulted in a strong increase of free Cu and (labile) soluble Cu complexes with a maximum fraction of 0.28 and 0.32 of total Cu, respectively. Labile (i.e. DGT-detectable) soluble Cu complexes had a relatively high averaged diffusion coefficient (D) in the APA hydrogel (3.50 × 10⁻⁶– 5.58 × 10⁻⁶ cm² s⁻¹).     

城区大气和塑料大棚空气中酞酸酯的分析

本文报道了济南市大气飘尘和塑料蔬菜大棚空气中酞酸酯的污染情况，探讨了大气飘尘中酞酸酯随季节变化和昼夜更替的变化情况。     

塑料给水管材的选用分析

给水工程中如何根据不同的场合选用合适的塑料给水管材,本文从可靠性、使用寿命和工程造价等方面进行了阐述.     

Biodegradation of Injection Molded Starch-Poly (3-hydroxybutyrate-co-3-hydroxyvalerate) Blends in a Natural Compost Environment

Injection molded specimens were prepared by blending poly (hydroxybutyrate-co-valerate) (PHBV) with cornstarch. Blended formulations incorporated 30% or 50% starch in the presence or absence of poly-(ethylene oxide) (PEO), which enhances the adherence of starch granules to PHBV. These formulations were evaluated for their biodegradability in natural compost by measuring changes in physical and chemical properties over a period of 125 days. The degradation of plastic material, as evidenced by weight loss and deterioration in tensile properties, correlated with the amount of starch present in the blends (neat PHBV < 30% starch < 50% starch). Incorporation of PEO into starch-PHBV blends had little or no effect on the rate of weight loss. Starch in blends degraded faster than PHBV and it accelerated PHBV degradation. Also, PHBV did not retard starch degradation. After 125 days of exposure to compost, neat PHBV lost 7% of its weight (0.056% weight loss/day), while the PHBV component of a 50% starch blend lost 41% of its weight (0.328% weight loss/day). PHB and PHV moieties within the copolymer degraded at similar rates, regardless of the presence of starch, as determined by ¹H-NMR spectroscopy. GPC analyses revealed that, while the number average molecular weight (Mn) of PHBV in all exposed samples decreased, there was no significant difference in this decrease between neat PHBV as opposed to PHBV blended with starch. SEM showed homogeneously distributed starch granules embedded in a PHBV matrix, typical of a filler material. Starch granules were rapidly depleted during exposure to compost, increasing the surface area of the PHBV matrix.     

塑料玩具中邻苯二甲酸酯类环境激素检测方法研究

文章建立了一种对塑料玩具中5种邻苯二甲酸酯类物质同时分离和检测的高效液相色谱分析法。以shim-pack VP-ODS(4.6mm×150mm,5μm)为分离柱;以甲醇-水(体积比:90:10)为流动相,流速:1.0mL/min,检测波长:230nm。该方法所测得的5种邻苯二甲酸酯类物质在0.5～1000mg/L内具有良好的线性,相关系数r=0.9996,检出限达0.34～0.96μg/L,平均回收率在93.00%～105.23%。在对样品提取和纯化的基础上,对塑料玩具中邻苯二甲酸酯类物质进行了分析,结果令人满意。     

金属掺杂纳米TiO2薄膜的制备和抗菌性能研究

采用sol—gel法在载玻片表面制备了Ce,Cu,i．a,Ag掺杂的锐铁矿相TiO2薄膜,并通过SEM,XRD．FT—IR及UVVIS进行了表征,比较了薄膜的抗菌性能．UV—VIS研究表明,金属掺杂纳米TiO2薄膜在近紫外区吸光度有明显提高。抗菌实验表明掺Ag的TiO2薄膜抗菌效果最佳。     

喷淋工艺处理PVC塑料生产废气

采用喷淋工艺处理PVC塑料生产废气,将专利的吸收液与改型的喷淋塔相结合,在中试成功的基础上进行了实际工业化应用。应用结果表明:采用该工艺处理某PVC塑料生产企业的生产废气,吸收液在喷淋塔循环液中所占体积分数为15%时,废气中各污染物指标的去除率达85%以上,对于难处理的苯系物也能较好地去除;处理后废气中各污染物指标的含量满足GB 14554—1993《恶臭污染物排放标准》和DB 44/27—2001《大气污染物排放限值》的要求;该工艺装置运行费用较低,仅为电费和少量药剂费用,吸收液可循环使用,设备保养及维护简单,可满足市场需求。